SoleusAir GM-PAC-10E2 - Manual

Page 3 - LCDI POWER CORD AND PLUG; The TEST and RESET buttons should not be used as; RESET

LCDI POWER CORD AND PLUG This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination on the load side and a LCDI attachment...

Page 4 - PARTS INCLUDED; INCLUDE; SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION

INCLUDE PARTS INCLUDED Window Exhaust Adapter A Screw (7 ) Exhaust Hose Window Exhaust Adapter C Adjustable Window Slider (3) Hose clip(2) Rubber plug Battery (AAA.1.5V) INCLUDE Window Exhaust Adapter B SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION 1. Screwdriver(medium size Phillips) 2. Tape measur...

Page 5 - STRUCTURE

1, Control panel and display lamp 2, Remove control signal receiver window 3, Handel 4, Remote controller box 5, Air outlet 6, Vertical louvers 7, Horizontal louvers 8, Wheel 9, Air inlet 10, Grille 11, Air outlet 12, Air inlet 13,Power cord hook 14, Power cord 15, Window exhaust adapter A 16, Exhau...

Page 6 - SPECIFICATIONS; The cooling capacity is measured at an ambient temperature of DB; PACKAGE CONTENTS; Window Exhaust Adapter A; Model Number; Power cord hooks

6 SPECIFICATIONS x The cooling capacity is measured at an ambient temperature of DB 95 °F, WB 83 °F. x Noise level is measured at a distance of 3.28 ft away from the front of the unit, when the unit is in cooling mode. x Power consumption is measured when the fan runs at the highest speed setting. x...

Page 7 - Attach the hooks to the back of air conditioner with the screws.; Wind the power cord round the power cord hooks.; INSTALLATION

• Attach the hooks to the back of air conditioner with the screws. hoook screw • Wind the power cord round the power cord hooks. 7 INSTALLATION OF THE POWER CORD HOOK

Page 8 - PARTS & WINDOW KIT ASSEMBLY; PARTS; Extend both ends of the exhaust hose approximately 6 inches.

PARTS & WINDOW KIT ASSEMBLY PARTS EXHAUST HOSE & ADAPTERS ASSEMBLY & INSTALLATION INSTALLATION When the unit is operating as an air conditioner or dehumidifier, the window kit and exhaust hose must be installed. When the unit is operating in fan mode, the window kit and exhaust hose do n...

Page 9 - SINGLE HOSE WINDOW KIT INSTALLATION

9 SINGLE HOSE WINDOW KIT INSTALLATION When installing the exhaust hose, try and keep it as flat as possible. The less angles and bends in the hose, the better the unit will perform. If bending or an angle is necessary, use single 90 ° angles like the pictures above. Multiple bends will decrease perf...

Page 10 - CONTROL PABEL & DISPLAY; OPERATING INSTRUCTIONS; When the unit is running in Cool or F; Button; CONTROL PANEL DISPLAY & OPERATING INSTRUCTIONS; water tank. When water tank is filled. buzzer will sound 8; Press the button once to manually turn the uni; Each press of; hose and window kit must; Hold this hand grip to adjust the

CONTROL PABEL & DISPLAY When pressing key is valid, buzzer makes a sound, indicate dlamp indicates relevant state, syste mwill last for 2 seconds. OPERATING INSTRUCTIONS l. 3.MODE Button 4. Fan speed When the unit is running in Cool or F a n mode,press the Fan speed Button to select the fan spee...

Page 11 - For good receive, the distance between; Point the remote control; blocks the signal receiver window.; CAUTION

HOW TO USE THE REMO V E CONTROL For good receive, the distance between operator and the unit no more than 5 meters. Point the remote control towards the units signal receiver window a n d pr e s s th e d e s ir e d bu tto n . A beep will sound when the unit re- ceives the signal. blocks the signal r...

Page 12 - REMOTE CONTROL OPERATING INSTRUCTIONS

12 1) Power On and Off - Press the ON/OFF (POWER) button once to manually turn the unit on. Press the Power button once more to turn the unit off. When you manually power the unit on and off by pressing the ON/OFF button, the preset timer will be cancelled. 2) Mode Selection - Press the MODE Button ...

Page 14 - DRAINING COLLECTED WATER

1 4 When the temperature or humidity is too high, the air conditioner may not be able to evaporate all of the water as quickly as needed. All moisture that is unable to be evaporated is placed in a small bank up water tank in-side the unit. When this tank is completely full, an alarm will sound, the...

Page 15 - MAINTENANCE; and dry it thoroughly out of sunlight.; DISCLAIMER

MAINTENANCE Note: Make sure power is off and the power cord is not plugged into an electrical outlet prior to performing any maintenance on the unit. Clean or replace filter - If the air filter is blocked with a dust, the airflow volume may reduce. It is recommended to clean the filter once every tw...

Page 16 - SOLUTIONS; TROUBLESHOOTING; The Remote Control is not working

PROBLEM The Air Conditioner will not start POSSIBLE CAUSES The air conditioner is unplugged or not connected well. The fuse is blown/circuit breaker is tripped. Power Failure The current interrupter device is tripped. SOLUTIONS x Make sure the air conditioner plug is pushed completely into the out-l...

Page 17 - The LCD Display is showing “H8”

PROBLEM The LCD Display is showing “E5” POSSIBLE CAUSES Low Voltage Protection SOLUTIONS x Unplug for 10 minutes and then turn on the unit. If “E5” is still dis-played, contact customer service. TROUBLESHOOTING (CONT.) The LCD Display is showing “H8” The backup water tank is full x Drain the water t...

Page 18 - WARRANTY; THIS WARRANTY DOES NOT COVER:

WARRANTY One Year Limited Warranty Soleus International Inc. warrants the accompanying Soleus Air Powered by Gree Portable Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of origi...

SoleusAir GM-PAC-10E2 - Manual

Table of Contents:

Summary

Other SoleusAir Models