Page 2 - IMPORTANT SAFETY INSTRUCTIONS; PROTECTION FOR CHILDREN
2 IMPORTANT SAFETY INSTRUCTIONS WARNING: This powerful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following SAFETY instructions could result in serious injury or death to the operator or other persons. Th...
Page 3 - PREPARATION
3 IMPORTANT SAFETY INSTRUCTIONS PREPARATION (Continued From Previous Page) 7. Keep people and pets out of mowing area. Immediately STOP blades, STOP engine, and STOP machine if anyone enters the area. 8. Check shields, deflectors, switches, blade controls and other safety devices frequently for prop...
Page 4 - TABLE OF CONTENTS
4 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS .........................................................................2-3 TABLE OF CONTENTS ...................................................................................................... 4 SECTION 1 - FAMILIARIZATION .........................
Page 5 - Section 1 - FAMILIARIZATION; CONTROL PANEL
5 Section 1 - FAMILIARIZATION FIGURE 1.1 1.1 INTRODUCTION This manual has been prepared for the operator’s of the SNAPPER Rear Engine Rider. Its purpose, aside from recommending standard operating procedures and routine service requirements, is to promote SAFETY through the use of accepted operating...
Page 6 - Section 2 - OPERATING INSTRUCTIONS; OPERATOR’S SEAT ADJUSTMENT
6 Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check tires and add or release air as needed to bring pressure to 12 psi in front and 12 psi in rear tires. 2.1.2. Check guards, deflectors and covers...
Page 7 - WARNING
7 Section 2 - OPERATING INSTRUCTIONS 2.3 STARTING & OPERATION 2.3.1. ENGINE (ELECTRIC START) IMPORTANT: When the ignition key is turned to “START”, the engine will turn over, but will not start unless the Clutch/Brake pedal is pressed all the way down, the Blade Lever is in the “Off” position (S...
Page 11 - BRAKE; DO NOT park the machine on slopes.
11 Section 2 - OPERATING INSTRUCTIONS 2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE 2.4.4. PARK BRAKE 1. Engage park brake by pushing clutch/brake pedal “DOWN” and moving the park brake lever to the “ON” position. While holding the park brake lever “ON”, release clutch/brake pedal to set park brake. See...
Page 12 - Section 3 - MAINTENANCE
12 Section 3 - MAINTENANCE WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns,...
Page 13 - SYSTEM; TOP VIEW OF BELT ROUTING
13 Section 3 - MAINTENANCE WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns,...
Page 14 - Section 3 – MAINTENANCE; MOWER DECK LINKAGE – LUBRICATION
14 Section 3 – MAINTENANCE 3.2.8. LUBRICATION – GREASE FITTINGS The following components on the Rear Engine Rider are equipped with grease fittings and require periodic lubrication. Apply General Purpose grease (NLGI No.2) with a grease gun. 1. Front Wheel Bearings. Refer to Section “FRONT WHEEL BEA...
Page 16 - REMOVING FUEL TANK
16 Section 3 - MAINTENANCE 3.5 EVERY TWO YEARS In addition to regular maintenance, the following components of the Rear Engine Rider should be carefully inspected every two years for wear or damage. Replace worn or damaged parts with genuine SNAPPER replacement parts available from an authorized SNA...
Page 19 - Tighten lift quadrant mounting bolts securely.
19 Section 4 - ADJUSTMENTS & REPAIR WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid s...
Page 22 - BLADE DRIVE BELT REPLACEMENT
22 Section 4 - ADJUSTMENTS & REPAIR WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid s...
Page 24 - INSTALLATION
24 Section 4 - ADJUSTMENTS & REPAIR WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. Stop engine. Stop blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid s...
Page 25 - TESTING
25 Section 4 - ADJUSTMENTS & REPAIR WARNING The electrolyte (acid) produces a highly explosive gas. Keep all sparks, flame and fire away from area when charging battery or when handling electrolyte or battery. Electrolyte (acid) is a highly corrosive liquid. Wear eye protection. Wash affected ar...
Page 26 - Battery Condition Chart; State of Charge; SNAPPER REAR ENGINE RIDER ACCESSORIES; DESCRIPTION OF KIT
26 Section 4 - ADJUSTMENTS & REPAIR 4.6.6. BATTERY TESTING Battery Condition Chart State of Charge Syringe Hydrometer Digital Voltmeter Five Ball Hydrometer 100% Charged w/ Sulfate Stop 1.280 12.80v Five Balls Floating 100% Charged 1.265 12.60v Four Balls Floating 75% Charged 1.210 12.40v Three ...
Page 27 - TROUBLESHOOTING; (Trouble Shooting Continued on Next Page)
27 TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel to proper level. Start Using 2. Engine needs choking. 2. Move choke control to “CHOKE” position. Recoil Starter 3. Spark plug wire disconnected. 3. Place spark plug wire ...
Page 30 - YEAR LIMITED WARRANTY; DISCLAIMER OF WARRANTY
30 3 YEAR LIMITED WARRANTY For three (3) years from purchase date for the original purchaser's residential, non-commercial use, SNAPPER, through any authorized SNAPPER dealer will replace, free of charge (except for taxes where applicable), any part or parts found upon examination by the factory at ...
Page 31 - PRIMARY MAINTENANCE
Page 35 - SERVICE NOTES
35 SERVICE NOTES ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________________________________________ ______________________________________________...
Page 36 - Safety Instructions & Operator’s Manual for; IMPORTANT
36 Safety Instructions & Operator’s Manual for REAR ENGINE RIDING MOWER SERIES 18 IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and cr...