Smeg 129316- Manual

129316 • Appliance can either stand on its own or can be placed on top of a washing machine of the same dimensions - minimum width 517 mm, depth 476 mm. The surface for placing the dryer must be clean and fl at. Use supplied vacuum feet to prevent sliding of the appliance. Washing machine hardtop mu...

129316 1 Lid2 Evacuation tube A - Evacuation dryer • There are two openings for the evacuation of humid air. One of them should be closed with the supplied lid, while the other should be connected to the evacuation tube. The distance between the dryer and the moist air outlet (ventilation shaft, win...

129316 • Use the power cord to connect the dryer to the power supply via wall socket. • Rated voltage and other characteristics are indicated on the name plate, located under the door frame of the appliance. The wall socket should always be within reach. It has to be earthed according to the standin...

129316 - Open the dryer door by pushing the left-hand side of the door towards the appliance (make sure the drum is empty). - Sort the laundry according to the type of fabrics. Do the buttons and zippers, tie the strings and pull out the pockets. Very delicate laundry should be put in a special prot...

129316 - Insert the laundry into the drum (prior making sure that the drum is empty). - Close the dryer door. - Select drying time • By turning the drying time selector, set the preferred drying period, according to the type and quantity of laundry and washing machine spin rpm (see drying program ch...

129316 • Press the START /PAUSE button (D) - LED E is on, appliance starts to operate (after a 2 second pause). • 10 minutes prior the end of drying program the machine starts the cooling cycle (heater is off), which prevents excessive creasing. • At the end of the cooling program the appliance swit...

129316 • Water container is full (condenser appliance only) When the container is full, signal lamps (E) and (F) are fl ashing. The drying program is interrupted. When the container is emptied, press the START /PAUSE button (D) to reactivate the drying program. 14

129316 • After every drying clean the fi lter, located in the inner part of the door. • Lift the fi lter lid (Fig.). • Pull your fi ngers over the fi lter to remove fi bers and threads lining. Replace the fi lter cover. • If necessary, also clean the fi lter housing and door sealing. Cleaning of the...

129316 Strictly switch the appliance off prior cleaning (unplug the power cord from the wall socket, or turn the selector jog to the position “0”). • Clean the casing and drum interior with soft cloth and mild detergent. • Periodically clean (vacuum) the interior of air evacuation opening and evacua...

129316 Interferences from the ambient (for example electrical wiring) could induce signalization of different faults. In such cases:- switch the appliance off, and wait for a few seconds; - plug in the appliance and repeat the drying program. If the fault repeats, call authorized service shop. Warra...

129316 20 Unevenly dried laundry: • If the amount of laundry to be dried is not too big.• If there are only large pieces of laundry (large and small pieces should be dried together). • If different fabrics are dried together (group the laundry according to the type of fabrics). The machine signals e...

129316 Note: Indicated drying time corresponds to the laundry spun at indicated spin rpm. In case of higher or lower spin rpm the times are accordingly shorter or longer.Drying time is also prolonged in case of excessively large pieces of laundry. 21 Type of laundry Max. load in kg Level of dryness ...