Skylink ad-103 - Manual - manualsarea.com

Page 2 - Emergency Dialer; QUICK

– 2 – SKYLINK TECHNOLOGIES INC. Your Guide to the Emergency Dialer DIAL-ALERT MODEL: AD-103 TM The AD-103 Emergency Dialer contains all the above items. – 19 – DIAL-ALERT QUICK GUIDE [1] - D ials each number once, then redial if necessary , [2] - Finish dialing first phone number then begins second ...

Page 3 - TABLE OF CONTENTS; To replace the dialer backup battery:; BATTERY MAINTENANCE

– 3 – TABLE OF CONTENTS PACKAGE CONTENTS............................................................................................4 OVERVIEW.....................................................................................................5 INSTALLATION..............................................

Page 4 - Pack of screws and anchors (for; PACKAGE CONTENTS; and 2 is Dial Sequence 2.; Universal Dial Tone; the pager pause duration.; ADVANCED PROGRAMMING

All materials required for installation are included with this package 1 Dial-Alert (AD-103) 1 Telephone Line1 antenna (installed)1 AC adapter1 9 volt alkaline battery 1 Pack of screws and anchors (for Dial-Alert ) One templateDouble sided tapeUser's instructionsWarranty CardQuick Guide – 4 – PACKAG...

Page 5 - Erase Programmed Control Panel; To erase all the control panels, follow the instructions below.; Dial Sequence

– 5 – OVERVIEW The AD-103 Dial-Alert can call multiple telephone numbers and sends a personalized pre-recorded message. The person receives the emergencymessage can confirm receipt of that message by pressing the "#" key ontheir telephone. A pre-recorded message will be played notifying the ...

Page 6 - INSTALLATION; How to use the template:; Changing Password; to set the calling time to 90 seconds.

– 6 – INSTALLATION The Dial-Alert is installed using the screws provided. We have also included double sided tape, to use for temporary installation while you are positioningthe dialer. Once the dialer is positioned correctly, install it permanently withscrews. We have also included wall anchors and...

Page 7 - The adapter cord must be inserted; OPERATIONS; RECEIVING A PHONE CALL

– 7 – INSTALLATION 3. Thread the AC adapter cord through the top hole in the back of the unit and plug it intothe AC connector on the circuit board asshown. The adapter cord must be inserted through the back of the unit before it isattached to the wall. 4. Insert the 9 volt battery and rotate the an...

Page 8 - TESTING

– 8 – INSTALLATION Speaker On/Off SwitchThe speaker must be on during pro-gramming and recording the voicemessage in order to use the playbackfeature. For security purposes, thespeaker may be turned off after pro-gramming to allow for silent dialingwhen the dialer is activated.The On/Off switch for ...

Page 9 - LIGHTS AND SOUNDS; LIGHTS; STANDARD PROGRAMMING; PROGRAM A PHONE NUMBER

– 9 – LIGHTS AND SOUNDS Below is an explanation of the lights and sounds of the Dial-Alert LIGHTS ACPWR light on dialer is being powered by AC adapter. ACPWR light off dialer is not receiving any AC power. LOBATT. light off backup battery is connected and working. LOBATT. light on backup battery is ...

Page 10 - RECORD A VOICE MESSAGE; voice message playback mode.; ] button. You now can start to record the

– 10 – STANDARD PROGRAMMING There are a few programming steps you must perform before the dialer canoperate. Please follow the instructions below to program these fields, including: - Record voice messages- Phone numbers you wish to dial during emergency (up to 9 phone numbers)- Program the panic bu...

Skylink ad-103 - Manual

Table of Contents:

Summary

Other Skylink Models