Simplicity Series 1 - Manual

Page 2 - preliminaries

2 1 preliminaries Congratulations! You have just purchased one of the finest pieces of outdoor power equipment on the market today. If properly cared for,your new blower will provide years of dependable service. Please read and follow this instruction manual carefully in orderto get the most out of ...

Page 3 - Do; safety rules regarding outdoor power equipment

TRAINING • Read, understand, and follow all instructions in the manu-al and on the unit before starting. If the operator(s) ormechanic(s) can not read English it is the owner’s responsi-bility to explain this material to them.• Become familiar with the safe operation of the equipment,operator contro...

Page 5 - unit assembly; FRONT WHEEL ASSEMBLY; HANDLE ASSEMBLY

3 unit assembly Note: Please refer to Parts List for correct part identification and placement. FRONT WHEEL ASSEMBLY • Attach left and right caster brackets to caster wheelusing 3/8-18 x 2-1/4 bolt and lock nut. Insert bolt throughhole in bracket. Place caster wheel onto bolt. Placeother caster brac...

Page 6 - unit operation; STARTING THE ENGINE; BEFORE STARTING ENGINE:; CHOKED

6 4 unit operation STARTING THE ENGINE IMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no way meant to replaceor supercede engine manufacturer’s operating instructions. In order to obtain optimum performance from your engine, referto your engine manual....

Page 7 - BLOWER OPERATION

7 4 unit operation (cont.) TO SHUT ENGINE DOWN: • Move engine speed control to slow “Turtle” position. • Allow engine to idle for 2-3 minutes before shutting down. • Move engine speed control to “STOP” position. Turn fuel valve to closed position. IMPORTANT NOTE: If you experience problems with your...

Page 8 - TO CHANGE AIR DISCHARGE DIRECTION:; SIDE

8 4 unit operation (cont.) GENERAL RULES TO OBSERVE BEFORE AND DURING OPERATION: • Inspect your unit before each and every use. Check for worn, bent or broken components, loose fasteners, low or flattires, etc., and repair or replace prior to operation. DO NOT OPERATE A MACHINE THAT IS WORN OR DAMAG...

Page 9 - maintenance

9 5 maintenance GENERAL: • Follow implicitly the engine manufacturer’s recommendations for maintenance. • Always keep your machine clean – especially the engine. Check all adjustments periodically. Also, periodically checkthat all fasteners are secure. • Never make any adjustments to the unit until ...

Page 11 - illustrated parts list

Page 13 - decal identification

13 6 illustrated parts list (cont.) Item Part No. Qty Description 42 90391 4 WASHER, 5/16” Internal Tooth Lock 43 3071776 4 KNOB, Folding Handle 44 46465 1 GUIDE, Rope 45 90372 1 NUT, 1/4-20 Hex Center Lock, GR5 or B 46 3071800 1 THROTTLE CONTROL, B&S 47 90505 1 SCREW, 1/4-20 x 2” Hex Head Cap, ...

Page 14 - EUROPEAN PERFORMANCE:

14 7 decal identification (cont.) 73462 - WARNING COMBO - LOCATEDON TOP OF BLOWER HOUSING EUROPEAN PERFORMANCE: Maximum level of vibration measuredat the operator’s hand 16 m/sec2 29490 - MODEL YEAR 2004 - LOCATEDON REAR OF BLOWER HOUSING 75760 - SNAPPER LOGO - LOCATED ONINTAKE BAFFLE (ON APPLICABLE...

Page 15 - notes

Page 16 - European

16 ASSEMBLY INSTRUCTIONS OPERATOR’S MANUAL PARTS LIST European Walk-Behind Leaf Blower Series 1 Manual No. 7078091 (I.R. - 09/14/04) McDonough, GA 30253 USA

Simplicity Series 1 - Manual

Table of Contents:

Summary

Other Simplicity Models