Shure 27C687 - Manual
Shure 27C687 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Model 522 User Guide
27C687 (Rev. 6)
Printed in U.S.A.
©2012 Shure Incorporated
MODEL 522
BASE-STATION MICROPHONE
The Model 522 is a dynamic base-station microphone for radio
communications, paging, and dispatching systems. Its cardioid
(unidirectional) pickup pattern suppresses unwanted background noise
from nearby dispatchers, ventilating equipment, or office machines.
It also can reduce feedback in public address paging applications.
Features
•
Dual impedance (19 to 300 ohms or High)
•
lmpedance change switch for convenient change-over
•
Finger-tip control bar (locking or non-locking action) to actuate
microphone circuit and an external relay or control circuit
•
Long-life switch to satisfy rigorous requirements of
communications and paging systems
•
Sturdy, high impact ARMO-DUR
®
‚ base and microphone case
•
Adjustable microphone height
•
Dependable under most operating conditions
PRESS-TO-TALK SWITCH OPERATION
Press and hold the bar switch to talk. To lock the switch, press and pull it
forward. To unlock the switch, move the bar back and release.
IMPEDANCE SELECTION
Use the switch located under the microphone base, near the cable entry,
to select high ("HI") or low ("LO") impedance.
Use the low-impedance position for long cable lengths under conditions
of severe hum disturbance. Use Shure Model A95 Series Line Matching
Transformers when using a low-impedance microphone line with a high-
impedance amplifier input.
LOGIC CONNECTIONS
The RED and BLACK leads may be used to control an external relay or
switching circuit.
AUDIO CONNECTIONS
Unbalanced high-impedance operation:
Set the impedance switch to the “HI” position (as shipped). Connect the
GREEN cable lead and the shield to the amplifier chassis ground. The
WHITE cable lead is the “hot” conductor.
Balanced-line low-impedance operation:
Set the impedance switch to the “LO” position. Connect the shield to the
amplifier chassis ground. The WHITE and GREEN cable leads are the
“hot” conductors.
Table 1. Cable-to-Connector Wiring
INPUT TYPE
WIRE
COLOR
FUNCTION
XLR
CONNECTOR
1/4 IN.
PHONE
PLUG
UNBALANCED
WHITE
AUDIO
PIN 2
TIP
GREEN
AUDIO
GROUND
PIN 3
SLEEVE
SHIELD
CHASSIS
GROUND
PIN 1
SLEEVE
BALANCED
WHITE
AUDIO +
PIN 2
TIP
GREEN
AUDIO –
PIN 3
RING
SHIELD
CHASSIS
GROUND
PIN 1
SLEEVE
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
