Sharp FU-W43E - Manual - manualsarea.com

Page 2 - Please read before operating your new Air Purifier; NOTE

Please read before operating your new Air Purifier The air purifier draws in room air from its air intake, lets the air pass through an Active Carbon Filter (deodorization filter) and a HEPA Filter (dust collec- tion filter) inside of the unit, then discharges the air from its air outlet. The air pu...

Page 3 - FEATURES; ENGLISH; CONTENTS

ENGLISH FEATURES E-1 ENGLISH Thank you for purchasing the SHARP Air Puri- fier. Please read this manual carefully for the correct usage information. Before using this product, be sure to read the section: “Important Safety Instructions.” After reading this manual, retain it in a conven- ient locatio...

Page 4 - IMPORTANT SAFETY INSTRUCTIONS; WARNING

E-2 IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should be followed, including the following: WARNING - To reduce the risk of electrical shock, fire or injury to persons: • Read all instructions before using the unit.• Use only a 220-240 volt outlet. • Do ...

Page 5 - CAUTIONS CONCERNING OPERATION; INSTALLATION GUIDELINES; FILTER GUIDELINES

ENGLISH E-3 CAUTIONS CONCERNING OPERATION • Do not block the intake and/or air outlet. • Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam. • Do not lay the unit down when using. • Always hold the handle on the back of the unit when mo...

Page 6 - PART NAMES; MAIN UNIT DISPLAY

Odour Sensor Date Label Main Unit HEPA Filter Filter Support Front Panel Washable Active Carbon Filter E-4 PART NAMES MAIN UNIT DISPLAY ILLUSTRATIVE DIAGRAM Fan Speed Indicator Lights Filter Reset Indicator Light Plasmacluster ON/OFF Indicator Light Plasmacluster Indicator Light(Blue) CLEAN - SIGN L...

Page 7 - INCLUDED; BACK

ENGLISH E-5 INCLUDED • Operation manual BACK The colour changes according to the air condition. ABOUT THE CLEAN-SIGN • The condition of the CLEAN-SIGN depends on the room air condition detect- ed by the Dust and Odour Sensors when the plug is inserted into the wall outlet. • It is possible to have a...

Page 8 - PREPARATION; Remove the filters; Remove the Front Panel.; FILTER INSTALLATION; Remove the Filter Support.; Remove the Washabe Active Carbon Filter (Black) and

PREPARATION To maintain the quality of the filters, they are installed in the main unit and packed in plastic bags. Be sure to remove the filters from the plastic bags before using the unit. Remove the filters Remove the Front Panel. E-6 Be sure to remove the power plug from the wall outlet. FILTER ...

Page 9 - nstall the filters; Place the HEPA Filter into the

ENGLISH Tab (blue) E-7 2 1 3 4 5 2 I nstall the filters Place the HEPA Filter into the main unit. Do not install the filter backwards or the unit will not operate properly. Insert the Filter Support’s 2 bottom tabs (left and right) into the small holes in the unit, and slide the Active Carbon Filter...

Page 10 - OPERATION; MAIN UNIT OPERATION; FAN SPEED Button; AUTO operation; ION SHOWER Mode Button

OPERATION MAIN UNIT OPERATION E-8 Power ON/OFF Button • Used to start operation (short beep) and stop operation (long beep) • P l a s m a c l u s t e r I n d i c a t o r L i g h t a n d F a n Speed Indicator Light turn on/off. • Unless the power cord is unplugged, the op- eration will start in the p...

Page 11 - Plasmacluster ON/OFF Button; ADJUSTMENT OF SENSOR DETECTION SENSITIVITY; With the unit OFF, press the Fan Speed Button for 3 seconds.

ENGLISH E-9 Plasmacluster ON/OFF Button Press the Plasmacluster ON/OFF Button to turn Plasmacluster Ion Mode ON and OFF. When Plasmacluster is ON, both the Indicator Light and Plasmaclus- ter Indicator will turn on. LIGHTS CONTROL Button U s e w h e n t h e t h e P l a s m a c l u s t e r Indicator ...

Page 12 - Keep the unit away from water; CARE AND MAINTENANCE; MAIN UNIT; SENSOR FILTER CARE; FILTER RESET INDICATOR LIGHT; FILTER; Detach the sensor filter and tap

To prevent dirt or stains on the main unit, clean as often as necessary. If stains are allowed to remain, they may become hard to clean. Wipe with a dry, soft cloth For stubborn stains or dirt, use a soft cloth dampened with warm water. Do not use volatile fluids Benzene, paint thinner, polishing po...

Page 13 - WASHABLE ACTIVE CARBON FILTER CARE; Care Cycle; Drip dry filter to remove excess water.; CAUTION

ENGLISH E-11 WASHABLE ACTIVE CARBON FILTER CARE HAND WASH ONLY! DO NOT TUMBLE DRY! Care Cycle 2 months Washable Active Carbon Filter 2 Drip dry filter to remove excess water. 1 Rinse dirt from the WASHABLE ACTIVE CARBON FILTER under lukewarm water. Remove dust on the washable active carbon filter be...

Page 14 - FILTER REPLACEMENT GUIDELINES; HEPA Filter / Washable Active Carbon Filter; REPLACING THE FILTERS

E-12 CARE AND MAINTENANCE FILTER REPLACEMENT GUIDELINES The replacement period differs depending on the room environment, the usage hours and location of the Air Purifier. If dust or odour persist, replace the filters. (Refer to “Please read before operating your new Air Purifier”) HEPA Filter / Was...

Page 15 - SYMPTOM; TROUBLESHOOTING; ERROR DISPLAY; LAMP INDICATION

ENGLISH The CLEAN-SIGN Light lights green even when the air is im- pure. E-13 Before calling for repair, please review the list below, since the problem may not be a unit malfunction. SYMPTOM REMEDY (not a malfunction) Odours and smoke are not removed. • Clean or replace the filters if they appear t...

Page 16 - SPECIFICATIONS; Standby Power

E-14 SPECIFICATIONS ModelPower supplyFan Speed AdjustmentRated PowerFan Speed Recommended Room Size Cord LengthDimensionsWeight Fan Speed Operation ~40m 2 *2 ~20m 2 *3 2.0m 338mm(W)x207mm(D)x620mm(H) 6.1kg MAX 42W 318m 3 /hour MED 15W 204m 3 /hour SILENT 3.5W(3.2W) *1 36m 3 /hour *1 FU-W53E 220-240V...

Page 18 - Memo

Page 20 - SHARP CORPORATION

TINS-A303KKRZ CN Printed in China 08L OSAKA, JAPAN SHARP CORPORATION W53E.eng.indd 20 08.11.13 3:11:35 PM

Sharp FU-W43E - Manual

Table of Contents:

Summary

Other Sharp Models