Page 3 - ENGLISH; CONTENTS; Declaration of Conformity; SHARP ROOM AIR CONDITIONER CV-P09FX
ENGLISH ENGLISH This manual explains the proper use of your new air conditioner. Please read this manualcarefully before using the product. This manual should be kept in a safe place for handyreference. CONTENTS • FOR CUSTOMER ASSISTANCE (U.S.) ................ E-2 • CONSUMER LIMITED WARRANTY (U.S.)...
Page 4 - FOR CUSTOMER ASSISTANCE; TO ACCESS THE INTERNET:
E-2 FOR CUSTOMER ASSISTANCE (the United States) To aid in answering questions if you call for service or for reporting loss or theft, pleaserecord below the model and serial number located on the back side of the unit. MODEL NUMBER SERIAL NUMBER DATE OF PURCHASE Dealer Name Address City State Zip Te...
Page 5 - CONSUMER LIMITED WARRANTY; SHARP ELECTRONICS CORPORATION
ENGLISH E-3 CONSUMER LIMITED WARRANTY CONSUMER LIMITED WARRANTY FOR THE U.S. USERS SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the“Product”), when shipped in its original container, will be free from defective workmanship and materials, and a...
Page 7 - LIMITED WARRANTY; Consumer Electronics Products; Congratulations on your purchase!
ENGLISH E-5 LIMITED WARRANTY Consumer Electronics Products Congratulations on your purchase! Sharp Electronics of Canada Ltd. (hereinafter called “Sharp”) gives the following express warranty to the first consumerpurchaser for this Sharp brand product, when shipped in its original container and sold...
Page 8 - PRECAUTIONS; Points to keep in mind when using your air conditioner.; WARNINGS FOR USE; NOTE
PRECAUTIONS Points to keep in mind when using your air conditioner. WARNINGS FOR USE • Install the air conditioner in accordance with the installation instructions in the latter section of this manual. • Do not modify any part of this product. • Do not insert anything into any part of the unit. • En...
Page 9 - WARNING ABOUT GROUNDING; USAGE CAUTIONS
ENGLISH E-7 WARNING ABOUT GROUNDING • Improper use of the grounding plug can re- sult in the risk of electric shock. This appliance must be grounded. In the eventof an electrical short circuit, grounding reducesthe risk of an electric shock by providing a lessresistant conduit for the electric curre...
Page 10 - NOTES ON OPERATION; Dehumidification; ENERGY EFFICIENCY TIPS
PRECAUTIONS NOTES ON OPERATION • Allow 3 minutes for the compressor to restart cooling. If you turn the air conditioner off and immediately restart it, allow three minutes for thecompressor to restart cooling. There is an electronic device in the unit that keeps thecompressor turned off for three mi...
Page 11 - LOCATION; SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION
ENGLISH LOCATION • The air conditioner should be placed on a firm founda- tion to minimize noise and vibration. For safe and se-cure positioning, place the unit on a smooth, level floorstrong enough to support the unit. • The unit has casters to aid placement, but it should only be rolled on smooth,...
Page 12 - PART NAMES; REAR VIEW; FRONT VIEW
PART NAMES 1 Air Outlet 2 Vertical louvers 3 Horizontal louvers 4 PLASMACLUSTER Lamp (blue) 5 Remote control signal receiverwindow 6 AUX. Button 7 OPERATION Lamp (red) 8 TIMER Lamp (orange) 9 MEGA COOL Lamp (green) 0 Air inlet REAR VIEW NOTE: Actual unit might vary slightly from above illustration. ...
Page 13 - REMOTE CONTROL
ENGLISH REMOTE CONTROL 1 Transmitter 2 Display 3 POWER Button 4 LIGHTS Button 5 TEMPERATURE Button 6 PLASMACLUSTER Button 7 1 hr OFF Button 8 MODE Button 9 ON TIMER Button 0 FAN Button q OFF TIMER Button w CANCEL Button e LOUVERS Button r RESET Button t MEGA COOL Button E-11 y MODE SYMBOLS : COOL : ...
Page 14 - INSTALL WINDOW PANEL; Installation in a double-hung sash window
INSTALL WINDOW PANEL Hole Projection Insect guardnet Rain guard "A" Window panel Projection "A" Window panel E-12 Adjustment panel Exhaust cover Window panel Foam seal A(adhesive type) Installation in a double-hung sash window (See page 14 for installation in a sliding sash window. )...
Page 15 - Attach a bracket with the screw.
ENGLISH Adjustment panel Extension panel Foam seal E-13 If the inner width of the window isbetween 24" (609mm) and 36.8"(934mm) inclusive. (1) Open the window sash and place the window panel on the window stool. (2) Slide the adjustment panel to fit the window frame width. (3) Secure the win...
Page 16 - Installation in a sliding sash window; Connect the rain guards to the insect
INSTALL WINDOW PANEL Installation in a sliding sash window (See page 12 for installation in a double-hung window.) Hole Projection Insect guard net Rain guard "A" Window panel Projection "A" Windowpanel E-14 Adjustment panel Exhaust cover Window panel 1 Connect the rain guards to the...
Page 18 - Installation of the exhaust hose; Attach the window exhaust adapter to; Attach the exhaust hose adapter to the; Slide and open the exhaust cover on; Unacceptable; INSTALLATION AND REMOVAL OF EXHAUST HOSE
Exhaust hose Windowexhaustadapter Projection Extend Hole "TOP" E-16 The exhaust hose must be installed or removed in accordance with the usage mode. MODE EXHAUST HOSE COOL, FAN, VENTILATION, DEHUMIDIFICATION with no container Install DEHUMIDIFICATION with container(minimum capacity 3 gallo...
Page 19 - Removal of the exhaust hose; Remove the window exhaust adapter.
ENGLISH ndow haust apter "PUSH" Projection E-17 Removal of the exhaust hose 1 Remove the window exhaust adapter. Pull out and remove the window exhaustadapter by pushing down two “PUSH”markings, and slide and close the exhaustcover in the window panel. 2 Remove the exhaust hose adapter fromt...
Page 20 - LOADING BATTERIES; POWER PLUG CHECK
1 Remove the battery cover at the back of the remote control. 2 Insert batteries into the compart- ment, making sure the ± ± ± ± ± and — — — — — p o l a r i t i e s a r e c o r r e c t l y aligned. • Lines will appear on the display when batteries are properly in-stalled. 3 Reattach the battery cove...
Page 21 - CAUTION; HOW TO USE THE REMOTE CONTROL
ENGLISH E-19 CAUTION • Do not expose the signal receiver window to direct sunlight. This may adversely affect its operation. If necessary, close the curtains to block out the sunlight. • Use of a fluorescent lamp in the same room may interfere with transmission of the signal. • The unit may be affec...
Page 22 - COOL MODE; TO TURN OFF; Press the POWER button again.
1 3 COOL MODE Drainage nozzle Stopcock E-20 Install the exhaust hose (See Page16), turnthe drainage nozzle to the CLOSE position,and check the drainage nozzle is coveredwith the stopcock. 1 Press the MODE button to select COOLmode. COOL DEHUM FAN VENT 2 Press the POWER button to start op-eration. • ...
Page 23 - DEHUMIDIFICATION MODE; Dehumidification with no container; Dehumidification with container
ENGLISH DEHUMIDIFICATION MODE 1 Remove the exhaust hose (See Page 17) 2 Turn the drainage nozzle to the OPEN position. 3 Pull the stopcock out from the drainage nozzle. • When the stopcock is removed, a small amount of water may be discharged from the drainage nozzle. • Always perform this procedure...
Page 25 - TO CHANGE AIR FLOW DIRECTION; UP / DOWN AIR FLOW DIRECTION; LEFT / RIGHT AIR FLOW DIRECTION
ENGLISH TO CHANGE AIR FLOW DIRECTION UP / DOWN AIR FLOW DIRECTION NOTE • During VENTILATION mode, UP/DOWN air flow direction cannot be changed. Hold the vertical louver as shown in the dia-gram and adjust the air flow direction. 1 Press the LOUVERS button on the re-mote control. • The horizontal lou...
Page 26 - TO CANCEL; Press the PLASMACLUSTER button again.; PLASMACLUSTER OPERATION
1 Press the PLASMACLUSTER button duringoperation. • The remote control will display “ ”. • The blue PLASMACLUSTER lamp on the unit will light. TO CANCEL Press the PLASMACLUSTER button again. • The PLASMACLUSTER lamp on the unit will turn off. NOTES: • Use of the PLASMACLUSTER function will be memo- ...
Page 27 - Press the MEGA COOL button again.; MEGA COOL OPERATION; Press the 1hr OFF button.; Press the CANCEL button.
ENGLISH 1 Press the MEGA COOL button during coolingmode. • The remote control will display " " . • The temperature display will go off.• The green MEGA COOL lamp on the unit will light. TO CANCEL Press the MEGA COOL button again. • MEGA COOL operation is also cancelled when the mode is chang...
Page 28 - NOTES ON TIMER SETTING AND OPERATION; TIMER OPERATION; OFF TIMER; TO CANCEL TIMER
0.5h 1.0h 1.5h 10h 11h 12h E-26 NOTES ON TIMER SETTING AND OPERATION • The latest time setting will be memorized and will appear on the remote control display the next time you set the OFF TIMER or ON TIMER. • The OFF TIMER and ON TIMER can not be set together. Only the most recent TIMER setting wil...
Page 29 - ON TIMER; Press the ON TIMER button.
ENGLISH E-27 1 ON TIMER Display shown when you setthe unit to turn on 6.5 hourslater. The unit will turn on automatically according to your setting.Timer duration can be set from a minimum of half an hour (30 minutes) to amaximum of 12 hours.Up to 9.5 hours, you can set in half-hour (30-minute) incr...
Page 30 - Use this mode when the remote control is not available.
AUXILIARY MODE AUXILIARY MODE 1 E-28 Use this mode when the remote control is not available. 1 Press the AUX. button on the unit. • The red OPERATION lamp on the unit will light and the unit will start operating in COOLmode. • The fan speed is set to AUTO.• The temperature setting is automatically s...
Page 31 - DRAINAGE
ENGLISH DRAINAGE Prepare for drainage and drain out water within the unit in the following cases. If the unit stops operating and the TIMER, OPERATION and MEGA COOL lamps areblinking. (This indicates that the water tank inside the unit is full.) 1 Make sure to turn the unit off. 2 Turn the drainage ...
Page 32 - CLEANING THE UNIT AND THE REMOTE CONTROL; MAINTENANCE; CLEANING THE INSECT GUARD NET; CLEANING THE FILTERS; REMOVE THE FILTERS; CLEAN THE FILTERS; REINSTALL THE FILTERS; MAINTENANCE AFTER AIR CONDITIONER SEASON
CLEANING THE UNIT AND THE REMOTE CONTROL Wipe them with a soft, dry cloth or with a cloth moistened with a mild soap. Carefully removeany residue by wiping with a damp cloth and dry completely.Avoid splashing water onto the unit. Water can dangerously damage the electrical insulation.Never use harsh...
Page 33 - BEFORE CALLING FOR SERVICE
ENGLISH BEFORE CALLING FOR SERVICE If the unit appears to be malfunctioning, check the following points before calling fora service. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose?• Has the fuse blown or is the circuit breaker tripped?• Did you restart the unit...
