Sharp AF-R120CX - Manual - manualsarea.com

Page 2 - FOR YOUR PROTECTION

2 To aid in answering questions if you call for service or for reporting loss or theft, please recordbelow the model and serial number located on the right side of the unit. DATE OF PURCHASE Dealer Name Address City State Zip Telephone FOR YOUR PROTECTION TO PHONE: Dial 1-800-BE-SHARP (237-4277) for...

Page 3 - SHARP ELECTRONICS CORPORATION

3 SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"),when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option,either repair the defect or replace the...

Page 4 - INSTALLATION INSTRUCTIONS; CHECK WINDOW AREA

4 INSTALLATION INSTRUCTIONS Before beginning installation, read these instructions carefully.Use the enclosed MOUNTING KIT for proper installation. The mounting kit is designed for wooden sill double or single hung sash-type windows. Minimum opening(Without mounting kit) Mounting kit fully closed Mo...

Page 5 - WARNING; INSTALLATION

5 7 6 5 4 3 2 1 ITEMS PACKED WITH THIS UNIT No. Accessories Q'ty Right closure assembly Left closure assembly Window sash foam seal 1 1 1 SUGGESTED TOOLS 1. Screw driver (medium size Phillips)2. Tape measure or ruler3. Knife or scissors INSTALLATION INSTRUCTIONS 13 Screws(L=1", 25.4mm) Bottom ga...

Page 8 - PRECAUTIONS; CAUTION FOR USE

8 PRECAUTIONS 3-Pronged receptacle 3-Pronged plug Grounding prong Groundedreceptacle box Groundingadapter Groundedreceptacle box Screw Tab for grounding screw Groundingwire IMPORTANT: Points to keep in mind when using your air conditioner. • Install the air conditioner by following the installation ...

Page 9 - NOTES ON OPERATION

9 PRECAUTIONS • Allow 3 minutes for the compressor to restart cooling. If you turn the air conditioner off and immediately restart it, allow three minutes for the compressor torestart cooling. There is an electronic device in the unit that keeps the compressor off three minutes forprotection. • If a...

Page 10 - PARTS NAMES; UNIT; OPERATION INSTRUCTIONS

10 HIGH COOL MED COOL LOW COOL FAN ONLY SELECTOR ENERGY SAVER POWER ON/OFF TEMP F hr TIMER ON/OFF 1 2 3 4 5 6 7 8 9 10 11 8 12 1 2 3 4 5 6 7 9 10 11 2 1 SELECTOR indicatorReceiver window for remote controlsignalDisplaySELECTOR padTIMER ON/OFF padTIMER indicator PARTS NAMES UNIT CONTROL PANEL TEMPERA...

Page 11 - COOLING OPERATION; During cooling operation; HOW TO OPERATE

11 F hr POWER ON/OFF POWER ON/OFF F hr TEMP OPERATION INSTRUCTIONS --- Lower temp. --- Raise temp. COOLING OPERATION Display / Indicator T o u c h P O W E R O N / O F Fpad. To turn off the unit, touchPOWER ON/OFF pad again . • POWER indicator and SELECTOR indicator (HIGH COOL) will light. • POWER in...

Page 12 - NOTES ON FAN SPEED; FAN ONLY OPERATION; During operation

12 LOW COOL MED COOL HIGH COOL SELECTOR SELECTOR TO CHANGE FAN SPEED Procedure • SELECTOR indicator will light in order as you touch. NOTES ON FAN SPEED Display / Indicator Pad Fan operates at medium speed; cooling power at medium. FAN ONLY OPERATION Cooling for sleeping comfort with low fan speed. ...

Page 13 - ENERGY SAVER; Procedure; Display / Indicator; EXHAUST

13 CLOSED OPEN EXHAUST Lever ENERGY SAVER ENERGY SAVER HOW TO OPERATE ENERGY SAVER TO CHANGE AIR FLOW DIRECTION During normal operation, the thermostat automatically controls cooling and the fan runscontinuously. When the ENERGY SAVER is selected, the thermostat automaticallycontrols cooling and the...

Page 14 - TIMER; ON TIMER OPERATION; Pad

14 0.5h 1.0h 1.5h 10h Preset(0.5h) Previous setting 11h 12h CL(cancel) F hr TIMER ON/OFF HOW TO OPERATE ON TIMER OPERATION • After setting the ON TIMER, change the temperature and fan speed settings as shown on pages 11 and 12. When the temperature is set in the timer mode, the temperature will show...

Page 15 - OFF TIMER OPERATION

15 0.5h 1.0h 1.5h 10h Preset(0.5h) Previous setting 11h 12h CL(cancel) F hr TIMER ON/OFF HOW TO OPERATE OFF TIMER OPERATION • This unit has a built-in timer that can be programmed to shut the unit off up to 12 hoursin advance. • You can set the timer to stop in increments of 30 minutes (0.5 hours) u...

Page 16 - USING THE REMOTE CONTROL; INSTALLING BATTERIES; HOW TO USE THE REMOTE CONTROL

16 Insert the batteries in the compartment,making sure the and polaritiesare properly aligned. HOW TO OPERATE USING THE REMOTE CONTROL INSTALLING BATTERIES Use two size-AAA (R03) batteries. Battery compart-ment cover NOTES: • The battery life is approximately one year with normal use.• When you repl...

Page 17 - OPERATING WITH THE REMOTE CONTROL

17 HIGH COOL MED COOL LOW COOL FAN ONLY • The time setting will change as you push the button. The display will change as follows; • The last OFF time setting is memorized by the unit and will appear on the display when the button is pushed. • The timer will be set, 5 seconds after the SET TIMER / O...

Page 18 - CLEANING THE FILTER; REMOVE THE FILTER; CLEANING OF THE FRONT PANEL AND CABINET

18 ;;; ; ; ; ; ;;; ; ; ;; ; ; ;;; ; ; ; ;; ;;;;; ; ;; ;; ;;;; ;;; ;; ;;; ; ;; ; ; ; ;; ; ;; ;;; ; ;; ; ; ENERGY EFFICIENCY TIPS CLEANING AND MAINTENANCE CLEANING THE FILTER If the filter is clogged with dust, the amount of air flow willbe reduced, resulting in poor cooling performance. Thefilter sho...

Page 19 - BEFORE CALLING FOR SERVlCE

19 BEFORE CALLING FOR SERVlCE IF YOUR AIR CONDITIONER DOES NOT OPERATE PROPERLY, PLEASE CHECKTHE FOLLOWING ITEMS BEFORE CALLING FOR SERVICE. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose? • Is the fuse blown or the circuit breaker tripped? • Did you restart th...

Sharp AF-R120CX - Manual

Table of Contents:

Summary

Other Sharp Models