Sears 200.71233- User Manual

Page 2 - Warranty; Table Of Contents

1 Warranty .................................................................... 1 Important Safety Instructions ................................. 2 Parts .......................................................................... 3 Wiring Diagram .........................................................

Page 3 - Important Safety Instructions; WARNING

2 Help us help you REMEMBER: • Place charger as far away from battery being charged as the charger cables will permit. • Do not expose charger to rain or snow. • Never charge a frozen battery. If battery fluid (electrolyte) becomes frozen, bring battery into awarm area to thaw before you begin charg...

Page 4 - Parts; Wiring Diagram

3 Parts This section shows an illustration of your battery charger. Use it to become familiar with where all the parts arelocated, and what they look like. Wiring Diagram Replacement Parts List DieHard 71233 ITEM DESCRIPTION PART NUMBER 1 Handle 3599000286 2 Positive (RED) Cable w/clamps 3899001519 ...

Page 5 - Before Using Your Battery Charger; Assembling your charger

4 Attach Foot: Remove charger from packing materials and placecharger face down. Attach mounting foot and securewith the two, 1/4-20 thread cutting screws provided. continued on next page Before Using Your Battery Charger It is important to prepare your charger for use. This section will tell you ho...

Page 6 - Plugging it in

5 Axle Assembly (continued) : Place the charger on its side. Place one end of eachbracket into slot, then place the axle assembly undereach bracket. Fasten the other side of each bracketusing the two, 10-32 thread cutting screws provided. WARNING Plugging it in Electrical Shock Hazard Be sure that p...

Page 7 - Using an extension cord

6 MINIMUM RECOMMENDED EXTENSION CORD Length of Cord, in Feet 25 50 100 150 AWG* Size of Cord 16 14 10 8 *AWG=American Wire Gauge Using an extension cord The use of an extension cord is not recommended. Ifyou must use an extension cord, please make surethat you follow these guidelines: • Make sure th...

Page 8 - Using Your Battery Charger; Setting the controls

7 To obtain the best results from your battery charger, you must know how to use it properly. This section tells howto set the controls and how to charge a battery in and out of the vehicle. Using Your Battery Charger Follow these instructions to obtain the accurate chargelevel for your battery. TOU...

Page 10 - Using the engine start feature; Using the compressor

9 Using the engine start feature The Engine Start is a feature to help start the engineof your vehicle: 1. Push the switch located on the front panel toCHARGE/TEST. 2. Push SELECT BUTTON and choose 125ASTART (6 volt) or 225A START (12 volt). TheENGINE START feature will deliver 125 amps tohelp crank...

Page 11 - Charging Your Battery

10 Charging Your Battery NOTE: A marine (boat) boat battery must be removed and charged on shore. To charge it on board requiresequipment specially designed for marine use. Charging your battery in the vehicle: 1. Arrange the power cord and charging cords care-fully in order to avoid damage that cou...

Page 13 - Calculating charge times

12 Calculating charge times • Marine, or deep-cycle batteries are usually rated in Reserve Capacity (RC) . • NR means that the charger setting is NOT RECOM- MENDED . Find your battery’s rating on the chart below and notethe charge time given for each charger setting. Thetimes given are for batteries...

Page 14 - Troubleshooting

13 Troubleshooting Performance problems often result from little things that you can fix yourself. Please read through this table for apossible solution if a problem occurs. PROBLEM POSSIBLE CAUSE SOLUTION/REASONS No reading on Digital AC cord and/or extension Check AC outlet and extension cords for...

Sears 200.71233- User Manual

Table of Contents:

Summary

Other Sears Models