Sears 200.71232- User Manual

Page 3 - Warranty; Table Of Contents

1 Warranty .................................................................... 1 Important Safety Instructions ................................. 2 Parts .......................................................................... 3 Before Using Your Battery Charger ........................ 4 Assembli...

Page 4 - Important Safety Instructions; WARNING

2 Help us help you Remember: • Place charger as far away from battery being charged as the charger cables will permit. • Do not expose charger to rain or snow. • Never charge a frozen battery. If battery fluid (electrolyte) becomes frozen, bring battery into awarm area to thaw before you begin charg...

Page 5 - Parts; Wiring Diagram

3 Parts This section shows an illustration of your battery charger. Use it to become familiar with where all the parts arelocated, and what they look like. Replacement Parts List DieHard 71232 Item Description Part Number 1. Plastic Top 3799001210 2. Hub Cap 5200000008 3. Wheel 0099000120 4. Axle 00...

Page 6 - Before Using Your Battery Charger; Assembling your charger

4 To attach the axle assembly: 1. Remove charger from packing materials and placeupside down on a flat surface. Attach mountingfoot and secure with the two 1/4-20 thread cuttingscrews. 2. Hold axle upright on floor or work surface. Then,using a hammer, tap one of the plastic hubs ontothe top end of ...

Page 7 - Plugging it in

5 3. Tap the other axle cap onto the opposite end ofthe axle and place the axle assembly onto thebottom of the charger. Place one end of thebracket into slot, then place the axle assemblyunder each bracket. Fasten the other side of thebrackets using the two 10-32 screws provided. To attach the handl...

Page 8 - Preparing your battery to be charged

6 A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly groundedoutlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualifiedelectrician. MINIMUM RECOMMENDED EXTENSION CORD Length of Cord, in Feet 25 50 100 150 AWG*...

Page 9 - Using Your Battery Charger; Setting the controls

7 For best results from your battery charger, learn to use it properly. This section tells how to set the controls,charge a battery in or out of the vehicle, use the ENGINE START feature and test the battery. Using Your Battery Charger All the controls for your charger are located on thefront of the...

Page 11 - Charging Your Battery

9 Charging Your Battery Charging your battery in the vehicle: 1. Arrange the power cord and charging leadscarefully in order to avoid damage that could becaused by the hood, door, or moving engine parts. 2. Keep clear of the fan blades, belts, pulleys, andother parts that can cause injury. 3. Check ...

Page 13 - Calculating charge times

11 Calculating charge times • Marine, or deep-cycle batteries are usually rated in Reserve Capacity (RC) . • NR means that the charger setting is NOT RECOM- MENDED . Find your battery’s rating on the chart below and notethe charge time given for each charger setting. Thetimes given are for batteries...

Page 15 - Troubleshooting

13 Troubleshooting Performance problems often result from little things that you can fix yourself. Please read through this table for apossible solution if a problem occurs. PROBLEM POSSIBLE CAUSE SOLUTION/REASONS No reading on the Clamps are not making a Check for poor connections at battery and fr...

Sears 200.71232- User Manual

Table of Contents:

Summary

Other Sears Models