Sears 140- User Manual

Page 2 - TAbLE Of CONTENTS; Specifications; Please read this Owner’s Manual before using your; For information about troubleshooting, call toll-free from any-

2 TAbLE Of CONTENTS Warranty ........................................................................... 3Important Safety Instructions ........................................... 3Power Inverter 140 Product Features .............................. 5Before Using Power Inverter 140 ......................

Page 3 - of inflammable fumes, gases or clothing.; WARRANTy; This warranty gives you specific legal rights, and you may

3 IMPORTANT SAfETy INSTRUCTIONS SAVE THESE INSTRUCTIONS Before using your Power Inverter 140, read and understand this Owner’s Manual.• Keep the inverter well ventilated in order to properly dis- perse heat generated while it is in use. Make sure there are several inches of clearance around the top ...

Page 5 - POWER INVERTER 140 PRODUCT fEATURES; Positive Connector

5 POWER INVERTER 140 PRODUCT fEATURES 1. Green LED Indicator2. One, 3-prong AC Receptacle3. Positive Connector 4. Two, Negative Connectors 2 1 4 3 4

Page 6 - bEfORE USINg POWER INVERTER 140; modified sine wave inverter.

6 bEfORE USINg POWER INVERTER 140 It is important to know the continuous wattage of the device you plan to use with the inverter. The Power Inverter 140 must be used with devices drawing 140 watts or less. If the wattage is not marked on the device, an estimate can be made by multiplying the AC inpu...

Page 7 - OPERATINg INSTRUCTIONS; Turn the device on. If the LED Indicator briefly blinks; NOTE; : A ‘’buzzing’’ sound emitted from inexpensive

7 OPERATINg INSTRUCTIONS 1. Push the Power Inver ter 140 f ir mly into the 12V accessory outlet. The LED indicator light should glow GREEN verifying the inverter is receiving power. (If connecting in a vehicle, remove the cigarette lighter from its outlet.) 2. Make sure that the device to be operate...

Page 9 - LED INDICATOR AND OVERLOAD PROTECTION; The LED glows GREEN automatically when plugged into

9 LED INDICATOR AND OVERLOAD PROTECTION The LED glows GREEN automatically when plugged into a 12V DC source and will not glow under the following conditions: 1. When the power input from the vehicle’s battery drops to approximately 10 volts, low battery shutdown occurs and inverter shuts off. 2. Whe...

Page 10 - Solution; Poor contact at terminals.; cap too far finger tight is sufficient.; Inverter may be defective.

10 TROUbLESHOOTINg PRObLEM: Low or No Output Voltage Reason/ Solution 1. Poor contact at terminals. Unplug and reinsert Power Inverter 140. 2. Equipment being operated is drawing too much power. Use a higher capacity inverter or do not use the device. 3. Inverter is too hot (thermal shut down). Allo...

Page 11 - SPECIfICATIONS; Modified Sine Wave; REPLACEMENT PARTS; Can be purchased at most electronic component retailers.

11 SPECIfICATIONS Maximum Continuous Power .............................. 140 WattsSurge Capacity (Peak Power) .............................280 WattsNo Load Current Draw .......................................<0.2 AmpsWave Form .......................................... Modified Sine Wave Input V...

Table of Contents:

Summary

Other Sears Models