Page 2 - © 2013 Seagate Technology LLC. All rights reserved.; Document Revision History; Revision; Initial release
© 2013 Seagate Technology LLC. All rights reserved. Publication number: 100716627, Rev. D July 2013 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Seagate Laptop SSHD and SeaTools are either trademarks or...
Page 3 - SSHD SATA P; ONTENTS; ATA I
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D III C ONTENTS S EAGATE T ECHNOLOGY S UPPORT S ERVICES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.0 I NTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Page 4 - IGURES; SATA C
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D IV F IGURES F IGURE 1 T YPICAL 5V S TARTUP AND O PERATION C URRENT P ROFILE . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 F IGURE 2 A TTACHING SATA C ABLING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 5 - Seagate Technology Support Services
Seagate Laptop SSHD SATA Product Manual, Rev. D 1 For information regarding online support and services, visit http://www.seagate.com/about/contact-us/technical-support/ Available services include: • Presales & Technical support • Global Support Services telephone numbers & business hours • ...
Page 6 - NTRODUCTION; For more information on FIPS 140-2 Level 2 certification; About FIPS; Standard models
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 2 1.0 I NTRODUCTION This manual describes the functional, mechanical and interface specifications for the following Seagate Seagate ® Laptop SSHD model drives: For more information on FIPS 140-2 Level 2 certification About FIPS on page 16. These...
Page 7 - Scalability to higher performance levels.
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 3 1.1 A BOUT THE S ERIAL ATA I NTERFACE The Serial ATA interface provides several advantages over the traditional (parallel) ATA interface. The primary advantages include: Easy installation and configuration with true plug-and-play connectivit...
Page 8 - RIVE
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 4 D RIVE S PECIFICATIONS 2.0 D RIVE S PECIFICATIONS Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the phrases the drive and this drive are used throughout this manu...
Page 9 - LBA mode; Drive model; Table 1
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 5 D RIVE S PECIFICATIONS 2.1 F ORMATTED C APACITY F ORMATTED C APACITY (1) 1. One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. G UARANTEED S EC...
Page 10 - Table 3; Typical; All models; Table 2; Read
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 6 D RIVE S PECIFICATIONS 2.3 R ECORDING AND I NTERFACE T ECHNOLOGY Recording method Perpendicular Recording density 1894 Kb/in Track density 375 ktracks/in avg Areal density 705 Gb/in 2 avg Spindle speed 5400 RPM +/- 0.2% Sustained data transfer...
Page 11 - Figure 2; Power requirements for the drives are listed in the table in; Table 4; . Typical power measurements are based on an average of drives; OWER; Seek average
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 7 D RIVE S PECIFICATIONS 2.7 P OWER S PECIFICATIONS The drive receives DC power (+5V) through a native SATA power connector (refer to Figure 2 ). 2.7.1 Power consumption Power requirements for the drives are listed in the table in Table 4 . Typi...
Page 12 - Typical current profiles; The typical 5V startup and operation current profile is shown in; Figure 1; Figure 1 Typical 5V Startup and Operation Current Profile; Conducted noise; Voltage tolerance
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 8 D RIVE S PECIFICATIONS 2.7.1.1 Typical current profiles The typical 5V startup and operation current profile is shown in Figure 1 . Figure 1 Typical 5V Startup and Operation Current Profile 2.7.2 Conducted noise Input noise ripple is measured ...
Page 13 - drive buffer is enabled, the heads are parked and the spindle is at; OWER MODES; Table 5: Environmental specifications; Parameters; Ambient temperature
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 9 D RIVE S PECIFICATIONS 2.7.4 Power management modes The drive provides programmable power management to provide greater energy efficiency. In most systems, power management is controlled through the system setup program. The drive features the...
Page 14 - Table 6; DLE
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 10 D RIVE S PECIFICATIONS 2.8.1 Shock All shock specifications assume that the drive is mounted securely with the input shock applied at the drive mounting screws. Shock may be applied in the X, Y, or Z axis. 2.8.1.1 Operating shock These drives...
Page 15 - Table 7
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 11 D RIVE S PECIFICATIONS 2.10 E LECTROMAGNETIC I MMUNITY When properly installed in a representative host system, the drive operates without errors or degradation in performance when subjected to the radio frequency (RF) environment as defined ...
Page 16 - Safety certification; How to Identify and Resolve Radio-Television Interference
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 12 D RIVE S PECIFICATIONS 2.12 A GENCY C ERTIFICATION 2.12.1 Safety certification These products are certified to meet the requirements of UL60950-1, CSA60950-1 and EN60950 and so marked as to the certify agency. 2.12.2 Electromagnetic Compatibi...
Page 17 - China Restriction of Hazardous Substances (RoHS) Directive
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 13 D RIVE S PECIFICATIONS 2.13 E NVIRONMENTAL P ROTECTION Seagate designs its products to meet environmental protection requirements worldwide, including regulations restricting certain chemical substances. 2.13.1 European Union Restriction of H...
Page 18 - ONFIGURING AND; Serial ATA Cables and Connectors; for connector pin definitions. Either end of the SATA signal; Figure 2 Attaching SATA Cabling; CAUTION; the drive’s exposure to ESD.
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 14 C ONFIGURING AND M OUNTING THE D RIVE 3.0 C ONFIGURING AND M OUNTING THE D RIVE This section contains the specifications and instructions for configuring and mounting the drive. 3.1 H ANDLING AND S TATIC -D ISCHARGE P RECAUTIONS After unpacki...
Page 19 - Figure 3; Figure 3 Mounting Dimensions (for standard models); Top cover stiffness/deflection
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 15 3.3 D RIVE M OUNTING You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 3 for drive mounting dimensions. Follow these important mounting precaut...
Page 20 - BOUT; FIPS; Figure 4 Example of FIPS tamper evidence labels.; For reference only. May not represent actual drive.
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 16 A BOUT FIPS 4.0 A BOUT FIPS The Federal Information Processing Standard (FIPS) Publication 140-2, FIPS PUB 140-2, is a U.S. government computer security standard used to accredit cryptographic modules. It is titled “Security Requirements for ...
Page 21 - ERIAL; ATA D; Table 8; Power
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 17 5.0 S ERIAL ATA (SATA) I NTERFACE These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes 0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6. The dri...
Page 22 - ATA C; Table 9; Serial; ATA-standard commands names
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 18 S ERIAL ATA (SATA) I NTERFACE • the signal pins and the rest of the power pins. 3 There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. 4 All used...
Page 23 - ATA-standard security commands
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 19 S ERIAL ATA (SATA) I NTERFACE Set Multiple Mode C6h S.M.A.R.T. Disable Operations B0h/D9h S.M.A.R.T. Enable/Disable Autosave B0h/D2h S.M.A.R.T. Enable Operations B0h/D8h S.M.A.R.T. Enable/Disable Auto Offline B0h/DBh S.M.A.R.T. Enable One Att...
Page 24 - Identify Device command; The Identify Device command (command code EC; Drive Specifications; on page 4 for default; xxxx
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 20 S ERIAL ATA (SATA) I NTERFACE 5.3.1 Identify Device command The Identify Device command (command code EC H ) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose...
Page 25 - Table 10 Identify Device command
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 21 S ERIAL ATA (SATA) I NTERFACE 60–61 Total number of user-addressable sectorsThis field contains a value that is one greater than the total number of user-addressable sectors. The maximum value that shall be placed in this field is 0FFFFFFFh. ...
Page 26 - Table 11 Bit Descriptions; ORD
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 22 S ERIAL ATA (SATA) I NTERFACE 98-99 Streaming Performance Granularity 0000 H 100–103 Total number of user-addressable LBA sectors available(see Section 3.2 for related information)These words are required for drives that support the 48-bit ad...
Page 28 - Set Features command; Table 12 Set Features command values
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 24 S ERIAL ATA (SATA) I NTERFACE 5.3.2 Set Features command This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, cl...
Page 29 - Draft; ODE IN FEATURES REGISTER
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 25 S ERIAL ATA (SATA) I NTERFACE 5.3.3 S.M.A.R.T. commands S.M.A.R.T. provides near-term failure prediction for disk drives. When S.M.A.R.T. is enabled, the drive monitors predetermined drive attributes that are susceptible to degradation over t...
Page 30 - NDEX
S EAGATE L APTOP SSHD SATA P RODUCT M ANUAL , R EV . D 26 I NDEX A acoustics 10 active mode 9 Address 18 agency certification 12 ambient temperature 6 areal density 6 ATA commands 18 Australia/New Zealand Standard AS/NZS3548 1995 12 Australian Communication Authority (ACA) 12 Australian C-Tick 12 Av...
Page 33 - Seagate Technology LLC
Seagate Technology LLC AMERICAS Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, United States, 408-658-1000 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888EUROPE, MIDDLE EAST AND AFRICA Se...
