Sanyo xe50 - Manual
Sanyo xe50 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Follow these steps to replace the lamp.
1.
Turn off the projector and unplug the AC power cord. Let the projector cool for at
least 45 minutes.
2.
Remove the screw from the lamp cover and open the Cover.
3.
Loosen the two (2) screws that secure the lamp. Lift the lamp out of the projector
by using the handle.
4.
Replace the lamp with a new one and secure the two (2) screws. Make sure that
the lamp is set properly. Close the lamp cover and secure the screw.
5.
Connect the AC power cord to the projector and turn on the projector.
Follow these steps to reset the lamp counter.
1.
Turn the projector on and press the MENU button to display the On-Screen
Menu. Use the Point buttons to move the red frame pointer to the Setting
Menu icon.
2.
Use the Pointed buttons to move the red frame pointer to Lamp counter and
then press the SELECT button. The first dialog box appears showing the total
accumulated lamp time and reset option. If you select Reset,
“Lamp replacement
counter Reset?
”
appears. Select
“
Yes
”
to continue.
3.
Another confirmation dialog box appears, and selects
“
Yes
”
to reset the Lamp
replacement counter.
When the projection lamp of the projector reaches its end of life, the Lamp
replacement icon appears on the screen and LAMP REPLACE indicator lights
yellow. Replace the lamp with a new one promptly. The timing when the
LAMP REPLACE indicator should light is depending on the lamp mode.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized service station for a checkup of the
unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or
coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the
projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the
unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.
When ordering a
replacement lamp, first
check which model
projector you have.
PLC-XE50
Lamp No. 610 337 9937
or
PLC-XE50A
Lamp No. 610 347 8791
NB: This is an abridged guide only. For additional safety precautions and information, please consult the projectors owner’s manual.
Lamp Replacement for Sanyo PLC-XE50 & XE50A Projectors
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
