Sanyo VCC-6570P - Manual

CONCERNING AUTO-IRIS LENSES DC type auto-iris lens A lens without amplifier circuit that operates only on a DC power source. In general, this type of lens isreferred to as DC type coil lens or DC type non-amplifier lens. (Set the A.I. LENS switch to the DC position.) VIDEO type auto-iris lens A lens...

MOUNTING THE LENS Please use a DC type auto-iris lens (sold separately). Check the lens mount Do not use a lens if the length “ L ” is more than 5 mm. That may damage the camera and prevent proper installation. 1 Remove the lens mount cap from the camera. 2 Install the auto-iris lens. CS mount type ...

MOUNTING THE LENS Rewiring the lens cable in the lens iris plug 1 Prepare the lens cable. Cut the cable at the plug, then remove approx. 8 mm of the cable sheath and strip about 2 mm from each wire. 2 Install the lens iris plug. Solder the cable to the pins following the correct pin layout (refer to...

CONNECTIONS Basic connection for monitoring or recording The peripheral devices (VCR, monitor, lens, etc.) and cables aresold separately. 1 Make the video signal connection between the camera andthe monitor or time lapse VCR. 2 When using this unit, the supplied clamping core A and B must beinstalle...

CONNECTIONS Connections to the camera Y/C OUT connector The peripheral devices (VCR, monitor, lens, etc.) and cables aresold separately. 1 Using a coaxial cable (twin type, 75 ohms), connect the Y/COUT connector from the camera to the S-VIDEO inputterminal on the monitor or time lapse VCR. 2 When us...

SETTINGS The illustration shows the factory default settings for the switches in the camera setup section. The camera settings are described on the assumption that a DC type auto iris lens is being used. If you are using a VIDEO type auto iris lens, besure to read the Note which is given. Control na...

SETTINGS High speed electronic shutter setting Normally, the speed setting switches for the high speed electronicshutter are all set to the down ( OFF ) position. This sets the electronic shutter speed to 1/50 sec. The switches can be set as indicated intable A to select one of the 8 speeds availabl...

SETTINGS Backlight compensation setting This camera has two different backlightcompensation functions: Normally backlight compensation switch 6 ( MULT ) and 7 ( CENT ) are set to the down ( OFF ) position. Change the backlight compensation switch settingsdepending on the conditions. • MULT mode: Use...

SETTINGS White balance adjustment Normally the switch 8 ( WB ) is set to the down ( ATW : auto white balance) position and the white balance is adjusted automatically. If amanual white balance adjustment is necessary, follow the steps below. Set the switch 8 ( WB ) to the up ( M : manual) position, ...

SETTINGS External sync adjustment (VBS) 1 Connect the VBS signal output for the other camera to the VBS IN connector at the rear of this camera. 2 If the signals are not synchronized, change the sub-carrier (SC-P1)switches as follows. Setting 9-pin 10-pin Default OFF (down) OFF Set to 90˚ counterclo...

TROUBLESHOOTING Before taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform correctly, pleaseconsult your dealer or a Sanyo Authorized Service Centre. No picture on the monitor screen • Is the power turned on to all connected ...

SPECIFICATIONS Camera: Scanning system : PAL standard(625 TV lines, 25 frames/sec.) Interlace : PLL 2:1 interlace Image device : 1/3 inch solid state image device CCD Picture elements : 795 (H) x 596 (V) Effective picture elements : 752 (H) x 582 (V) Synchronizing system : Internal sync, Line lock m...