Page 2 - To the Owner; Safety Precaution
EN-1 To the Owner Before operating this projector, read thismanual thoroughly and operate the projectorproperly.This projector provides many convenientf e a t u r e s a n d f u n c t i o n s . O p e r a t i n g t h eprojector properly enables you to managethose features and maintains it in bettercon...
Page 4 - Safety Instructions
EN-3 Safety Instructions All the safety and operating instructionsshould be read before the product is operated.Read all of the instructions given here andr e t a i n t h e m f o r l a t e r u s e . U n p l u g t h i sp r o j e c t o r f r o m A C p o w e r s u p p l y b e fo r ec l e an i n g . D o...
Page 5 - USE CAUTION IN CARRYING OR
EN-4 Air Circulation Openings in the cabinet are provided for ventilation and to ensure reliable operation o f t h e p r o d u c t a n d t o p r o t e c t i t f r o m overheating, and these openings must notbe blocked or covered. CAUTION Hot air is exhausted from the exhaust vent.When using or insta...
Page 6 - Compliance; Federal Communications Commission Notice; AC Power Cord for the United States and Canada:; AC Power Cord for the United Kingdom:; WARNING : A PLUG WITH BARED FLEXIBLE
EN-5 Compliance Federal Communications Commission Notice Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residenti...
Page 7 - Notes on AC Power Cord; CAUTION; Ground
EN-6 Notes on AC Power Cord AC Power Cord must meet requirement of country where you use a projector. Confirm anAC plug type with graphics below and proper AC Power Cord must be used. If supplied ACPower Cord does not match your AC outlet, contact your sales dealer. This projector isequipped with a ...
Page 8 - CONTENTS
EN-7 CONTENTS Introduction ............................................................................................................... 8 Projector Features ............................................................................................................ 8Package Contents ................
Page 9 - Introduction; Projector Features; The projector offers the following features:
EN-8 * means compressed. Introduction Projector Features The projector integrates high-performance optical engine projection and a user-friendlydesign to deliver high reliability and ease of use. The projector offers the following features: 3 panel 0.56 inch LCD projectorWXGA (1280 x 800 pixels)1.2X...
Page 10 - Package Contents; Projector with Lens Cap
EN-9 Package Contents When you unpack the projector, make sure you have all these components: Save the original shipping carton and packing material; they will come in handy ifyou ever to ship your unit. For maximum protection, repack your unit as it wasoriginally packed at the factory.Accessories a...
Page 11 - Projector Overview; Front View
EN-10 1 Front IR remote control sensor 2 Projection lens 3 Focus ring 4 Zoom ring 5 Control panel 1 2 3 6 9 8 7 4 5 10 11 7 8 6 AC power socket 7 Elevator foot 8 Elevator button 9 Ventilation holes Lens cap strap Lens cap 1 0 11 Projector Overview Front View
Page 13 - Using the Product; Control Panel; LED; MENU; Displays or exits the on-screen display menus.
EN-12 Using the Product Control Panel LED 1 Lamp LED indicatorRefer to “LED Indicator Messages”. 2 Power LED indicatorRefer to “LED Indicator Messages”. Button Function 3 ON / STAND-BY Refer to “Powering On/Off the Projector”. 4 Four directional (INPUT/AUTO PC ) buttons - Use four directional button...
Page 14 - Connection Ports; VIDEO IN; Connects analog RGB output signal from a computer to this jack.; MONITOR OUT; Connects Y Cb/Pb Cr/Pr output from video equipment to this jack.
EN-13 Connection Ports 1 AUDIO IN (R/L) Connects an audio output from video equipment or computer to this jack. 2 VIDEO IN Connects composite video output from video equipment to this jack. 3 COMPUTER IN Connects analog RGB output signal from a computer to this jack. 4 S-VIDEO IN Connects S-Video ou...
Page 15 - Remote Control
EN-14 Remote Control 1 ON / STAND-BY Refer to “Powering On/Off the Projector”. 2 F o u r d i r e c t i o n a l ( I N P U T / A U T O P C )buttons - Use four directional buttons to select items or make adjustments to your selection. - Manually selects an input source. (Left button) - Automatically ad...
Page 16 - Installing the Batteries; . Open the battery cover in the direction
EN-15 Installing the Batteries 1 . Open the battery cover in the direction shown. 2 . Install batteries as indicated by the diagram inside the compartment. 3. Close the battery cover into position. Keep the batteries out of the reach of children. There is a danger of death byaccidentally swallowing ...
Page 17 - Remote Control Operation; Operating the projector from the front; Operating the projector from the rear
EN-16 Remote Control Operation Point the remote control at the infrared remote sensor and press a button. Operating the projector from the front Operating the projector from the rear Do not point the LED light pointer directly to the people's eyes (especially smallchildren). There is a danger of inj...
Page 18 - Installation; Connecting the Projector; Audio Cable
EN-17 Desktop type Laptop type 3 6 5 8 4 1 2 2 7 When connecting cable, power cords of both a projector and external equipmentshould be disconnected from AC outlet.The figure above is a sample connection. This does not mean that all of thesedevices can or must be connected simultaneously.The cables ...
Page 19 - Powering On/Off the Projector; Powering on the projector:; INPUT; Powering Off the Projector:
EN-18 Powering On/Off the Projector Powering on the projector: 1 . Remove the projector lens cap.2 . Complete the AC power cord and peripheral signal cable(s) connections.3 . Press ON / STAND-BY button to turn on the projector. 4 . Turn on your source (computer, notebook, DVD, etc.). The projector a...
Page 20 - Adjusting the Projected Image; Adjusting the Projector Height; elevator feet into position.
EN-19 Adjusting the Projected Image Adjusting the Projector Height The projector is equipped with two elevator feet to adjust the image height up to 9.0degrees. To raise the image:1 . Press the elevator button.2 . Raise the image to the desired height angle, then release the button to lock the eleva...
Page 21 - Adjusting the Projector Zoom and Focus; Rotate to the left to enlarge the image.
EN-20 Adjusting the Projector Zoom and Focus 1 . Adjust the image by rotating the zoom ring. Rotate to the right to reduce the image. Rotate to the left to enlarge the image. 2 . Focus the image by rotating the focus ring. A still image is recommended for focusing. Focus ring Zoom ring
Page 22 - Adjusting Projection Image Size
EN-21 Position the projector in a horizontal position; other positions can cause heatbuild-up and damage to the projector.Make sure the heat ventilation holes are not blocked.Do not use the projector in a smoky environment. Smoke residue may causebuildup on critical parts. 32 (Min.) 92 152 212 272 3...
Page 23 - Menu Operation
EN-22 Menu Operation The projector has multilingual On Screen Display menus that allow you to make imageadjustments and change a variety of settings.
Page 24 - How to operate
EN-23 How to operate 1 . Press MENU button to open the OSD menu. 2 . When OSD is displayed, use S / T buttons to select any feature in the main menu. After selecting the desired main menu feature, press X button to enter sub-menu for feature setting. 3 . Adjust the settings with W / X buttons. 4 . P...
Page 25 - Total Dots
EN-24 Picture (Computer Mode) Brightness Adjusts brightness of the image. Press W to darken the image. Press X to lighten the image. Contrast Adjusts contrast of the image. Press W to decrease the contrast. Press X to increase the contrast. Fine Sync “Fine Sync” synchronizes the signal timing of the...
Page 27 - Aspect
EN-26 Image (Computer Mode) Aspect Use this function to choose your desired image size. Q 1 TO 1 : Keep the image with original width- height ratio. Q FILL ASPECT : Maintain the original aspect ration of the input signal while enlarging to fill as much of the output display as possible. 16: 9 input ...
Page 28 - FILL ALL; Any type
EN-27 FILL ALL H Position (Horizontal Position) Press W to move the image left. Press X to move the image right. V Position (Vertical Position) Press W to move the image down. Press X to move the image up. Auto PC Adj. Automatically scans the input source. 1280 x 800 Any type ofresolution. Always fi...
Page 32 - Maintenance; Cleaning the Lens
EN-31 Maintenance The projector needs proper maintenance. You should keep the lens clean as dust, dirt orspots will project on the screen and diminish image quality. If any other parts needreplacing, contact your dealer or qualified service personnel. When cleaning any part ofthe projector, always s...
Page 33 - Cleaning the Air Filter; cord from the wall socket.
EN-32 Turn off the projector and remove the AC power cord from the power outlet beforebeginning maintenance work.Make sure the lens is cool before cleaning.Do not use detergents or chemicals other than those noted above. Do not usebenzene or thinners.Do not use chemical sprays.Use a soft cloth or le...
Page 34 - Replacing the Lamp; Projector lamps have a finite life. Replace the lamp when:; “LED Indicator Messages”
EN-33 Replacing the Lamp Projector lamps have a finite life. Replace the lamp when: A warning message “Lamp is approaching the end of its useful life in full poweroperation. Replacement suggested!” appears on the screen.The image becomes darker and hues become weaker after a lamp has been for a long...
Page 35 - ORDER REPLACEMENT LAMP
EN-34 1 . Turn off the projector and unplug the AC power cord. 2 . P l a c e a p r o t e c t i v e s h e e t ( c l o t h ) b e n e a t h t h e projector. Turn the projector over so you canaccess the lamp cover. 3 . Loosen the access panel screw and open the p a n e l . 4 . Loosen the screws on the b...
Page 36 - Specifications
EN-35 Specifications Display Type 3 panel 0.56 inch LCD projector Resolution (Pixels) 1280 x 800 (1,024,000 dot x 3) Lens Manual Zoom (1.2X) Aspect Ratio 16:10 (Default) Screen Size 26.7" - 302" Lamp 210W Video Compatibility NTSC3.58, NTSC4.43PAL-60, PAL-M,NSECAMHDTV (480i/p, 576i/p, 720p, 1...
Page 37 - Appendix; LED Indicator Messages
EN-36 Appendix LED Indicator Messages Projector Status Standby Lamp waiting Lamp on Lamp ignition failure Fan lock Over Temperature Over temperature (Filter) C o o l i n g Lamp Replacement LED Type Power LED Lamp LED Color Status Color Status Meaning GreenGreenGreenGreen Amber Green - Green GreenGre...
Page 38 - Compatibility Modes; Mode
EN-37 Compatibility Modes Computer (COMPUTER IN / DVI-D IN terminal): Mode Resolution fH (kHz) fV (Hz) VGA mode 3 640 x 480 3 1 . 4 6 9 5 9 . 9 4 0 VGA VESA 72 Hz 3 7 . 8 6 1 7 2 . 8 0 9 VGA VESA 75 Hz 3 7 . 5 0 0 7 5 . 0 0 0 VGA VESA 85 Hz 4 3 . 2 6 9 8 5 . 0 0 8 SVGA VESA 56 Hz 800 x 600 3 5 . 1 5...
Page 39 - Troubleshooting; Cause; The temperature is too high.; Solution; Plug in the AC power cord.
EN-38 Troubleshooting Refer to the symptoms and measures listed below before sending the projector for repairs.If the problem persists, contact your local reseller or service center.Please refer to “LED Indicator Messages” (p.36) as well. SymptomNo power. Power goes outduring use. No image appearson...
Page 40 - The batteries could be weak.
EN-39 SymptomR e m o t e c o n t r o ldoesn’t work. Cause The batteries could be weak. The polarity is not correct. The remote control is not beingused within the effective range.T h e r e a r e s o m e o b s t r u c t i o n sbetween the remote control andprojector.There are some fluorescent orother...
Page 41 - Serial Control Interface; Connection and Operation
EN-40 Serial Control Interface This projector provides a function to control the projector's operations by using the RS-232Cserial port. Connection and Operation Connect a RS-232C serial cross cable to RS-232CPORT on the projector and serial port on the PC. Launch a communication software provided...
