Sanyo LNS-W03 - Manual
Sanyo LNS-W03 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Note : Figures in this manual may be differ from the actual product.; NOTES ON LENS INSTALLATION; Check the lens is securely fixed by 4 screws.; BE SURE TO CHECK FOR SAFETY; LIST OF CONTENTS; Following parts are included in the packing.
- Page 3 – LENS REPLACEMENT AND INSTALLATION PROCEDURE
- Page 4 – ADJUST FOCUS
- Page 7 – FOCUS ADJUSTMENT
Type of the Cabinet (1) See Page 2
LCD PROJECTOR LENS
MODEL NO. LNS-W03
LENS REPLACEMENT
AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of
cabinet. Before installing or replacing the lens, make sure the type of cabinet and be
sure to refer to the Installations corresponding with your projector.
When installing or replacing the lens, make sure the Lens Model No. matches with
your projector. Refer to the catalog, or contact your sales dealer for the proper Lens
Model No.
TYPE OF THE CABINET AND INSTALLATION PROCEDURES
Refer to the Installation procedure corresponding to your projector and install the lens
correctly. (See the chart below.)
Type of the Cabinet (2) See Page 4
1AA6P1P2952-- (ICYZ)
For use the other models (other than above cabinet), contact your sales dealer.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Some parts are not used for installation or replacement. Keep these parts for later use. Note : Figures in this manual may be differ from the actual product. NOTES ON LENS INSTALLATION The ZOOM, FOCUS and LENS SHIFT adjustment on the Top Control or theRemote Control cannot be operated with this Lens...
LENS REPLACEMENT AND INSTALLATION PROCEDURE 1. Remove screws A (2 screws). 2. Pull down the lower lens cover while pushing the part D, then remove it. 3. Remove screws B (2 screws). 4. Remove screws C (2 screws) and remove upper lens cover. 1 A Fig-1 Fig-2 ● IN CASE OF MODEL WITHOUT LENS Remove 2 sc...
MOUNT THE LENS COVER. (See figure-6) INSTALL THE LENS. (See figure-4) 1. Remove protective caps(front and back) on the lens. 2. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens.Use the driver included with the lens tofasten the screws. (Afte...
