Sanyo AH-23631 - Manual
Sanyo AH-23631 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Lens Replacement Procedure; Remove the Lens; Mount the Lens; Slowly turn the lens clockwise until it clicks. Make sure that
- Page 3 – Turn the Lens Cover counter-clockwise and pull it; Remove the Lens Cover and the Top Cabinet; Slide the Light-Block Sheet Base upward to remove it.; Remove the Light-Block Sheet Base
- Page 5 – Mount the Light-Block Sheet Base
- Page 6 – screen may not be as sharp as at the center of the screen.; Focus Adjustment; d. Repeat steps b and c until correct focus is obtained.
After the lens replacement (before attaching the top cabinet), check the following
things.
1. Check the lens is properly installed.
2. Check no wiring is tangled on the gear of the lens motor or other mechanical
parts.
3. Check no parts is missing, or no mounting part is lost.
LCD Projector
Lens Replacement Procedure
Model Number
1AA6P1P5412-- (IFEK-EI)
LNS-T10/LNS-W10/LNS-T11/LNS-W11
Lens replacement should be performed by the qualified service
personnel.
It should be followed by this procedure precisely.
Before an attempt to replace the lens, confirm the model number
(both the LCD projector and the lens) and prepare the proper lens.
Lens installation is different in cabinet design (Type A and B).
Before installation the lens, check cabinet design should be made.
The lens cover is on the lens for protection. Be sure to remove the
lens cover before installation.
When installing or removing the lens, be careful not to stain,
scratch or damage the lens.
If you have any questions, contact the dealers.
Notes on Lens Replacement
Following parts are contained in the packing.
●
LENS
●
LIGHT-BLOCK SHEET (Spare)
{Except LNS-W11 (AH-23631)}
1 piece
1 piece (Part No. 910 322 9677)
Notes on Lens Replacement
Parts List
Printed in Japan
AH-23541/AH-23511/AH-23661/AH-23631
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
-2- Lens Replacement Procedure While pressing the Lens release button on the top ofthe cabinet, turn the lens counterclockwise until itstops and pull it out slowly from the projector. Be careful not to drop the lens. Remove the Lens 1 2 Perform the steps 1-2 for lens replacement.First set the lens a...
-3- Lens Replacement Procedure 1. Turn the Lens Cover counter-clockwise and pull it toward front to remove the Lens Cover. 2. Remove the two screws (SCREW "A") and remove the Top Cabinet. Remove the Lens Cover and the Top Cabinet 1 SCREW "A" LENS COVER TOP CABINET Fig-1-1 Slide the L...
-5- Mount the Light-Block Sheet Base. UP Turn the projector on and check Lens shift, Zoom andFocus is operating properly.If Light-Block Sheet interfere with those operations,check if the Light-Block Sheet is set properly.LNS-W11 (AH-23631) cannot adjust the Zoom andFocus at the Remote control or the...
