Samsung PC1NWSMAN - Installation Manual

Page 2 - For Slim 1 Way cassette; Accessories; Handle the panel carefully.; Installing the product; PC1NUSMAN

2 For Slim 1 Way cassette Fix 2 hooks of the panel on both sides of the indoor unit. 1 Tighten the panel fixing screws. 2-1 Tighten the panel fixing screws temporarily. 2-2 Close the gap between the panel and the ceiling by adjusting the position of the panel and then tighten the screws completely. ...

Page 3 - ENGLISH

3 ENGLISH Connect the cables between the indoor unit and the panel. 4-1 Remove the 3 screws of the electrical component box and take out the electrical component box cover. 4-2 Connect the panel connector to the indoor unit PCB connector. X Connect the swing motor of the panel or the connectors of r...

Page 4 - When the hooks of the panel cannot be fixed to the indoor unit,; PC1NUPMAN

For Slim 1 Way cassette Fix 2 hooks of the panel on both sides of the indoor unit. 1 Tighten the panel fixing screws. 2-1 Tighten the panel fixing screws temporarily. 2-2 Close the gap between the panel and the ceiling by adjusting the position of the panel and then tighten the screws completely. 2 ...

Page 8 - For 2 Way Cassette

Fix 2 hooks of the panel on both sides of the indoor unit. 3 Assemble 8 bolts to the panel and the indoor unit temporarily,then adjust it not to leave a gap between the ceiling and the panel. 4 Remove the front grille. 2-1 Remove the safety clips. 2-2 Open the front grille about 45 q and pull it for...

Page 9 - If the panel is installed incorrectly, air may leak.

9 ENGLISH 9 Install the air flow blade. 5-1 Fix the right part of the blade to the indoor unit. 5-2 Fix the other side of the blade. 5-3 Fix the middle part of the blade by pushing slightly the middle tab in the indoor unit. 5 If the direction is incorrect, the blade will not be inserted smoothly. C...

Page 10 - For 4 Way Cassette; Installation manual; Detach the front grille

For 4 Way Cassette Open the electrical component box cover. • After untightening the screws, slide the electrical component box cover in the direction of the arrow as shown in the figure and pull it down. 1 Push the switch type handles inward and pull the grille to open. • Handles are located on the...

Page 11 - ENGLISHENGLISH; Install the panel using 2 hooks on the both sides of the indoor unit.

ENGLISHENGLISH Install the panel using 2 hooks on the both sides of the indoor unit. 3 Detach the 4 corners of the panel. Use two grooves on the each corner of the panels when pulling them out. • Handle the corner with digital display gently, since there are electrical cables connected to that corne...

Page 12 - Close the electrical component box cover and tighten the screws.; If the angle on the air flow blades has been changed by user

12 E- 12 E- 12 12 Close the electrical component box cover and tighten the screws. 7 Attach and close the front grille. • Make sure the hooks on the rear side of grille fits properly into the grooves on panel ( X ) and then push the panel to close ( Y ). 8 Check out that the panel is fixed to the in...

Page 13 - SERViS iSTASYONLARI GÖSTERiR LiSTE

SERViS iSTASYONLARI GÖSTERiR LiSTE ÑƟ²øƟIÃࢩÑđøƟIÃࣛǄŵkƟÑAÑÑŵđĘÃĘ 1 ǄĘǤĘÃ ƊđƊƸĘkøkAƟŵĮĘÃAƊÃƊƟĘ9ƸøťȐ࢏ǤkƟÑA࢏øÑđÑƟkUƓÑŵçkƟÑøƟU࢏ƓƟÑ࢏ 2 đkŵçkȐUŵkƊÑ øƟĮÑƊÑƊƟĘ9ƸøÑƓđkŵçkȐÑĮƟçIÃøŵAU࢏ĘĮࡤߩߪçࡤߥĘĮࡤ9ߥkǽƸť 3 ƟkøkĮĘ ߢߤߣߤߦߨߩߢߨߢߢ 4 çƊ ߢߤߣߤߦߥߩߪߧߤߪ 6 ƟÑAŵkƟƊÑAÑøĘĮ ߨߤ߫ߥߪߪ 8 ǤkŵÑĘĮ ߩߦߤߢߥ߫ߩߥߥߩ 1 ƊʪθӬϑʒ̈ ²đkƟUĮ¢ŵƸU¢...