Samsung F-AR12FSSSCWK1 - User Manual

English-5 Pr EP ar aTIOn 01 Do not install this appliance near a heater, inflammable material. Do not install this appliance in a humid, oily or dusty location, in a location exposed to direct sunlight and water (rain drops). Do not install this appliance in a location where gas may leak.  This may...

English-6 Safety precautions FOR POWER SUPPLY CAUTION When not using the air conditioner for a long period of time or during a thunder/lightning storm, cut the power at the circuit breaker.  Failing to do so may result in electric shock or fire. FOR USING WARNING If the appliance is flooded, please...

English-7 Pr EP ar aTIOn 01 Do not insert your fingers or foreign substances into the outlet when the air conditioner is operating.  Take special care that children do not injure themselves by inserting their fingers into the product. Do not touch the air flow blade with your hands or fingers durin...

English-9 Pr EP ar aTIOn 01 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsibl...

English-10 Checking before use Operation ranges The table below indicates the temperature and humidity ranges the air conditioner can be operated within. Refer to the table for efficient use. Smart install  Through Smart install function, installer can check if the installation was done properly. ...

English-11 Ba SIC FunCTIOn 02 Main parts Your air conditioner may slightly look different from illustration shown below depending on your model. Checking the name of the parts Display Temperature indicator / Filter Reset indicator( ) / Defrost indicator( ) / Power consumption indicator / Auto clean ...

English-12 Checking the remote controller Remote controller buttons  Before using the functions of the remote controller, you should set the current time. (Refer to page 17) Power Turn on/off the air conditioner Temp + – Increase/Decrease the temperature by 1 ˚C. Options Select options during opera...

English-13 Ba SIC FunCTIOn 02 Correct disposal of batteries in this product (Applicable in countries with separate collection systems) This marking on the battery, manual or packaging indicates that the batteries in this product should not be disposed of with other household waste at the end of thei...

English-14 Basic function Basic operation is an operation mode that can be selected by pressing the Mode button. auto(2-Step Cooling or Heat) In Auto mode, the air conditioner will automatically set the temperature and fan speed depending on the room temperature . • 2-Step Cooling mode sets the air ...

English-17 Ba SIC FunCTIOn 02 adjusting the air flow direction This function will allow you to adjust the air flow direction vertically and/or horizontally . Press the or button to make air flow blades vertically and/or horizontally. Vertical air flow Horizontal air flow Remote controller display Re...

English-18 Timer Before using the functions of the air-conditioner, set the current time . Remote controller display 1 . Press the Settings button . 2 . Press the , or Settings button until (Colck) indicator starts to blink . 3 . Press the SET button to set the Colck function . - (Colck)  (Colck) i...

English-19 TIMEr 03 Setting the On/Off timer You can set the air conditioner to turn on/off automatically at desired time. Setting On timer while the air conditioner is off / Off timer while the air conditioner is on Setting On timer Remote controller display Setting Off timer Remote controller disp...

English-20 additional options available in On/Off timer mode (When the remote controller is on) You can select from Auto/Cool/Dry/Fan /Heat . You can set the temperature after selecting the operation mode .Temperature adjustment is available when Auto/Cool/Dry /Heat mode is selected . Setting on tim...

English-21 TimEr 03 mode For a comfortable sleep, the air conditioner will operate in 3 stages in order of Fall asleep  Sound sleep  Wake up stage. When the air conditioner is operating in Cool/Heat mode; Remote controller display 1. Press the Timer button to select ( ). - ( ) indicator will keep ...

English-22 Options using the Fast function using the Comfort function You can set the Comfort function to provide mild cooling/heating. When the air conditioner is operating in Cool/Heat mode; Remote controller display 1 . Press the Options button . 2 . Press the , or Options button until (Comfort) ...

English-23 O PTIO n S 04 using the Single user function This function will reduce the energy usage while the air conditioner is operating in Cool/Heat mode. When the air conditioner is operating in Cool/Heat mode; Remote controller display 1 . Press the Options button . 2 . Press the , or Options bu...

English-24 2-Step cooling function 2-Step Cooling function will set the air conditioner to cool the room quickly to reach the set temperature when the indoor temperature is higher than the set temperature, and then the air conditioner will automatically operate in Dry mode when indoor temperature re...

English-25 O PTIO n S 04 using the Quiet function You can reduce the noise generated from an indoor unit during Cool/Heat mode. When the air conditioner is operating in Cool/Heat mode; Remote controller display 1 . Press the Options button . 2 . Press the , or Options button until (Quiet) indicator ...

English-26 using the Virus Doctor function This function will produce positive ions and supply them into the airflow. (Applicable model: AR  WK  Series) When the air conditioner is operating; Remote controller display 1 . Press the Options button . 2 . Press the , or Options button until ( ) in...

English-27 SE TTI ngS 04 Settings using the auto clean function Auto clean function will minimise the moisture inside of the indoor unit. Activate this function to help provide you with clean air. When the air conditioner is operating; AR  WK  Series AR  UR  Series Indoor unit display 1 . ...

English-28 Setting the Display option Display lighting can be adjusted by following this instruction. 1 . Press the Settings button . 2 . Press the , or Settings button until (Display) indicator starts to blink . 3 . Press the SET button to set the display status . - 3 seconds after setting Display ...

English-29 SE TTI ngS 05 resetting the Filter clean reminder You can conveniently control your air conditioner anywhere with Smart APP. (Applicable model: AR  WK  Series) WIFI(WPS) is not seen to new remote control LCD.( It is hidden function .) Remote controller display 1 . Press the Timer but...

English-30 Cleaning the air conditioner Cleaning the indoor unit Cleaning the outdoor unit heat exchanger  Clean the product with a tepid damp cloth.  Remove the dust accumulated in the gap of the product with a soft brush.  When dust accumulates on the heat exchanger, it may decrease cooling per...

English-32 Cleaning the air conditioner reassembling the air filter 1 . Put the filter on the main body and insert the hooks which are in the top of the Air filter into the the main body .  Air filter 2 . There’s one hook in both side of the filter, press the surface of the Air filter softly and ge...

English-33 O THErS 06 Maintaining the air conditioner If the air conditioner will not be used for an extended period of time, dry the air conditioner to maintain it in best condition.  : This check mark requires checking the indoor/outdoor unit periodically. Follow the description to maintain the a...

English-34 Troubleshooting Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses. PROBLEM SOLUTION The air conditioner does not work at all. • Check power status and then operate the air conditioner again. • Plug in or switch on the circ...

English-36 Carefully follow the precautions listed below because they are essential to guarantee the safety of the equipment. • Always disconnect the air conditioner from the power supply before servicing it or accessing its internal components.• Verify that installation and testing operations are p...

English-37 In ST aLL aTIOn 07 Installing the unit IMPORTANT: When installing the unit, always remember to connect first the refrigerant tubes, then the electrical lines. Always disassemble the electric lines before the refrigerant tubes.  Upon receipt, inspect the product to verify that it has not ...

English-38 Choosing the installation location Outdoor Unit  Where it is not exposed to strong wind  Well ventilated and dustless places  Where possible keep out of sunlight and rain  Where neighbors are not annoyed by operation sound or hot air  Solid wall or support that prevents vibration and...

English-39 In ST aLL aTIOn 07 Space Requirements for Outdoor Unit When installing 1 outdoor unit 30 0 or m or e  When the air outlet is opposite the wall 15 00 o r m or e  When the air outlet is towards the wall 30 0 or m or e 150 or more 600 or more  When 3 sides of the outdoor unit are blocked ...

English-40 (Unit : mm)  When the upper part of the outdoor unit and the air outlet is opposite the wall  When the walls are blocking front and the rear side of the outdoor units  When front and rear side of the outdoor unit is towards the wall 50 0 or m or e 300 or more 50 0 or m or e 300 or more...

English-41 Installat Ion 07 accessories The following accessories are supplied with the air conditioner: • The number of each accessory is indicated in parentheses. Accessories in the indoor unit case Accessories in the outdoor unit case Installation Plate (1)  09/12  (04 frame) Installation Pla...

English-42 Fixing the installation plate You can select the direction of the drain hose depending on where you want to install the indoor unit. Therefore before fixing the installation plate to a wall or a window frame, you must determine the position of the 65 mm hole through which the cable, pipe ...

English-43 In ST aLL aTIOn 07 • Search for other spots if there are less than two studs, or the distance between the studs are different from the plate hanger. • Fix the installation plate without inclining to one side. • Make sure that a wall can withstand the weight of the product. If you install ...

English-45 In ST aLL aTIOn 07 Connecting the assembly cable Cable specification Model Power cable (Outdoor Unit) Interconnection cable (Indoor-Outdoor) Type GL  09/12   18/24   30  3G, 1.0 mm², H07RN-F(**09/12**) 3G, 2.5 mm², H07RN-F(**18/24**) 3G, 4.0 mm², H07RN-F(**30**) Power Supply 3...

English-47 In ST aLL aTIOn 07 10. Connect the grounding conductor to the grounding terminals. 11. Close the terminal board cover by tightening the screw carefully. • In Russia and Europe, consult with the supply authority to determine the supply system impedance before installation. • Connect the wi...

English-48 Installing and connecting the assembly pipe of the indoor unit 1. Cut out the appropriate knock-out piece (A, B, C) on the rear of the indoor unit unless you connect the pipe directly from the rear. 2. Smooth the cut edges. 3. Remove the protection caps of the pipes and connect the assemb...

English-49 In ST aLL aTIOn 07 Evacuating the indoor unit • The remaining air in the Refrigeration cycle, which contains moisture, may cause malfunction on the compressor. • Always contact the service center or a professional installation agency for product installation. • To prevent dirt or foreign ...

English-51 In ST aLL aTIOn 07 Installing and connecting the drain hose of the indoor unit The drain hose must NOT slant upwards. The end of the drain hose must NOT be placed under water. Keep a clearance of at least 5 cm between the end of the drain hose and the ground. When installing the drain hos...

English-53 In ST aLL aTIOn 07 Installing and connecting the drain hose of the outdoor unit While heating, ice may accumulate. During the process of defrosting, check if condensation draining is adequate. For adequate draining, do the following. 1. Insert the drain plug into the drain hole on the und...

English-54 Evacuating the connected pipes 1. Connect each assembly pipe to the appropriate valve on the outdoor unit and tighten the flare nut. 2. Tighten the flare nut first with your hands, and then with a torque wrench, applying the following torque. Outdoor unit Indoor unit Gas pipe side Liquid ...

English-55 In ST aLL aTIOn 07 R-410A is a mixed type of refrigerant. It is necessary for recharging under conditions of liquid. When recharging refrigerant from the refrigerant cylinder to the equipment, follow the instructions below. 1. Before recharging, check whether the cylinder has a siphon or ...

English-56 Performing the gas leak tests C D A B Make sure to check for gas leaks before completing the installation process (connecting the assembly pipe and hose between indoor unit and outdoor unit, insulating the cables, hose and pipe, and fixing the indoor unit to the installation plate). To ch...

English-57 In ST aLL aTIOn 07 Fixing the indoor unit in place Insulation Pipes 'X' mm Rubber leg 'Y ' m m Perform the following work on the area where gas leak test was done priory. After checking for gas leaks in the system, insulate the pipe, hose and cables. Then place the indoor unit on the inst...

English-58 Smart Install mode This model supports Smart Install mode which checks installation status to find out if there is any problems with any of the functions . Execute Smart Install mode after installation . 1 . Check the installation status of the air conditioner . 1) Check the power supply,...

English-61 In ST aLL aTIOn 07 How to connect your extended power cables Items to prepare (compressor and insulation tape should be prepared by an installation technician.) 1. As shown in the figure, peel off the shields from the rubber/wire of the power cable. - Peel off 20 mm of the wire shields of...

DB68-05206A-00 QUESTIONS OR COMMENTS? COUNTRY CALL OR VISIT US ONLINE AT AUSTRALIA 1300 362 603 www.samsung.com/au/support A3050 Australia_IB&IM_DB68-05206A_EN.indd 62 2014/12/29 19:07:47

AR ✴✴ FSSSBWK Series AR ✴✴ FSSSCUR Series Air Conditioner user & installation manual imagine the possibilities Thank you for purchasing this Samsung product. To receive more complete service, please register your product at www.samsung.com/register This manual is made with 100% recycled paper. A...