Samsung AW126JB/127JB - User Manual
Samsung AW126JB/127JB Air Conditioner – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – -2-2 Replacing and refilling the refrigerant oil; Samsung Electronics
- Page 3 – -3 Disassembly and Reassembly Procedure; Part name
- Page 4 – Disassembly and Reassembly; Frame Up
- Page 5 – Cond Casing
4. Disassembly and Reassembly
4-1 Compressor Replacement Flow Chart
Samsung Electronics
4-1
Locate cause of defect
Release refrigerant
Disconnect electrical wiring
from compressor
Cut refrigerant lines
from compressor
Plug disconnected lines
Replace compressor
Inspect electrical
wiring for defects,
and terminals for
correct and secure
connections
Solder discharge line
Corrective action
Check refrigerant oil level
Add oil as necessary
Solder suction line
Use nitrogen gas
Perform soldering function
Fill system with nitrogen gas
Check for leakage
Recharge system
Recharge system
Evacuate system
Release nitrogen gas?
Problem?
Low oil level?
N
Y
Y
N
N
Y
Leakage?
AW126JB-1 6/27/98 10:38 AM Page 11
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
4-2 Checking the oil 4-2-1 Oil quality 4-2-2 Replacing and refilling the refrigerant oil 1. Replacing the compressor - Do not fill the system with oil as the compressor is already charged.2. Replacing the condenser - Refill 50cc.3. Replacing the evaporator - Refill 50cc.4. Replacing the refrigerant ...
4-3 Disassembly and Reassembly Procedure Samsung Electronics 4-3 Stop operating the air conditioner, and pull out the power cord before repair. No. Part name Procedures Remarks ① ➁ ➂ Ass'y Grill Ass'y Cabinet Ass'y Control 1. Pull the panel front and remove the screw on the grille 2. Hold the lower ...
Disassembly and Reassembly 4-4 Samsung Electronics No. Part name Procedures Remarks ➃ ➄ Frame Up Case Cond &Propeller Fan 1. Remove 10 screws on the Frame Up. 1. Remove two screws on the bottom side, and 5 screws on the case cond. 2. Remove the nut flange, and remove the propellr fan AW126JB-2 6...
