SABA HP-4 - User Manual
SABA HP-4 Range – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – spacing of 6” from all sides.; Air Supply and ventilation:
- Page 3 – PROPANE GAS CONVERSION
- Page 4 – gas is supplied to the equipment.; equipment to “burn in” for at least; Pilot Flame Height Adjustment:
- Page 5 – DO NOT clean equipment with steel wool.; Allow the equipment to cool completely before cleaning.
Gas Countertop Hot Plates
SABA
3390 Enterprise Ave., Hayward, CA 94545
Toll Free: +1 (844) 422-8900 Telephone: +1 (510) 293-0189 Fax: +1 (510) 293-0199
This manual contains important information regarding
your purchased equipment. Please read the manual thoroughly
prior to equipment set-up, operation and maintenance.
Failure to comply with regular maintenance guidelines
outlined in this manual may void the warranty. Please keep it for future
reference after installation and do not throw it away!
This is a universal installation and operation instruction book which
would apply to different models.
PLEASE READ!!!
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
WARNINGS • Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other equipment. • Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. • Read the installation and maintenance instructions thorou...
• The area in front and around the equipment must be kept clear to avoid any obstruction of the flow of combustion and ventilation air. • Adequate clearance must be maintained at all times in front of and at the sides of the equipment for servicing and proper ventilation. Pressure Regulator: • All c...
LIGHTING THE PILOT: The manifold units are equipped with standing pilots and each should be lit immediately after the gas is supplied to the equipment. 1. Before attempting to light the pilots, turn off the main gas valve to the equipment and wait 5 minutes to clear the gas. 2. Turn off all gas cont...
