Ryobi RY08570- User Manual

6 SYMBOLS SERVICE Servicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we suggest you return the product to your nearest AUTHORIZED SERVICE CENTER for repair. When servic- ing, use only identical replacement parts. WARNING: SAVE TH...

7 Fig. 1 PRODUCT SPECIFICATIONS Weight ..................................................................................................................................................................... 11.75 lbs.Engine displacement ....................................................................

9 NOZZLE THROTTLE CABLE WARNING: Disconnect the spark plug wire before assembling parts. Failure to do so could result in possible serious personal injury. ASSEMBLING THE BLOWER TUBES See Figures 2 - 4. �� n Assemble the elbow tube onto blower by aligning raised locking tabs on blower unit with the ...

10 ASSEMBLY CAUTION: Make all adjustments to the harness straps before start-ing the blower to avoid the possibility of injury. ADJUSTING HARNESS AND WAIST STRAPS Straps should be adjusted to a comfortable position before starting the blower. To adjust harness strap assembly: n Blower should be in o...

13 WARNING: When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dus...

14 MAINTENANCE SPARK ARRESTOR The muffler is equipped with a spark arrestor screen inside muffler body. After extended use the screen can become dirty and the screen may need to be replaced by an autho-rized servicing dealer. WARNING: To avoid a fire hazard, never run the blower without the spark ar...

15 TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER. PROBLEM CAUSE REMEDY Engine fails to start. No fuel in tank.Spark plug shorted or fouled.Spark plug is broken (cracked porcelain or electrodes broken).Ignition lead wire shorted, broken, or disc...

16 WARRANTY LIMITED WARRANTY STATEMENT Ryobi Technologies, Inc. warrants to the original retail purchaser that this Ryobi Technologies, Inc. product is free from defect in material and workmanship and agrees to repair or replace, at Ryobi Technologies, Inc.’s discretion, any defective product free o...

17 RYOBI TECHNOLOGIES, INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSION CONTROL SYSTEMS NON-ROAD AND SMALL OFF-ROAD ENGINES The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Ryobi Technologies, Inc. are pleased to explain the Emission Control System ...

18 EMISSIONS MAINTENANCE SCHEDULE AND WARRANTED PARTS LIST Emissions Parts Inspect Before Clean Every Replace Clean Every Replace Every Each Use 5 Hours Every 25 Hours 25 Hours 50 Hours or Yearly or Yearly CATALYTIC MUFFLER ASSEMBLY ......................................................................

OPERATOR’S MANUAL BACKPACK BLOWER RY08570 983000-699 3-05 WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. CALIFORNIA PROPOSITION 65 • SERVICE Now that you have purchased your tool, should a ...