Ryobi D45CK- Manual

6 WARNING : WARNING : To avoid serious personal injury, do not attempt to use this product until you read thoroughly and understand com-pletely the operator’s manual. Save this operator’s manual and review frequently for continuing safe operation and instructing others who may use this product. SERV...

7 DOUBLE INSULATION Double insulation is a concept in safety in electric power tools, which eliminates the need for the usual three-wire grounded power cord. All exposed metal parts are isolated from the internal metal motor components with protecting insulation. Double insulated tools do not need t...

8 KNOW YOUR DRILL-DRIVER See Figure 1. Before attempting to operate your drill-driver, familiarize yourself with all operating features and safety require-ments. WARNING: Carefully read through this entire operator's manual before using your new drill-driver. Pay close attention to the Safety Rules,...

9 ® UNL OC K WARNING: If any parts are missing, do not operate your drill-driver until the missing parts are replaced. Failure to do so could result in possible serious personal injury. APPLICATIONS (Use only for the purpose listed below) n Drilling in wood. n Drilling in ceramics, plastics, fibergl...

10 UN LO CK ® UNL OC K FORWARD SELECTOR Fig. 3 REVERSE This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to t...

11 ADJUSTABLE TORQUE CLUTCH Your drill is equipped with an adjustable torque clutch for driving different types of screws into different materials. The proper setting depends on the type of material and the size of screw you are using. TO ADJUST TORQUE n Identify the twenty four torque indicator set...

12 UNL OC K WARNING: Be prepared for binding or bit breakthrough. When these situations occur, drill has a tendency to grab and kick opposite to the direction of rotation and could cause loss of control when breaking through material. If not prepared, this loss of control can result in possible seri...

13 UN L OC K CHUCK REMOVAL See Figures 10, 11, and 12. Whenever necessary to remove the chuck for replace-ment, etc. use the following procedure for chuck re-moval: n Unplug your drill. n Rotate torque adjusting ring to the maximum torque setting. WARNING: Failure to unplug your drill could result i...

14 Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accel-erated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, commutators, etc. Consequently, we do not recommended using t...

15 RYOBI 3/8 in. (10 mm) DRILL-DRIVER – MODEL NO. D45CK The model number will be found on a plate attached to the motor housing. Always mention the model number in all correspondence regarding your DRILL-DRIVER or when ordering parts. SEE BACK PAGE FOR PARTS ORDERING INSTRUCTIONS NOTE: The assembly ...

983000-473 3 -04 • SERVICE Now that you have purchased your tool, should a need ever exist for repair parts or service, simply contact your nearest Ryobi Authorized Service Center. Be sure to provide all pertinent facts when you call or visit. Please call 1-800-525-2579 for your nearest Ryobi Author...