Ryobi 2075r- Manual

SAFETY WARNINGS 5 • Keep all bystanders, especially children and pets, at least 30 feet (9.1 m) away from the unit during operation. • Do not operate the engine faster than the speed necessary to cut, trim or edge. Do not run the engine at high speed when not cutting. • Always stop the engine when c...

ASSEMBLY INSTRUCTIONS 7 INSTALLING AND ADJUSTING THELOOP HANDLE If the loop handle is not assembled on thismodel, use the following instructions:1. Place the loop handle and bottom handle clamp on the boom shaft (Fig. 1). 2. Install, one at a time , the four (4) screws and four (4) hex nuts with a P...

8 OIL AND FUEL INFORMATION Old or improperly mixed fuel are usually the main reasons for the unit not runningproperly. Be sure to use fresh, clean fuel andfollow the instructions carefully for the properfuel/oil mixture. NOTE: Alcohol-blended fuel absorbs moisture(water). As little as 1% moisture in...

9 OPERATING INSTRUCTIONS Fig. 6 1. MIX OIL WITH GAS AND FILL FUEL TANKWITH FUEL/OIL MIXTURE per instructions on page 8. 2. Put the IGNITION SWITCH IN THE “ON” POSITION (Fig. 5). 3. FULLY PRESS AND RELEASE THE PRIMERBULB 5 TO 7 TIMES. FUEL SHOULD BEVISIBLE IN THE BULB (Fig. 6). 4. PLACE THE CHOKE LEV...

10 OPERATING INSTRUCTIONS OPERATING THE CLICK-LINK SYSTEM This unit is equipped with a Click-Link ® System, which enables optional attachments to beinstalled on the unit. The optional attachmentsare: Blower/Vacuum. . . . . . . . . . . . . . . . . . . . . BV720rCultivator . . . . . . . . . . . . . . ...

11 OPERATING INSTRUCTIONS CAUTION: Do not remove or alter the line cutting blade assembly.Excessive line length will cause clutch to overheat and may result in serious personal injury. Fig. 12 Each time the head is bumped, about 1 inch(25.4 mm) of trimming line is released. A blade in the string gua...

MAINTENANCE AND REPAIR INSTRUCTIONS 14 3. Wash the filter in detergent and water (Fig. 26). Rinse the filter thoroughly and allow it to dry. Fig. 26 Air Filter Fig. 24 2. Remove the air filter (Fig. 25). Fig. 25 AIR FILTER MAINTENANCE CLEAN AND RE-OIL THE AIR FILTER EVERY10 HOURS OF OPERATION. Your ...

MAINTENANCE AND REPAIR INSTRUCTIONS 15 6. Reinstall the filter (Fig. 25) and air filter cover. NOTE: If the unit is operated without the carburetor/air filter cover assembled,you will VOID the warranty. The condition of the air filter is important to theoperation of the unit. A dirty air filter will...

16 0.025 inch (0.655 mm) CAUTION: Replace a cracked, fouled or dirty spark plug. Do not sand blast,scrape, or clean electrodes becausethe engine could be damaged by gritentering the cylinder. REPLACING THE SPARK PLUG Use a Champion RCJ-6Y spark plug (or equivalent).Correct air gap is 0.025 in. (0.65...

17 TROUBLESHOOTING If further assistance is required, contact your authorized service dealer. PROBLEM CAUSE ACTION Engine will not start Fouled spark plug Engine will not idle Engine will not accelerate Engine lacks power orstalls when cutting Cutting head will notadvance line Ignition switch is “OF...

18 SPECIFICATIONS DRIVE SHAFT & CUTTING HEAD Drive Shaft Housing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Aluminum Tube (Click-Link)Throttle Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Finger-Tip Trigger...

RYOBI OUTDOOR PRODUCTS warrants each newRYOBI Product for two (2) years according to thefollowing terms. This warranty extends to the original retail purchaseronly and commences on the date of original retailpurchase. Any part of the RYOBI Product manufactured orsupplied by RYOBI and found in the re...