Roper G12-436 - Manual

Roper G12-436

Roper G12-436 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
Page: / 27

Table of Contents:

  • Page 2 – Good Practice; Plumbing; Separate Pump and Drive Assemblies; Driveline Guards; Check Alignment of Pump to Driveline; Parallel; Mounting Base; Roper Pumps’ Close Coupled Drives
  • Page 3 – WARNING
  • Page 5 – Figure B
  • Page 6 – RECOMMENDED TOOL LIST
  • Page 7 – INSTRUCTIONS FOR PUMP DISASSEMBLY
  • Page 9 – INSTRUCTIONS FOR PUMP ASSEMBLY; DO NOT
  • Page 13 – INSTRUCTIONS FOR PUMP ASSEMBLY,; REDUCTION; ALIGNING GHB PINION SHAFT HEIGHT
  • Page 16 – GEAR REDUCTION RATIOS AND CAPABILITIES
  • Page 17 – LIST
  • Page 19 – Gear Reduction Assembly only
  • Page 20 – Type BHB Hydraulic Drive Bracket Assembly only
  • Page 23 – FigFigure; HYDRAULIC DRIVE COUPLING ASSEMBLY
Loading the manual

G12-436
04/08/04

®

3611- 4722 GHB and BHB

Supplement to G12-209

OWNERS MANUAL

SAFETY INSTRUCTIONS

This is an industrial component. Only a qualified systems integrator should be allowed to
design it into a system. The integrator must determine proper plumbing, mounting, driveline
and guard components.

Improper installation or use could lead to a serious, even fatal, accident. The system
integrator must communicate all safe operation procedures to the end user(s).

Before operation, fully understand and follow the instructions shown in this manual and any
instructions communicated by the system integrator. No one should be allowed to operate or
maintain this pump who has not been fully trained to work safely according to the
configuration of the pump system and in accordance with all applicable government and
industry regulations.

Roper Pump Company

P.O. Box 269

Commerce, GA 30529 USA

Telephone: (706) 335-5551

TeleFAX: (706) 335-5490

Email:

[email protected]

www.roperpumps.com

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Good Practice; Plumbing; Separate Pump and Drive Assemblies; Driveline Guards; Check Alignment of Pump to Driveline; Parallel; Mounting Base; Roper Pumps’ Close Coupled Drives

Good Practice NOTE: These are general guidelines and do not cover all possible situations. It is the responsibility of the system integrator to apply this product properly. Plumbing 1. The inlet pipe should be as short and straight as possible to minimize suction pressure losses. Excessive restricti...

Page 3 - WARNING

WARNING Operating without guards could result in serious injury or death. Machinery in operation can grab, crush, cut, mangle and dismember. Do not operate without adequate guards in place. 3

Page 5 - Figure B

Other Roper Models