Rolls PM351 - Manual
Rolls PM351 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – This symbol indicates that there are; WARNING; pressure levels before hearing damage occurs.; avoid or damage may occur
- Page 3 – DESCRIPTION; NOTE: When in MONO mode, the ring of the; SCHEMATIC
- Page 4 – OPERATION; any voltage greater than 16 VDC will damage the unit.; GROUND LIFT; CONNECTION
Owners Manual
LIMITED
W
ARRANTY
This product is warranted to the original consumer purchaser to be
free from defects in materials and workmanship under normal installation, use
and service for a period of one (1) year from the date of purchase as shown on
the purchaser
’s receipt.
The obligation of Rolls Corporation under this warranty shall be
limited to repair or replacement (at our option), during the warranty period
of any part which proves defective in material or workmanship under normal
installation, use and service, provided the product is returned to Rolls Corpora-
tion,
TRANSPOR
TA
TION CHARGES PREP
AID. Products returned to us or to
an authorized Service Center must be accompanied by a copy of the purchase
receipt. In the absence of such purchase receipt, the warranty period shall be one
(1) year from the date of manufacture.
This warranty shall be invalid if the product is damaged as a result of
defacement, misuse, abuse, neglect, accident, destruction or alteration of the se-
rial number
, improper electrical voltages or currents, repair
, alteration or mainte-
nance by any person or party other than our own service facility or an authorized
Service Center
, or any use violative of instructions furnished by us.
This one-year warranty is in lieu of all expressed warranties,
obligations or liabilities.
ANY
IMPLIED
W
ARRANTIES, OBLIGA
TIONS,
OR LIABILITIES, INCLUDING BUT
NOT
LIMITED
TO
THE IMPLIED
W
ARRANTIES OF MERCHANT
ABILITY
AND FITNESS FOR
A
P
AR
TICU-
LAR PURPOSE, SHALL
BE LIMITED IN DURA
TION
TO
THE ONE
YEAR
DURA
TION OF
THIS
WRITTEN LIMITED
W
ARRANTY
. Some states do not
allow limitations on how long an implied warranty lasts, so the above limitation
may not apply to you.
IN NO EVENT
SHALL
WE BE LIABLE FOR
ANY
SPECIAL,
INCIDENT
AL
OR CONSEQUENTIAL
DAMAGES FOR BREACH OF
THIS
OR
ANY
OTHER
W
ARRANTY
, EXPRESSED
OR
IMPLIED,
WHA
TSOEVER.
Some states do not allow the exclusion or limitation of special, incidental or con-
sequential damages so the above limitation or exclusion may not apply to you.
This warranty gives you specifi
c legal rights, and you may also have other rights
which vary from state to state.
PM351
Personal Monitor
Station
PM351 P
ersonal
Monitor Station
The PM350 mixes an XLR mic signal, 1/4 TRS
stereo or mono instrument signal, and a 1/4"
TRS stereo or mono monitor signal together for
headphone monitoring.
• XLR Mic In & P
ass Through
• Stereo or Mono 1/4" Line Input
• "Phantom" powering via the Line In
•
Stereo or mono 1/4" Instrument In with built-in
DI outs
• Switchable ground lift on balanced outputs
• T
wo Headphone Outputs 1/4" and 1/8"
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INTRODUCTION Thank you for your purchase of the PM351 Personal Monitor Station. This unit mixes a microphone signal with a 1/4" Tip-Ring-Sleeve stereo or mono instrument level signal and a 1/4" TRS stereo or mono monitor signal. The Mic Input and Thru jacks have a switchable ground lift, as ...
DESCRIPTION LINE INPUT: 1/4" TRS stereo jack for connection to a line level source such as a mixer monitor/auxiliary output, cassette player output, CD player output etc. ground lift: Header jumper for disconnecting chassis ground from pin 1 of the Mic Input and Mic Thru.MIC THRU: XLR jack paral...
INST. INPUT MIC INPUT MIC THRU LINE INPUT lift gnd OPERATION Make sure the Rolls PS27 12VDC power supply is connected to an active AC outlet, and all audio connections are in place. • Setting the Mono/Stereo jumpers; If the input to the LINE INPUT or INSTRUMENT INPUT is a Tip-Ring-Sleeve stereo sign...
