Roland TD-8KV - Manual
Roland TD-8KV – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – IMPORTANT NOTES; Placement
- Page 5 – Getting Started; Setup Procedure
- Page 6 – About the Mesh Head; Adjusting the Head Tension
- Page 7 – Replacing the Head
- Page 8 – Setting Pads and Pedals
- Page 9 – Specifications
- Page 11 – About the Output Jacks
- Page 12 – Choking; Troubleshooting; Choke play is not possible
- Page 14 – Connect the pads and pedals to the TD-8
- Page 15 – About the Included Cables
- Page 16 – Information
Owner's Manual
Thank you, and congratulations on your choice of the TD-8KV Roland Drum
System.
Before using this unit, carefully read the sections entitled: “USING THE
UNIT SAFELY” (p. 2–3) and “IMPORTANT NOTES” (p. 4). These sections
provide important information concerning the proper operation of the
unit. Additionally, in order to feel assured that you have gained a good
grasp of every feature provided by your new unit, Owner’s manual
should be read in its entirety. The manual should be saved and kept on
hand as a convenient reference.
Copyright © 2001 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any
form without the written permission of ROLAND CORPORATION.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
4 IMPORTANT NOTES 291a In addition to the items listed under “USING THE UNIT SAFELY” on page 2–3, please read and observe the following: Placement 354a • Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it t...
5 Getting Started Check the Contents of the Box ❑ TD-8 (Percussion Sound Module) x 1 ❑ KD-80 (V-Kick Trigger) x 1 ❑ FD-6 (Hi-Hat Control Pedal) x 1 ❑ PD-80R (V-Pad) x 1 ❑ PD-80 (V-Pad) x 3 ❑ CY-12R/C (V-Cymbal) X 2 ❑ PD-7 (Pad) x 1 ❑ Accessory Set x 1 ❑ Connection Cable Set x 1 ❑ Connection Cable (1...
6 These strips are 7.5 mm and 7 mm in length. Use them for adjusting the head tension. 7.5 mm 7 mm About the Mesh Head Adjusting the Head Tension • On the KD-80, PD-80R, and PD-80, adjusting the head tension affects only the head response, and does not change the pitch of the sound, as it would on a...
