Rinnai ORH18MR - User Manual

Page 2 - including local OH&S requirements

Rinnai 2 ORH OIM This appliance must be installed in accordance with:• Manufacturer’s Installation Instructions• Current AS/NZS 3000• Local Regulations and Municipal Building Codes including local OH&S requirements This appliance must be installed, maintained and removed only by an Authorised Pe...

Page 3 - TABLE OF CONTENTS; Warnings and Important Information; Unpacking �� 10

Rinnai 3 ORH OIM TABLE OF CONTENTS Warnings and Important Information 4 About Your Outdoor Radiant Heater 7 Radiant Heating Principles �� 7Features ��...

Page 4 - READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE; REGULATORY / INSTALLATION; appliance�; WARNINGS AND IMPORTANT INFORMATION

Rinnai 4 ORH OIM IMPORTANT READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE . Always comply with the following precautions to avoid dangerous situations and to ensure optimum performance.Failure to carefully read and follow all instructions in this manual can result in equipment malfunction, propert...

Page 6 - MANDATORY INSPECTION PRIOR TO INSTALLATION; A NOTE ON ILLUSTRATIONS; vary slightly from that which is shown in this manual.

Rinnai 6 ORH OIM IMPORTANT MANDATORY INSPECTION PRIOR TO INSTALLATION Immediately report any damage or discrepancies to your appliance supplier. This appliance has been inspected and tested at the time of manufacture and packaging, and was released for transportation with...

Page 7 - IP Rating; ABOUT YOUR OUTDOOR RADIANT HEATER

Rinnai 7 ORH OIM RADIANT HEATING PRINCIPLES Radiant heat is widely regarded as the most comfortable, healthiest and most natural form of outdoor heating available. This heating type is based on the same primary source of heat we know - the warmth of the sun. It ...

Page 8 - GENERAL DESIGN LAYOUT / CARTON CONTENTS

Rinnai 8 ORH OIM GENERAL DESIGN LAYOUT / CARTON CONTENTS The packaging for this appliance should contain: 1. Outdoor Radiant Heater: a. Heater body b. Front radiating surface. 2. 1000mm Flexible power cord with three pin plug (fitted) 3. Operation Indicator Light 4. Adjustable angle mounting br...

Page 9 - heated and the conditions.; DELAY OFF TIMER; INSTALLATION

Rinnai 9 ORH OIM 3� The red operation indicator will flash to indicate the heater is in Standby mode. 4� Point the remote control towards the indicator light area of the heater to operate it. Press “On” button on the remote control to turn on the heater and the heater will begin to radiate infrared ...

Page 10 - REGULATORY REQUIREMENTS; APPROXIMATE HEATING AREA; Heater; Indoor Area Spot Heating; Vertical wall mount; Correct Installation; ALL

Rinnai 10 ORH OIM REGULATORY REQUIREMENTS • The heater must be installed in accordance with the manufacturers installation instructions. • The heater MUST ONLY be installed or removed by an authorised person. • The heater MUST be installed in accordance with AS/NZS 3000 and all other ...

Page 11 - CLEARANCES; Minimum clearances when mounting the heater on; A VERTICAL WALL; Minimum clearances when mounting the heater parallel with; A CEILING; Minimum clearances when mounting the heater at an; ANGLE TO A CEILING; Same both ends

Rinnai 11 ORH OIM CLEARANCES Minimum clearances when mounting the heater on A VERTICAL WALL � Minimum clearances when mounting the heater parallel with A CEILING � Minimum clearances when mounting the heater at an ANGLE TO A CEILING � 1500 Min. 100 Min. 220 Min. 1000 Min. to surfaces (ie table to...

Page 12 - INSTALLATION METHOD; Set the adjustable angle mounting brackets to desired angle:

Rinnai 12 ORH OIM INSTALLATION METHOD 1� Open the packaging and carefully take the heater out and inspect for any damage. 2� Determine the mounting position for the heater, refer to "Approximate Heating Area" on page 10 "Outdoor Radiant Heater Mounting" on page 10 and ...

Page 13 - ELECTRICAL CONNECTIONS; also be provided in accordance with wiring rules.; LOCATION OF ELECTRICAL CONNECTION; Electrical connections or GPOs; MULTIPLE INSTALLATIONS; installer�

Rinnai 13 ORH OIM ELECTRICAL CONNECTIONS WARNING The installation of electrical wiring, power outlets, and switches MUST BE performed by an authorised electrical installer. GPO Connection The heater is provided with a power cord fitted with a 3 pin plug (models ORH15SR, ORH18MR and ORH24LR are fitt...

Page 14 - CLEANING; ALWAYS TURN OFF AND OR ISOLATE THE POWER BEFORE CLEANING.

Rinnai 14 ORH OIM CLEANING WARNING ALWAYS TURN OFF AND OR ISOLATE THE POWER BEFORE CLEANING.NEVER IMMERSE THE APPLIANCE IN WATER. CAUTION Before operating the heater for the first time or after extended periods of non use ensure that the surfaces are clean and free of debris or dust. Once the radiat...

Page 15 - WHAT IS COVERED BY THIS WARRANTY?; WARRANTY

Rinnai Outdoor Radiant Heater Product Warranty NOTICE TO CONSUMERS UNDER AUSTRALIAN CONSUMER LAW Notice to consumers under the Australian Consumer Law:Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major f...

Page 17 - etc�; “Domestic Use”; Use�; “Product”; years

6� EXCLUSIONS No warranties except those implied and that by law cannot be excluded are given by Rinnai in respect of Goods supplied. Where it is lawful to do so, the liability of Rinnai for a breach of a condition or warranty is limited to the repair or replacement of the Goods,...

Page 18 - NOTES

Page 20 - CONTACTS; Rinnai Australia Pty Ltd; National Help Line

Rinnai 20 ORH OIM Issue 2 - November 2019 CONTACTS Rinnai Australia Pty Ltd ABN 74 005 138 769 | AU24752 100 Atlantic Drive, Keysborough, Victoria 3173P.O. Box 460, Braeside, Victoria 3195Tel: (03) 9271 6625Fax: (03) 9271 6622 National Help Line Tel: 1300 555 545* Fax: 1300 555 655 Monday to Frid...

Rinnai ORH18MR - User Manual

Table of Contents:

Summary

Other Rinnai Heaters Models