Ridgid R2720 - Manual

6 SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. Indicates a potentially hazardous situation, which, if not avoided, c...

7 DOUBLE INSULATION Double insulation is a concept in safety in electric power tools, which eliminates the need for the usual three-wire grounded power cord. All exposed metal parts are isolated from the internal metal motor components with protect-ing insulation. Double insulated tools do not need ...

8 PRODUCT SPECIFICATIONS Belt Size ..........................................................3 in. x 21 in.Sanding Surface ............................................... 17.5 sq. in.No Load Speed ........................................800 - 1,500/min. DUST COLLECTION BAG TRACKING KNOB SANDING BELT...

10 WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: A l w a y s w e a r s a f e t y g o g g l e s o r s a f e t y gl a s s e s w i t h s i d e s h i e l d s w h e n op e r a t i n g powe...

11 VARIABLE SPEED See Figure 2. The sander has a variable speed control dial, A (slowest) to F (fastest) , designed to allow operator control of belt speed. To increase belt speed, turn the variable speed control dial to a higher setting. Turn to a lower setting to decrease belt speed. Refer to the ...

13 LOCKING ON THE SANDER See Figure 8. The lock-on feature allows you to lock the switch trigger in the ON position. Locking the switch trigger on allows you to operate the sander for extended periods of time.If you have the lock-on feature engaged during use and the sander is accidentally disconnec...

14 TO ADJUST SANDING BELT TRACKING See Figure 10. n Connect the sander to power supply. n With sander positioned as shown below, pull switch trig-ger and release immediately. NOTE: This position is for adjustments only. Sanding belt should not be in contact with workpiece or any foreign ob-jects whe...

15 WARNING: To prevent the possibility of sawdust or foreign objects being thrown into your face and eyes, never attempt to use the sander without dust bag properly installed. Sawdust or foreign objects being thrown into your face and eyes could result in possible serious injury. DUST BAG See Figure...

16 MAINTENANCE WARNING: When servicing use only identical RIDGID replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, als...

17 TIMING BELT REPLACEMENT See Figures 13 - 14. n Unplug the sander. n Remove dust bag. n Lay belt sander on side as shown. n Remove sanding belt from sander. Follow instructions on page 12 to remove sanding belt. NOTE: Removing sanding belt will simplify the process of installing a new timing belt....

19 WARRANTY Proof of purchase must be presented when requesting war-ranty service. Limited to RIDGID ® hand held and stationary power tools purchased 2/1/04 and after. This product is manufactured by One World Technologies, Inc. The trademark is licensed from RIDGID, Inc. All warranty communications...

20 983000-639 8-05 Customer Service Information: For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call 1-866-539-1710 or visit us onli...