Revolabs uc500 - Manual
Revolabs uc500 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Technical Note
1 |
P a g e
FLX – VoIP Registering with Cisco UC500/CME Series
Date: March 13
th
, 2012
This technical note gives a detailed description on how to register a Revolabs FLX conference phone with
a Cisco UC 500/CME series. On the UC 500/CME series a SIP extension and user has to be created using
the Command Line Interface (CLI). Once that user is created, the FLX can be set up to register with the
UC500/CME series PBX.
To perform the tasks described in this document, the user needs to have administrative rights on the
Cisco UC500/CME. While the steps in this document are not difficult, we recommend that a trained
Cisco administrator should perform them.
The instructions provided here were collected using a Cisco UC560. Other versions of the Cisco
UC500/CME series may differ, though the general procedures are the same.
Configuring Cisco UC500 series PBX for FLX Registration
The configuration of SIP devices on the UC500/CME series is straightforward. The SIP CME feature in IOS
is used to register the FLX as a generic SIP endpoint.
The following IOS CLI commands are needed on the UC500/CME device. Please note that in your setup
the dn numbers and the pool might be different based on other SIP devices you have installed.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
