Revolabs 6000 - Manual
Revolabs 6000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Connecting the Cables; MXP
- Page 4 – Adjust the audio Output Type Level if necessary (recommend +0dB); Return to previous menu and select ECHO CONTROL
- Page 5 – video codec will cause echo.
Revolabs Fusion™ Wireless Microphone System- Tandberg 6000 / 8000 MXP
Setup Guide
N
OTES AND
C
AUTIONS
:
This setup guide will guide you through the steps needed to properly connect a Revolabs
Fusion System to a Tandberg 6000 / 8000 MXP video codec.
1.
Connecting the Cables
2.
Configuring the 6000 / 8000 MXP Video Codec
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion System and/or the video codec may not function properly. Please
read through these instructions completely before proceeding. Contact Revolabs technical
support if you have any questions.
Requirements for connecting systems:
1.
Revolabs Fusion 4 or 8 microphone system
2.
Tandberg 6000 / 8000 MXP video codec
3.
QTY 1 XLR male to XLR male cable
4.
Qty 2 RCA-RCA male cable
5.
Amplified speakers
NOTE:
IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM
T
ANDBERG AND ARE PART OF THE
T
ANDBERG
MXP
A
DMINISTRATOR
’
S
G
UIDE
©
M
AY
2008
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Connecting the Cables C ONNECTING A REVOLABS FUSION TO T ANDBERG 6000 / 8000 MXP VIDEO CODEC 1. Connect a Male RCA-RCA audio cable between the “Conf. In” port on the Fusion and the “VCR 1” port on the 6000 / 8000 MXP. 2. Connect a Male XLR audio cable between the “Mic Conf. Out” port on the Fusion a...
6. Return to previous menu and select OUTPUTS 7. Confirm that Out1 is ON 8. Adjust the audio Output Type Level if necessary (recommend +0dB) 9. Return to previous menu and select ECHO CONTROL 10. Enable MIC 1 Echo Canceller (ON) 11. Return to previous menu and select AUDIO LEVELING (AGC) 12. Turn MI...
NOTE: You must use your Fusion remote control to control the room volume for both the audio and video conference calls. Adjusting the volume in the video codec will cause echo.
