RCA MST65BKR - Manual
RCA MST65BKR – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – NOTE; Tools required
- Page 3 – English; Part 1B – Mounting to the Wall (Concrete); Do not over-tighten these screws and do not release
- Page 4 – Only use the spacers if necessary.; Part 3 – Final Assembly; Do not release the
- Page 5 – Operation and adjustment; Do not release the display
1.
Read these instructions before you begin.
If
you are unsure of any part of the process, contact
a professional contractor or installer for assistance.
Improper installation can result in injury or damage.
2.
The wall or mounting surface must be capable of
supporting the combined weight of the mount and
the display; if not, the structure must be reinforced.
3.
Locate pipes, wires, or any other hazards in the wall
where you wish to install the mount before drilling.
4.
Safety gear and proper tools must be used. Failure
to do so can result in injury or damage.
5.
A minimum of two people are required for
installation. Do not attempt to install this mount
alone under any circumstances.
6.
Follow all instructions and recommendations
regarding adequate ventilation and suitable
locations for mounting your display. Consult the
owner‘s manual for your particular display for more
information.
Warnings
CAUTION:
This wall mount is intended for use only with the
ma ximum weight of 75 kg (165 lbs). Use with heavier
than the ma ximum weights indicated may result in
instability causing possible injur y.
Specifi cations
Display Size:
37” to 65”
Ma ximum Load:
165 lb (75kg)
Mounting Pattern:
800 mm x 500 mm ( 31.5” x 19.7” ) ma x
Tilt Range:
15° down
Profi
le:
1.4”
( 3.5
cm)
fl at panel
solutions
Tilt Wall Mount for LCD, Plasma, and
LED Displays
Instruction Manual
MST65BKR
Fits TVs 37”- 65”
Maximum Load
Capacity – 165 lb (75kg)
Continues on next page...
Pour des instructions
en français, se
reporter à la page 6.
Para obtener
instrucciones en
español, consulte la
página 11.
Box contents
Upper Wall Plate (x1)
Lower Wall Plate (x1)
Left Plastic Side (x1)
Right Plastic Side (x1)
Mount Arm (x2)
Instruction Manual (x1)
Hardware Kit (x1)
Template (x2)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Assembly Assemble the mount by carefully snapping the right and lef t plastic sides onto the upper and lower wall plates, as shown in the illustration (see Fig. 1). Do not force any of the connections as it may result in breakage of the plastic par ts. Installation Part 1A – Mounting to the Wall (...
English 3 Part 1B – Mounting to the Wall (Concrete) IMPORTANT! For safety reasons, the concrete wall must be capable of suppor ting the combined weight of the mount and the display. The manufacturer takes no responsibility for failure caused by walls of insuf fi cient strength. 1. Place the appropri...
4 3. Attach the mount arms to the back of your display using the screws identifi ed in steps 1 and 2 (see Fig. 7): A. If you are using the M6 screws you will also need to use the M6 washers (H). M8 screws do not require washers. B. If you are using the longer screws on a display with a curved or rec...
