RadioShack 32-2057 - Manual

8 The Basics connecting a lamp and headphones listening safely Do not listen at extremely high volume levels. Extended, high-volume listening can lead to permanent hearing loss.To protect your hearing when using headphones, always follow these guidelines to set the listening volume: • Set CUE LEVEL ...

9 The Basics using your mixer 1. Set your output source’s volume to minimum and turn it on. 2. Press POWER to turn on the mixer. 3. Turn on the audio input sources you want to mix. 4. Preset the input signal levels and mix your audio input sources. Refer to the next two sections for details. 5. When...

11 The Basics Notes: • Write down the CH setting for each audio source. Then, when you want to mix that source, you can adjust its volume to that setting. • If it was necessary to set CH 1 to maximum to get a reading of 0 or less on the LED meter, slide CH 1 down to about 8 and adjust MASTER upward ...

13 Beyond the Basics mixing your inputs You can select any two of your connected audio sources and mix them so one or both play through your sound system. Mixing consists of three parts: playing an input source, monitoring a second input source, and switching to a second input source. playing an inp...

14 Beyond the Basics monitoring a second input source Monitoring a second input source requires listening to an input source, finding the desired audio section you want to mix, and adjusting it’s sound level to match the volume of the first input source (the one designated ASSIGN A ). 1. Connect and p...

15 Beyond the Basics using a microphone Your mixer has a set of tone controls for the microphone so you can tailor its high and low frequency sounds. 1. For regular sound, leave MIC TREBLE and MIC BASS set to 0 . 2. Rotate MIC TREBLE toward +10 to increase, or toward –10 to decrease high frequency s...

17 Beyond the Basics frequently asked questions Q - I set up my mixer according to the instructions. Why isn’t it working? A - Make sure you are connected to a “live” AC outlet. - Verify that all sources are securely connected. - Check the fuse and replace it if needed. Q - Why is there no signal fr...

18 Beyond the Basics care Keep the mixer dry; if it gets wet, wipe it dry immediately. Use and store the mixer only in room temperature environments. Handle the mixer carefully; do not drop it. Keep the mixer away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new....

19 Beyond the Basics specifications Input Sensitivity/Impedance: DJ MIC (XLR jack) ..........................1.5 mV, 600 ohms, Balanced/UnbalancedMIC 2 (PHONE jack) .......................1.5 mV, 600 ohms, Balanced/UnbalancedPHONO 1, PHONO 2 ..............................................................

©2004. RadioShack Corporation. All rights reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. Printed in USA 32-2057 07A04 This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one (1) year from the d...