QSC UF-3 - Manual

QSC UF-3

QSC UF-3 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
Page: / 14

Table of Contents:

  • Page 3 – Architecture; UF-3 UNIVERSAL FILTER
  • Page 4 – Operation; , the amplifier in which the; Bypassing the Filtering; Channel 1; Programming the Low-Pass Filter; Figure 2—UF-3 Circuit board jumper and resistor network locations
  • Page 5 – Programming the High-Pass Filter and CD Horn Equalization
  • Page 6 – IV. TYPICAL APPLICATIONS; Subsonic Filter; Use only these three digits to; Figure 5—UF-3 as a subsonic filter
  • Page 7 – CD Horn boost; Subsonic and Ultrasonic Filter; Figure 6—UF-2 as an ultrasonic filter
  • Page 8 – -Way Active Crossover; Steps 2 through 5 configure Channel 1.; Amp; HF Driver; Figure 9—UF-2 as a 2-way active crossover
  • Page 9 – BusCard; Multi-way Crossover System
  • Page 10 – Tools and materials you will need:; Installing the UF-3 on a BusCard; Input card; Figure 11—Location of the input card
  • Page 11 – VI. WARRANTY AND DISCLAIMERS; Disclaimer
Loading the manual

11

UF-3

UF-3

UF-3

UF-3

UF-3

Universal

Universal

Universal

Universal

Universal

Filter

Filter

Filter

Filter

Filter

*TD-004031-00*

*TD-004031-00*

Rev. A

Owner’

s Manual

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Architecture; UF-3 UNIVERSAL FILTER

1 I. DESCRIPTION The UF-3 is an embedded dual-channel universal filter accessory for use with select QSC power amplifiers. Compatible amplifier models and lines,both current and discontinued, include: • All PLX, two-channel CX, and two-channel DCA models (with a BSC-3 or BSC-5 BusCard installed) • A...

Page 4 - Operation; , the amplifier in which the; Bypassing the Filtering; Channel 1; Programming the Low-Pass Filter; Figure 2—UF-3 Circuit board jumper and resistor network locations

2 III. PROGRAMMING THE UF-3 The UF-3 circuit board has six 3-pin headers and four SIP resistor network sockets (see Figure 2). All are used for programming the module. Thecircuitry for the two channels is identical, so the headers and sockets are divided between them: those designated by a three-dig...

Page 5 - Programming the High-Pass Filter and CD Horn Equalization

3 Programming the High-Pass Filter and CD Horn Equalization To use either the high-pass filter or the constant-directivity horn equalization, or both, set the jumper onJx02 across pins 2 and 3, which are the lower two pins on their header. If, however, you do not wish touse either one and want to by...

Other QSC Models

All QSC Other