QA-Deluxe QA-Deluxe 3300W - User Manual
QA-Deluxe QA-Deluxe 3300W Fan – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WHERE TO LOCATE
- Page 3 – INSTALLATION
- Page 4 – Installing Damper Box
- Page 8 – REQUIRED VENTING AREA
Installation Instructions
READ AND SAVE THESE INSTRUCTIONS
SAFTEY INFORMATION
Read the following safety information before installing this Whole House Fan. Failure to follow these
instructions could result in personal injury, death or property damage.
WARNING
- TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
Use this unit only in the manner intended by the manufacturer. If you have questions, contact the
manufacturer.
Before installing, servicing, or cleaning the unit, main electrical disconnect switch must be in the OFF
position and install a lockout tag.
CAUTION
- FOR GENERAL VENILATING USE ONLY. NOT DESIGNED TO EXHAUST HAZARDOUS
OR EXPLOSIVE MATERIALS AND VAPORS.
WARNING
- TO REDUCE THE RISK OF FIRE, ELETRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
Qualified person(s) in accordance with all applicable codes and standards, including fire-rated
construction, must do installation work and electrical wiring.
Contact Us
(888) 398-5267
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Whole House Fans are designed to pull in fresh, cool air from the outside through open windows in your home. Hot air that is in the home is pulled up through the fan and into the attic, and then exhausted through vents in the roof, under eaves, soffits or gables. STEP 1: SELECT THE INSTALLATION SI...
3 1. **Warning: Cut out drywall to the dimensions of the Grille and not to the dimensions of the metal damper box. From inside the attic at your predetermined location drill two holes at the edge of the joist approximately 12 inches apart. From inside the home use the two newly drilled holes as ...
4 3. Installing Damper Box Attach the supplied brackets to the joist as shown in the picture below using the 1 ½” hex screws. Place the damper box on top of the brackets as shown in the picture below and screw one side of the damper box to the joist. The brackets will support the weight of the d...
