PROAIRA HTR65 - User Manual

PROAIRA HTR65

PROAIRA HTR65 Heater – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
Page: / 1
Loading the manual

Page 1 (cover)

Page 2 (inside)

Page 3 (inside)

Page 4 (back)

Black border shows

page size and should

not print

Black border shows

page size and should

not print

11.0"

8.50"

FRONT

BACK

FRONT

FRONT

BACK

FRONT

HEATER OPERATION:

Always operate the heater in

the upright position following all instructions and

recommendations listed in this manual.

HEATER LOCATION:

Place the heater in the area of

the room that is coldest.

HEATER CONNECTION:

Plug heater directly into 120

volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in

outlet. A loose connection may cause overheating and

damage to the plug or heater. NOTE: To prevent

overloading a circuit, do not plug the heater into a

circuit that is servicing other electrical needs.

TURNING HEATER ON:

To start the heater, turn the

On/Off Switch from the OFF position to the ON

position. Then rotate the Thermostat Control clockwise

to the HIGH THERMOSTAT position as described

below. (During the heaters initial use, you may

experience a slight odor or smoking. This is the result

of the heating element lubrication “burning off”. This is

normal and will go away after a few minutes of use.)

POWER LEVEL SWITCH:

This heater has two heat

settings: 750 and 1500 watts. Use the higher setting

(1500 WATT) to raise the room temperature quickly.

When the desired temperature is reached use the

lower 750 WATT setting. It is usually sufficient to

maintain a comfortable temperature.

SETTING THERMOSTAT:

After heater has been turned

on and the room has reached the desired temperature,

slowly rotate the thermostat knob counter-clockwise

until the heater shuts off (you should hear a faint “click”).

By leaving the thermostat at this setting it will

automatically maintain this temperature. To lower

temperature, rotate the knob further counter-clockwise

(towards the LOW position). To raise the temperature,

rotate the thermostat knob clockwise (towards the

HIGH position).

TURNING OFF:

Turn the On/Off Switch to the OFF

position before unplugging or plugging in the heater.

Heater should be unplugged when not in use.

POWER INDICATOR LIGHT:

The Power Indicator

Light will illuminate when the heater is turned on.

ALARM INDICATOR:

The Alarm Indicator will

illuminate when the heater has overheated. If light is

illuminated immediately turn the On/Off switch to the

OFF position then unplug the unit. Follow instructions

in the Important Safety Features section below.

ASSEMBLY INSTRUCTIONS:

This heater

is packaged with the legs unassembled.

The legs must be attached before

operating the heater.

Please notice the arrow

on each base leg.

It shows the installation

direction to the

front of the heater.

1. Insert the protrusions on the leg into the notches

on the bottom of the heater.

Power Indicator Light

Power

Level

On/Off

Switch

Thermostat

Control

Alarm

Indicator

Save these Instructions

IMPORTANT SAFETY FEATURES

The Power Indicator Light, located above the On/Off

Switch, lights whenever the heater is turned on. The

heater is equipped with an automatic overheat

protection device located inside the body of the

heater. If the heater grille is obstructed, or if the

heater gets too hot for any reason, the automatic

overheat protection device will turn the heater off. To

reset the heater, simply turn power off and unplug the

heater for 10 minutes until it cools down and restarts.

Be sure that the heater is on a smooth level surface

with no obstructions.

CARE AND MAINTENANCE

CLEANING

: CAUTION-Before cleaning the heater be

sure to disconnect power cord and allow the heater to

cool completely. This heater should be cleaned at least

once a year to maintain proper performance. Clean

the outside surface with a clean damp cloth. Do not

use harsh chemical or abrasive cleaners. DO NOT

IMMERSE THE HEATER IN WATER. Allow heater to

dry completely before use.

REPAIR:

DO NOT OPERATE THE HEATER WITHOUT

THE GRILLE IN PLACE. DO NOT USE THE HEATER

IF IT HAS MALFUNCTIONED OR BECOME

DAMAGED IN ANY WAY.

STORAGE:

Keep original carton for storage of the

heater. Coil and tie the power cord to avoid damage

during storage.

WARNING:

SHOCK HAZARD

Use your heater only in dry environments. This heater is not

intended for use in a bathroom, laundry area, or similar

locations, or near sinks, washing machines, swimming pools or

other sources of water. Never locate heater where it may fall

into a bathtub or other water container. Do not use heater

outdoors. Do not use in damp environments such as flooded

basements.

WARNING:

HOT SURFACES

Do not touch body of heater when in use. This heater is hot

when in use, to avoid burns, do not let bare skin touch hot

surfaces. If provided, use handles when moving this heater.

WARNING:

FIRE HAZARD

Heater has hot and arcing or sparking parts inside. Do not use

near combustible materials or flammable gases or sources of

heat. DO NOT USE in areas where gasoline, paint or

flammable materials are used or stored. Keep combustible

materials such as furniture, pillows, bedding, papers, clothes

and curtains at least 3 feet (0.9 m) from the front of the heater

and keep them away from the sides and rear. To prevent a

possible fire, do not block air intakes or exhaust in any manner.

Do not use on soft surfaces, like a bed, where openings may

become blocked. Do not place the heater near a bed because

objects such as pillows or blankets can fall off the bed and be

ignited by the heater. Do not insert or allow foreign objects to

enter any ventilation or exhaust opening as this may cause an

electric shock, fire, or damage the heater.

WARNING:

ELECTRICAL SHOCK HAZARD

Do not use with damaged cord or plug. Use with adequate

electrical system that is up to code.

The supply cord has a polarized plug. As a safety feature this

plug will fit in a polarized outlet only one way. To prevent

electric shock, match wide blade of plug to wide slot, fully

insert plug. If the plug does not fit contact a qualified

electrician.

Do not operate any heater with a damaged cord or plug or after

heater malfunctions, has been dropped or damaged in any

manner. Do not operate heater with a broken heating element

or ceramic cone or any visual imperfections. For repairs

covered under warranty, see warranty statement.

PET OWNERS NOTE:

The health of birds and some small pets are extremely sensitive

to the fumes given off during the initial use of many appliances.

Although these fumes are not harmful to humans, it is

recommended that this heater not be used around birds and

small pets during its initial use until the manufacturing corrosion

coatings burn off.

INTENDED USE:

This product is intended for indoor residential and office use only, not

for industrial or other commercial application. Use only with electrical

wiring that is in good working order and that meets applicable codes

and ordinances. This heater must be plugged in to a 120V AC, 15 Amp.

(or larger) circuit. Do not plug anything additional into the same circuit.

If you have any questions whether your wiring is adequate, consult a

qualified electrician. Risk of fire, overheating, malfunction, property

damage, injury or even death may result if not adhered to.

Use your heater-fan only with a working smoke detector located in the

vicinity of your heater.

While using your heater, you should follow the IMPORTANT

INSTRUCTIONS listed below. As part of those instructions, we have

used the word “

WARNING

” to indicate the level of hazard:

WARNING

indicates a hazard which, if not avoided, could result in

injury or death.

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be

followed to reduce the risk of fire, electric shock and injury to persons,

including the following:

• Read all the instructions before using this heater.

• This heater is hot when in use. To avoid burns, do not let bare skin

touch hot surfaces. Use provided handle when moving this heater.

Keep combustible materials, such as furniture, pillows, bedding,

papers, clothes and curtains at least 3 feet (0.9 meters) from the

front of the heater and keep them away from the sides and rear.

• Do not use heater unattended. Use of extreme caution is necessary

when any heater is used by or near children, invalids, disabled

persons or pets.

• Do not operate the heater with a damaged power cord or after the

heater malfunctions, has been dropped or damaged in any manner.

Return heater to authorized service facility for examination, electrical

or mechanical adjustment or repair.

• Do not use heater outdoors.

• Use your heater only in dry environments. This heater is not intended

for use in a bathroom, laundry area, or similar locations, or near

sinks, washing machines, swimming pools or other sources of water.

Never locate heater where it may fall into a bathtub or other water

container. Do not use in damp environments such as flooded

basements.

• Do not place the heater on a small, unlevel, uneven or any surface

which might allow heater to tip or fall.

• For proper operation, heater should be placed on a smooth,

non-combustible surface. Do not place on rugs, carpet, vinyl flooring

or other plastic surfaces. Not for use outdoors or in wet areas.

• This heater is not designed as a primary heat source.

• Always plug heaters directly into a wall outlet/receptacle. Never use

with an extension cord or relocatable power tap (outlet/power strip).

Always unplug heater when not in use.

• Do not run power cord under carpeting. Do not cover cord with

throw rugs, runners or similar coverings. Arrange cord away from

traffic area where it will not be tripped over.

• To disconnect heater, turn controls off then remove plug from outlet.

• Do not insert or allow foreign objects to enter any ventilation or

exhaust opening as this may cause an electric shock or fire or

damage the heater.

• To prevent a possible fire, do not block air intakes or exhaust in any

manner. Do not use on soft surfaces like a bed, where openings may

become blocked.

• A heater has hot and arcing or sparking parts inside. Do not use it in

areas where gasoline, paint or flammable liquids are used or stored.

• Use this heater only as described in this manual. Any other use not

recommended by the manufacturer may cause fire, electric shock or

injury to persons or property.

SAVE THESE INSTRUCTIONS

LIMITED WARRANTY

A limited warranty is extended to the original purchaser of this heater and Proaira warrants against

malfunction due to defects in material or workmanship for a period of one (1) year from the original

date of purchase (the “Warranty Period”). If such a defect is discovered within the Warranty Period,

Proaira will, at its option, repair or replace the product at no cost after a thorough review of the defect.

Replacements outside of the Warranty Period will require a fee to cover materials, labor, handling and

shipping.

This limited warranty does not apply to defects resulting from misuse or use contrary to the owner’s

manual and safety guidelines, damage caused by an improper voltage, damage caused by use

outdoors, modification, alteration, repair or service of the product by a third party, mishandling,

improper maintenance, commercial use of the product, damages which occur in shipment or are

attributed to acts of God.

This limited warranty does not imply or assume any responsibility for consequential damages that

may result from the use, misuse, or the lack of routine maintenance of this heating appliance. This

limited warranty does not cover claims which do not involve defective material or workmanship.

FAILURE TO PERFORM GENERAL MAINTENANCE WILL VOID THIS LIMITED WARRANTY.

THIS LIMITED WARRANTY IS GIVEN TO THE ORIGINAL PURCHASER IN LIEU OF ALL OTHER

WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES

OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PRODUCT. THE REMEDY PROVIDED

IN THIS LIMITED WARRANTY IS EXCLUSIVE AND IS GRANTED IN LIEU OF ALL OTHER

REMEDIES. IN NO EVENT WILL PROAIRA BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL

DAMAGES.

Some states do not allow the exclusion or limitation of incidental or consequential damages or allow

limitations on how long an implied warranty lasts, so the above limitations or exclusions may not

apply to you. This limited warranty gives you specific legal rights, and you may have other rights that

vary from state to state.

For full details, please contact Proaira Customer Service with proof of purchase.

Customer Service:

Phone: (877) 599-4747

Fax: (877) 600-4747

Email: [email protected]

2. Once inserted, push

base leg towards

heater front until it stops.

Pg. 3

Pg. 4

Pg. 2

Pg. 1

Deluxe Metal

Radiant Heater,1500W

MODEL HTR65

• Safety tip over switch

• Adjustable thermostat

• Safety overheat protection system

• 2 settings

• Stable base

• Alarm indicator light

• Forced fan

BACK

FRONT

FRONT

BACK

FRONT

BACK

3. Use supplied

screws to secure leg.

Repeat steps for

second leg.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other PROAIRA Heaters Models