Page 3 - GENERAL INFORMATION; Controls & Equipment Features
GB 3 GENERAL INFORMATION This instruction book is written for a person with some mechanical ability. Like most service books, not all the steps are described. Steps on how to loosen or tighten fasteners are steps anyone can follow with some mechanical ability. Read and follow these instructions befo...
Page 4 - WARNING; Hazard Symbols and the meanings
GB 4 This manual contains safety information to make you aware of the hazards and risks associated with snow throwers, and how to avoid them. The snow thrower is designed and intended for removal of snow, and should not be used for any other purpose. It is important that you read and understand thes...
Page 5 - Safe Operation Practices for Snowthrowers; Training
GB 5 WARNING: This machine is capable ofto amputating hands and feet and throwing objects. Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or bystanders, or damage to property or equipment. ...
Page 9 - MAINTENANCE CHART; MAINTENANCE; General Recommendations
GB 9 Warm engines will cause condensation in cold weather. To prevent possible freeze--up of recoil starter and engine controls, proceed as follows after each snow removal job. 1. Run the snow thrower a few minutes after throwing snow to prevent freeze--up of the auger/impeller. 2. With engine off, ...
Page 13 - TROUBLE SHOOTING CHART; TROUBLE
GB 13 TROUBLE SHOOTING CHART TROUBLE CAUSE CORRECTION Difficult starting Defective spark plug. Replace spark plug. Water or dirt in fuel system. Use carburetor bowl drain to flush and refill with fresh fuel. Engine runs erratic Blocked fuel line, empty gas tank, or stale gasoline Clean fuel line; ch...
Page 14 - LIMITED WARRANTY; ABOUT YOUR EQUIPMENT WARRANTY
GB 14 BRIGGS & STRATTON POWER PRODUCTS GROUP, LLC EQUIPMENT OWNER WARRANTY POLICY Effective March 1, 2005 replaces all undated Warranties and all Warranties dated before March 1, 2005 Briggs & Stratton Power Products Group, LLC will repair or replace, free of charge, any part(s) of the equip...
Page 16 - otros daños reproductivos.; ADVERTENCIA; Se usa una palabra de señal (PELIGRO, ADVERTENCIA o PRECAUCIÓN); Símbolos de peligro y significados; potenciales y cómo evitarlos.; Símbolos de operación y significados
ES 16 Este manual contiene información de seguridad para avisarle de los peligros y riesgos asociados a las lanzadoras de nieve y cómo evitarlos. La lanzadora de nieve fue diseñada para la finalidad de eliminar nieve, y no debe usarse para ningún otro fin. Es importante que usted lea y comprenda est...
Page 17 - El triángulo; REGLAS PARA OPERACIÓN SEGURA; Capacitación
ES 17 ADVERTENCIA: Es máquina es capaz de amputar manos y pies y arrojar objetos. Lea estas normas de seguridad y respételas estrictamente. El no respetar estas normas podría resultar en pérdida de control de la unidad, lesiones personales graves o muerte para usted o transeúntes, o daños a la propi...
Page 19 - ENSAMBLAJE
E 19 ENSAMBLAJE Lea y siga las instrucciones de ensamble y ajus- te para el quitanieves. Todos los sujetadores están en la bolsa de piezas. No bote ninguna pieza o material hasta que la unidad esté en- samblada. ADVERTENCIA: Antes de hacerle mantenimiento o montarle alguna pieza al quitanieves, desc...
Page 20 - OPERACIÓN
E 20 2. Levante los cortanieves (1) a la altura de- seada. 3. Apriete los sujetadores (2). Cómo preparar el motor NOTA: El motor fue enviado de la fábrica con aceite. Revise el nivel de aceite. Añada aceite según sea necesario. ADVERTENCIA: Siga las instruc- ciones del fabricante del motor en cuanto...
Page 22 - TABLA DE MANTENIMIENTO; RESPONSABILIDADES DEL CLIENTE; MANTENIMIENTO; Recomendaciones generales
E 22 TABLA DE MANTENIMIENTO RESPONSABILIDADES DEL CLIENTE REGISTROS DE SERVICIO Anote las fechas en que se haga el mantenimiento normal. Antes de ca- da uso Prime- ras 2 horas Cada 5 horas Cada 10 horas Cada 25 horas Cada tempo- rada Antes de guar- darlo FECHA DEL SERVICIO Revisar el nivel de aceite...
Page 26 - TABLA DE LOCALIZACIÓN Y REPARACIÓN DE AVERÍAS; PROBLEMA
E 26 TABLA DE LOCALIZACIÓN Y REPARACIÓN DE AVERÍAS PROBLEMA CAUSA CORRECCIÓN Dificultad al arrancar Bujía defectuosa. Cambie la bujía. Agua o suciedad en el sistema de combustible. Use el escurridor de la taza del carburador para enjuagar y volver a llenar el tanque con combustible fresco. El motor ...
Page 27 - GARANTÍA LIMITADA
E 27 BRIGGS & STRATTON POWER PRODUCTS GROUP, LLC PÓLIZA DE GARANTÍA DEL PROPIETARIO DEL EQUIPO En vigor a partir del 1 ° de marzo, 2005 reemplaza todas las garantías sin fecha y todas las garantías fechadas antes del 1 ° de marzo, 2005 Briggs & Stratton Power Products Group, LLC reparará o r...
Page 28 - ACERCA DE LA GARANTÍA DE SU EQUIPO
E 28 ACERCA DE LA GARANTÍA DE SU EQUIPO Recibimos con agrado la reparación bajo garantía y nos disculpamos por la inconveniencia. Cualquier centro de servicio autorizado puede hacer reparacionesbajo garantía. La mayor parte de las reparaciones bajo garantía se atienden de manera rutinaria, pero algu...
Page 37 - REPAIR PARTS
MODEL 96194000200 REPAIR PARTS 37 ENGINE / MOTEUR 25--1 2 3 25--4 25--2 25--3 5 4 20 22 24 11 6 7 8 10 Ref. Drive Page Ref. Auger HousingPage 9 25--2 16 17 18 13 15 12 1 27 27 21
Page 38 - sur le
MODEL 96194000200 REPAIR PARTS 38 ENGINE / MOTEUR Key No. N o sur le schéma Part No. N o de pièce Description 1 198563 CORD, STARTER 2 LH1955P--67510 D TEC ENGINE 3 198539 BOLT, CARRIAGE 5/16--18 4 198540 RETAINER, PUSH 5 198541 NUT 5/16--18 6 198542 PULLEY, ENGINE 7 400026 WASHER 8 850263 WASHER 9 ...
Page 39 - GEAR CASE; Description
MODEL 96194000200 REPAIR PARTS 39 GEAR CASE Key No. Part No. Description Key No. Part No. Description 19 73800400 NUT, HEX LOCK 1/4--20 27 404953 WASHER, FLAT 32 404955 NUT,1/4--20 33 404956 COLLAR,THRUST 34 174684 WASHER, THRUST 35 404957 PIN,SPRING 36 404948 SHAFT, AUGER INPUT (IMPELLER) 37 404944...
Page 40 - WHEELS
MODEL 96194000200 REPAIR PARTS 40 WHEELS 679 678 673 675 678 671 655 650 654 652 653 655 671 673 680 676 677 Ref. Drive Page Key No. Part No. Description 650 199039X008 SHAFT, AXLE 652 198679 SPRKT & HUB 653 198667 SCREW, 1/4--20 x 1.75 654 73800400 NUT, 1/4--20 HEX NYLOCK 655 198680 BEARING, AX...
Page 41 - FRAME
MODEL 96194000200 REPAIR PARTS 41 FRAME 160 162 162 91 91 122 90 168 103 106 105 108 Ref. Engine Page 110 148 149 107 Ref. DrivePage Ref. AugerHousing Page 111 123 123 167
Page 43 - DRIVE
MODEL 96194000200 REPAIR PARTS 43 DRIVE Ref. Wheel Page 229 200 223 225 226 227 234 230 221 Ref.Wheel Page Ref. Shift Yoke Page 206 201 220 218 232 234 229 220 220 218 218 207 215 215 238 238 210 212 213 213 217 213 220 218 236 Ref. Frame Page Ref. WheelPage Ref. WheelPage 208 239
Page 45 - AUGER HOUSING
Page 47 - DISCHARGE CHUTE; Ref. Auger Housing Page
MODEL 96194000200 REPAIR PARTS 47 DISCHARGE CHUTE 597 596 584 599 582 605 602 603 610 601 606 607 607 611 609 600 Ref. Auger Housing Page 600
Page 49 - HANDLE
MODEL 96194000200 REPAIR PARTS 49 HANDLE 720 730 766 739 739 766 731 734 734 733 733 740 741 725 724 724 725 725 726 724 726 727 727 726 728 756 750 751 755 746 746 744 743 763 Ref. Engine Page 760 762 759 745 751 745
Page 51 - CHUTE ROD; Ref. Auger Housing Assy
MODEL 96194000200 REPAIR PARTS 51 CHUTE ROD 856 855 854 855 861 860 863 864 864 867 Ref. Handle Assy 869 852--5 852--11 852--9 852--8 852--3 868 852--13 852--10 852--1 852--2 852--6 870 Ref. Auger Housing Assy 852--7 852--4
Page 53 - SHIFT YOKE
MODEL 96194000200 REPAIR PARTS 53 SHIFT YOKE 796 790 792 801 791 800 814 792 812 813 Key No. Part No. Description 790 198725x479 ROD, SHIFT 791 198727 SCREW, 1/4--20X.75 792 73800400 NUT, 1/4--20 796 198736 KNOB, SLIP 800 198737 LEVER, SPRING 801 198727 SCREW, 1/4--20X.75 812 198732x008 ROD ASSY., S...
Page 54 - HEADLIGHT
MODEL 96194000200 REPAIR PARTS 54 HEADLIGHT 626 Ref. Handle Page 633 632 620 622 623 631 625 624 629 630 634 628 627 621 Key No. Part No. Description 620 404467 HOUSING, HEADLIGHT UPPER 621 406471 HEADLIGHT, ASSY * 622 406465 HOUSING, HEADLIGHT LOWER 623 406472 SCREW, #8X1.75 624 406470 WIRING HARNE...