Page 2 - I. GENERAL OPERATION; SAFETY RULES; SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS
2 • Avoid starting or stopping on a slope. If tires lose trac- tion, disengage the blades and proceed slowly straight down the slope. DO NOT:• Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible. • Do not mow near drop-offs, ditches, or embankments. The ...
Page 3 - WARNING
3 WARNING: In order to prevent ac- ci den tal starting when setting up, trans port ing, ad just ing or making re-pairs, al ways dis con nect spark plug wire and place wire where it can not contact spark plug. WARNING: Do not coast down a hill in neutral, you may lose control of the tractor. WARNING:...
Page 4 - TABLE OF CONTENTS; CUSTOMER RESPONSIBILITIES; PRODUCT SPECIFICATIONS
4 TABLE OF CONTENTS SAFETY RULES ......................................................... 2-3PRODUCT SPECIFICATIONS ....................................... 4CUSTOMER RESPONSIBILITIES ................................. 4ASSEMBLY ................................................................. 6-8OPE...
Page 5 - CONTENTS OF HARDWARE PACK; Steering Wheel
5 CONTENTS OF HARDWARE PACK Steering Wheel Steering Wheel Insert (1) Large Flat Washer Steering Boot SteeringExtensionShaft Steering Wheel Adapter Seat (2) Keys Slope Sheet Key (1) Hex Bolt 1/4-28 x 1-1/4 (1) Locknut 1/4-28 (1) Locknut 1/2-20 (1) Oil Drain Tube (1) Knob (1) Washer 17/32 x 1-3/16 x 1...
Page 6 - ASSEMBLY; TOOLS REQUIRED FOR ASSEMBLY; UNPACK CARTON; HOW TO SET UP YOUR TRACTOR
6 ASSEMBLY TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed.(2) 7/16" wrenches Utility knife (2) 3/4" wrench Tire pres sure gauge PliersWhen right or left hand is mentioned in this man ual, it means when you are in the operating po ...
Page 8 - CHECKLIST; CHECK TIRE PRESSURE
8 ASSEMBLY ✓ CHECKLIST BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PER FOR MANCE AND SATISFACTION FROM THIS QUALITY PROD UCT. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly instructions have been completed. ✓ No remaining loose parts in carton....
Page 9 - OPERATION
9 OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean-ing. DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) OVER TEMP LIGHT KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FOR...
Page 10 - KNOW YOUR TRACTOR
10 OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ATTACHMENT CLUTCH LEVER - Used t...
Page 11 - HOW TO USE YOUR TRACTOR
11 NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “brown ing” of grass. To eliminate this possibility, al-ways stop engine when stopping tractor on grass areas. CAUTION: Always stop tractor com- plete ly, as described above, b...
Page 12 - TO OPERATE ON HILLS; TO TRANSPORT; TOW I N G C A RT S A N D OT H E R AT
12 TO OPERATE ON HILLS WARNING: Do not drive up or down hills with slopes great er than 15° and do not drive across any slope. • Choose the slowest speed before starting up or down hills. • Avoid stopping or changing speed on hills.• If slowing is necessary, move throttle control lever to slower pos...
Page 13 - ADD GASOLINE; BEFORE STARTING THE ENGINE; CHECK ENGINE OIL LEVEL
13 OPERATION TO START ENGINE (See Fig. 7) When starting the engine for the fi rst time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.• Sit on seat in operating position, depress clutch/brake pedal and set parking brake. • Place gear s...
Page 14 - MOWING TIPS; MULCHING MOWING TIPS
14 MOWING TIPS • Mower should be properly leveled for best mowing per- for mance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trim- ming. • Drive so that clippings are discharged onto the area that has b...
Page 15 - MAINTENANCE; LUBRICATION CHART; GENERAL RECOMMENDATIONS; BEFORE EACH USE
15 MAINTENANCE BE FO RE EAC H US E T RAC T 0 R Inspect Muffler/Spark Arrester Lubrication Chart Check Brake Operation Clean Air Filter Change Engine Oil (with oil filter) Replace Air Filter Paper Cartridge Replace Spark Plug Check Battery Level Check Tire Pressure Clean Battery and Terminals FILL IN...
Page 16 - BATTERY; TRACTOR; BRAKE OPERATION
16 01202 MAINTENANCE FIG. 13 FIG. 12 BATTERY Your tractor has a battery charging system which is suf fi cient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.• Keep battery and terminals clean.• Keep battery bolts tight.• Keep small vent hole...
Page 17 - ENGINE
17 MAINTENANCE V-BELTS Check V-belts for deterioration and wear after 100 hours and replace if necessary. The belts are not adjustable. Re place belts if they begin to slip from wear. TRANSAXLE COOLING Keep transaxle free from build-up of dirt and chaff which can restrict cooling. FIG. 15 FIG. 14 • ...
Page 18 - CLEANING
18 MAINTENANCE CLEANING • Clean engine, battery, seat, fi nish, etc. of all foreign matter. • Keep fi nished surfaces and wheels free of all gasoline, oil, etc. • Protect painted surfaces with automotive type wax. We do not recommend using a garden hose or pressure washer to clean your tractor unles...
Page 19 - SERVICE AND ADJUSTMENTS
19 SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral (N) position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP...
Page 20 - TO LEVEL MOWER HOUSING
20 TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 22) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. BELT REMOVAL -• Remove mower from tractor (See “TO REMOVE MOW ER” in this section of this manual). • Work belt off both mandrel pulley...
Page 24 - STORAGE; FUEL SYSTEM; ENGINE OIL; OTHER
24 STORAGE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open fl ame or spark. Allow the engine to cool before stor...
Page 25 - TROUBLESHOOTING POINTS
25 TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine fl ooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air fi lter. 5. Clean...
Page 27 - LIMITED WARRANTY
45 LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materi-als and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, w...
Page 28 - SERVICE; POLICY; WARRANTY; LIMITED WARRANTIES; A. Products Warranted
46 T E C U M S E H ® Issued January 1980Revised January 1991 T E C U M S E H ® SERVICE POLICY WARRANTY LIMITED WARRANTIES FOR NEW PEERLESS GEAR POWER TRAIN COMPONENTS A. Products Warranted Peerless Gear and Machine Division of Tecumseh Products Company (“Tecumseh”), subject to the limitations contai...
Page 29 - SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION
47 15 DEGREES MAX. FOLD ALONG DOTTED LINE THIS IS A 15 DEGREE SLOPE ONLY RIDE UP AND DOWN HILL,NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mowslopes greater...
Page 30 - FOR SERVICE OR REPLACEMENT PARTS:; PARTS AND SERVICE
Your POULAN PRO product has been expertly en gi neered and carefully manu fac tured to rigid quality stan dards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. FOR SERVICE OR REPLACEMENT PARTS: 1. Consult your dealer/place of purc...
