Porter-Cable FCP350 - Manual

Page 2 - GB; ENGLISH

2 Matthew G. PopikVice President of Engineering PORTER ✦✦ CABLE Porter-Cable Corporation4825 Highway 45 NorthJackson, TN 38305 Date of Manufacture:___________________________ Fecha de fabricación:, Date de fabrication: Serial No:______________________________________ Número de serie:, Nombre d'ordre...

Page 3 - GENERAL SAFETY RULES; DANGER: When using pneumatic tools, basic safety precautions; Never use oxygen or other bottled

3 GENERAL SAFETY RULES DANGER: When using pneumatic tools, basic safety precautions should always be followed to reduce the risk of personal injury, includingthe following: READ AND FOLLOW ALL INSTRUCTIONS. There are certain applications for which this tool was designed. Porter-Cablestrongly recomme...

Page 6 - EMPLOYER’S RESPONSIBILITIES; FUNCTIONAL DESCRIPTION; FOREWORD; TECHNICAL SPECIFICATIONS

6 EMPLOYER’S RESPONSIBILITIES DANGER: Employer must enforce compliance with the safety warnings and all other instructions contained in this manual. Keep this manual available for use by all people assigned to use this tool. For personal safety and proper operation of this tool, read and understandt...

Page 7 - PREPARING THE TOOL; DANGER: Do not load fastener strip into magazine backwards.

7 Fig. 19 PREPARING THE TOOL 1. After reading and understanding this entire manual, connect tool to air supply (Fig. 18). DANGER: Never point tool at yourself or others in work area.Always connect tool to air supply before loading fasteners (Fig. 18).Do not load fasteners with trigger or safety depr...

Page 8 - OPERATING INSTRUCTIONS; USING THE TOOL WITH SELECTABLE TRIGGERING OPTIONS; To use the tool in the SINGLE SEQUENTIAL ACTUATION MODE

8 5. Pull the follower (B) Fig. 22, all the way tothe rear of the magazine and release. Thefollower will apply pressure to the strip ofnails to feed it into the driving mechanism. 6. Adjust directional exhaust deflector (A) Fig.2 3 , s o t h a t t h e e x h a u s t a i r b l a s t w i l l b edirecte...

Page 9 - WARNING: Disconnect tool from air supply before performing

9 DANGER: Keep fingers AWAY from trigger when not driving fasteners to avoid accidental firing. Never carry tool with finger on trigger. In “Contact Actuation Mode” tool will fire a fastener if safety is bumped while trigger isdepressed. Never point tool at yourself or others in work area. Never att...

Page 10 - CLEARING A JAMMED FASTENER; WARNING: Disconnect tool from air supply.

10 CLEARING A JAMMED FASTENER 1. WARNING: Disconnect tool from air supply. 2. Remove any remaining fasteners from the nailer. A. Place finger in recess (A) Fig. 28, and depress lever to release follower mechanism. B. With follower release button (A) Fig. 28 depressed, slide follower all the way to t...

Page 11 - MAINTENANCE; CLEAN AND INSPECT DAILY; WARNING: Disconnect tool from air supply before cleaning and; SERVICE AND REPAIRS; TROUBLESHOOTING

11 MAINTENANCE CLEAN AND INSPECT DAILY WARNING: Disconnect tool from air supply before cleaning and inspection. Correct all problems before placing the tool back in use. Wipe tool clean and inspect for wear or damage. Use non-flammablecleaning solutions to wipe exterior of tool only if necessary. DO...

Page 12 - ACCESSORIES

12 PORTER-CABLE LIMITED ONE YEAR WARRANTY Porter-Cable warrants its nailing and stapling tools for a period of one year from the date of originalpurchase. We will repair or replace at our option, any part or parts of the product and accessoriescovered under this warranty which, after examination, pr...

Porter-Cable FCP350 - Manual

Table of Contents:

Summary

Other Porter-Cable Models