Porter-Cable DP350 - Manual

6 DRILL PRESS PARTS Fig. 1 Fig. 1 1 - Drill Press Head and Motor 2 - Column, Base Flange, and Rack 3 - Table 4 - Base Fig. 2 5 - Chuck 6 - Clamp Handle 7 - Pinon Shaft Handles (3) 8 - Table Raising and Lowering Handle 9 - M8x1.25x125mm Carriage Head Screws (2), 8.5mm Flat Washers (2), 8.5mm Lock Was...

7 FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTIONMANUAL. 1. Assemble the column (A) Fig. 3, to the base (B) using the four screws, three of which are shown at (C). Loosenset screw (D) and...

10 10. IMPORTANT: Make certain the spindle taper (Q) Fig. 15, and tapered hole in chuck (R) are clean and free ofany grease, lacquer or rust preventive coatings. NOTE: Household oven cleaner can effectively remove any sub-stance from the spindle and chuck; however, carefullyfollow the manufacturer's...

11 Fig. 18A FLEXIBLE LAMP The flexible lamp operates independently of the drillpress. To turn the lamp “ON” and “OFF” , rotate switch (A) Fig. 18A. To reduce the risk of fire, use 40 watt or less, 120 volt, reflector track type light bulb (notsupplied). A standard household light bulb should not beu...

12 VARIABLE SPEED CONTROL To avoid damaging the drive belts and pulleys, DO NOT turn speed control handles (A) Fig. 24, unless motor is running. The pilot wheel handles (A) areturned clockwise to increase speed and counterclockwiseto decrease speed. The speed range is 500 rpm to 3100rpm. Fig. 24 A A...

13 ADJUSTING SPINDLERETURN SPRING The spindle is automatically returned to its upper mostposition when the handle is released. It is recommendedthat the handle be allowed to slowly return to the topposition after each hole has been drilled in the material.This spring has been properly adjusted at th...

14 INSTALLING ANDREMOVING DRILL BITS DISCONNECT MACHINE FROM POWERSOURCE. 1. Insert smooth end of drill bit (A) Fig. 29, into chuck (B), as far as it will go, and then back the bit out 1/16",or up to the flutes for small bits. 2. Make certain that the drill bit (A) Fig. 29, is centered in the ch...

15 LUBRICATION DISCONNECT MACHINE FROM POWERSOURCE. 1. Remove the six screws (A) Fig. 30 that hold the top cover in place, and remove the top cover. 2. The variable speed pulleys should be oiled weekly with a few drops of light machine oil in the two oil holes(B) Fig. 31, located on top of the varia...

16 Printed in U.S.A. Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin normal use has proven to be defective in workmanship or material, provided that the customer returns the productprepaid to a De...

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set ® , BAMMER ® , B.O.S.S. ® , Builder’s Saw ® , Contractor’s Saw ® , Contractor’s Saw II™, Delta ® , DELTACRAFT ® , DELTAGRAM™, Delta Series 2000™, DURATRONIC™, Emc²™, FLEX ® , Fly...