Page 2 - Trademarks; Copyright; FCC Warning; Revision; Ethernet Over VDSL Converter User's Manual
PLANET Ethernet over VDSL series 2 Trademarks Copyright PLANET Technology Corp. 2001. Contents subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners. FCC Warning This equipment has been tested an...
Page 3 - TABLE OF CONTENTS; INSTALLING AND USING ETHERNET OVER VDSL; VDSL C
EV-401M / EV-401S User's Manual 3 TABLE OF CONTENTS 1. INTRODUCTION........................................................................5 1.1 C HECKLIST ................................................................................5 1.2 I NTRODUCTION T O E THERNET OVER VDSL C ONVERTER ............
Page 4 - This page intentionally left blank!
PLANET Ethernet over VDSL series 4 This page intentionally left blank!
Page 6 - Introduction To Ethernet over VDSL; General Description; With much enough bandwidth, the 10Mbps symmetric
PLANET Ethernet over VDSL series 6 1.2 Introduction To Ethernet over VDSL Converter General Description The converter is a switching architecture with four RJ45 10/100Mbps Fast Ethernet switching ports and one 10Mbps RJ11 symmetric Ethernet over VDSL port (symmetry means 10Mbps upstream and 10Mbps d...
Page 7 - Note: Slave device must connect to Master device through
EV-401M / EV-401S User's Manual 7 central side. If you want to setup one pair of converters for point-to-point connection then one set must be client mode and the other one is master mode. The cable specifications of the connection are listed as following: 10BASE-T, Category 3, 4 or 5 UTP 100BASE-TX...
Page 8 - The converter provides the following key features:; Complies with IEEE802.3 10BASE-T standard
PLANET Ethernet over VDSL series 8 1.3 Key Features The converter provides the following key features: Complies with IEEE802.3 10BASE-T standard Complies with IEEE802.3u 100BASE-TX standard Supports Ethernet over VDSL Two RJ11 connectors for Ethernet over VDSL port, one for LAN connection and one fo...
Page 11 - HARDWARE DESCRIPTION
EV-401M / EV-401S User's Manual 11 2. HARDWARE DESCRIPTION This product series provide 2 RJ-11 ports for voice connection (like telephone) and for network line connection. This product series also provide 4 RJ-45 ports for two different running speed –10Mbps, 100Mbps, in the same converter and autom...
Page 12 - LED indicators
PLANET Ethernet over VDSL series 12 LED indicators SYSTEM LED Steady Green This indicator lights green when the converter is receiving power. PWR Off Not receiving power VDSL LED Steady Green If both ends of the VDSL devices are connected then the LED will blink for a while (in 10 seconds), this is ...
Page 13 - *Note 1: Power off and on the converter to make the mode take; The rear panel of the Converter is shown as below
EV-401M / EV-401S User's Manual 13 Blinking Amber A collision occurs when two stations within a collision domain attempt to transmit data at the same time. Intermittent flashing amber of the collision LED is normal; the contending adapters resolve each collision by means of a wait-then-retransmit al...
Page 15 - Install the Ethernet Over VDSL Converter
EV-401M / EV-401S User's Manual 15 3. INSTALLING AND USING ETHERNET OVER VDSL CONVERTER 3.1 Install the Ethernet Over VDSL Converter The Converter does not require any software configuration. Users can immediately use any feature of this product simply by attached the cables and plug power on. There...
Page 16 - LAN to LAN connection; Master; and the other one is; “Slave”
PLANET Ethernet over VDSL series 16 Therefore, most of the traffic will be limited on the local phone line network instead of flooding to the Internet. Another application for the converter is used for LAN to LAN extension through the normal telephone line. 3.2 LAN to LAN connection Two sets of the ...
Page 17 - Installing Network Cables
EV-401M / EV-401S User's Manual 17 Water or moisture can not enter the unit Air flow around the unit and through the vents in the side of the case is not restricted (company recommend that you provide a minimum of 25mm inch clearance) To prolong the operational life of your units: Do not place objec...
Page 21 - TROUBLE SHOOTING; SYMPTOM
EV-401M / EV-401S User's Manual 21 5. TROUBLE SHOOTING SYMPTOM: VDSL link LED not lit after wire is connected to the VDSL port. CHECKPOINT: 1: Verify the length of the wire connected between EV-401M and EV-401S is not more than 1.5km. 2: Please note you must use 1 EV-401M and 1 EV-401S connect to ea...