Philips TAR3306/12 User Manual — Free PDF Download

Page 2 - Contents

Connect power 1 EN Contents 1 Important 2 SafetyNotice 22 2 Your clock radio 3 Introduction 3 What's in the box 3 Overview of the clock radio 3 3 Get started 4 Install batteries 44 Set time 4 4 Listen to FM radio 5 Tune to FM radio stations Select a preset radio station 5 Store FM radio stations aut...

Page 3 - Important; Safety; Notice

2 EN 1 Important Safety • Read these instructions. • Heed all warnings. • Follow all instructions. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus...

Page 4 - Your clock radio; Introduction; Overview of the clock radio

3 EN 2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support thatPhilips offers, register your product at www.philips.com/support. Introduction With this clock radio, you can • • listen to FM radio What's in the box Check and identify the conten...

Page 5 - Get started; Install batteries

4 EN Caution • Risk of product damage! Make sure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. • Risk of electrical shock! When you unplug the power cord, always pull the plug from the socket. Never pullthe cord. Note • 3 Get started Always fo...

Page 6 - Listen to FM radio

5 EN 4 Listen to FM radio Note • Keep the clock radio away from other electronic devices to avoid radio interference. • For better reception, fully extend and adjust the position of the FM antenna. Tune to FM radio stations 1 Press to turn on the clock radio. 2 Press and hold TUN for 2 seconds. The ...

Page 7 - Other features; Set alarm time; Set sleep timer; Adjust display brightness

6 EN 5 Other features Set alarm time Set alarm Note • You can only set the alarm in standby mode. • Make sure that you have set the clock correctly. 1 In standby mode, press and hold AL1 or AL2 for 2 seconds to set alarm time. 2 Press HR to set hour and MIN to set to confirm. minute, then press AL1 ...

Page 8 - Troubleshooting

7 EN 6 Product information Note • Product information is subject to change without prior notice. Rated Output Power 400mW RMS Tuner (FM) Amplifier Tuning Range 87.5-108 MHz Tuning Grid 50 KHz Sensitivity- Mono, 26 dB S/N Ratio <22 dBf Total Harmonic Distortion <3% Signal to Noise Ratio >50 ...