Paxar electro-sealer - Manual

Page 3 - Contents

Contents Warranty Information 1 Limited Warranty ........................................................................................................ 1 Parts ............................................................................................................................. 1 Service .....

Page 5 - Warranty Information; Limited Warranty

Warranty Information Limited Warranty PAXAR Systems Group, Division of PAXAR Corporation, extends the following warranties to the original purchaser of a PAXAR Electro-Sealer which has been installed and operated using recommended procedures and operating conditions. Parts Parts found defective in m...

Page 6 - Warning

Safety Instructions Warning When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. Failure to follow these instructions can result in severe personal injury. READ ALL INSTRUCTIONS CAREFULLY! The importance of usi...

Page 9 - General Description

General Description Main Switch This turns the machine on and off. Hold Switch This switch locks out the timer; the head will come down but the timer will not work. The head stays down as long as the foot pedal is depressed. THIS IS A MAINTENANCE FUNCTION used when changing electrodes to insure that...

Page 11 - Operation

Operation To put your Electro-Sealer into operation, turn on the main switch. Set the plate and electrode heat controls to the desired temperature. Turn on the vacuum pump by using the switch located on the power cord for the pump. Turn on the auto switch. This will cause the vacuum arm to pull a la...

Page 12 - Regular Maintenance

7112 Series Flock Feed Regular Maintenance 1. Remove accumulated moisture form the air filter by opening the bleed valve located at the base of the filter bowl. 2. To check the sealing area for an out of parallel condition: with the heat on, set the timer for one (1) second or less; place a light co...

Page 13 - Trouble Shooting

Trouble Shooting Symptoms Probable Cause Corrective Action Timer does not move but press operates Hold Switch turned on. Defective timer. Hold Switch should be turned off. Replace timer. No heat / no movements Bad fuse. No power. Check and / or replace fuse. Check power to its source. Timer moves / ...

Page 15 - Sealing Problems

Sealing Problems Symptoms Probable Cause Corrective Action Uneven sealing of label. Machine out of level; plates not parallel. Check and Adjust Hitting a seam or button with electrode. Relocate the label or use smallest electrode possible. Uneven thickness in label. Cardboard in garment. Use silicon...

Page 16 - Part Identification Numbers

Part Identification Numbers FIND NUMBER PART NUMBER DESCRIPTION QTY 1 200060 CONTROL HEAT ATHENA 1810 2 2 200074 CORD LINE 15 AMP 1 3 200093 FUSE HOLDER 30 AMP 1 4 200110 FUSE 10 AMP 1 5 200178 HEATER 3 INCH 2 6 200182 HEATER 4 INCH 2 7 200375 SOCKET RELAY 4 8 200394 RELAY TIME DELAY / CPDO 2 9 2004...

Page 19 - Recommended On-hand Spare Parts

Recommended On-hand Spare Parts PART NUMBER DESCRIPTION QTY 200060 CONTROL HEAT ATHENA 1810 2 200178 HEATER 3" 300 WATTS 5 200182 HEATER 4" 300 WATTS 5 200394 RELAY TIME DELAY / DPDT 2 200407 REALY (5X827) 3 200638 SWITCH LIMIT / VACUUM / SENSING 5 200765 THERMOCOUPLE, T/C PROBE 5 205152 TIM...

Paxar electro-sealer - Manual

Table of Contents:

Summary

Other Paxar Models