Panamax M4315-PRO - User Manual
Panamax M4315-PRO Surge Protector – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Introduction; Table of Contents; Box should contain the following, including the Quick Start Guide:; Before You Begin Inspect Upon Receipt.; Four silicone rubber feet for shelf mounting.
- Page 3 – Features Descriptions
- Page 4 – Important Safety Instructions
- Page 5 – Preset Profile Information
- Page 6 – The Bubble of Protection; Rear Panel Features Overview; steel retention clip.; TV
- Page 7 – Log into; Troubleshooting; MAC ADDRESS; CHALLENGE KEY; BlueBOLT; Advanced Operation; automation systems within the local network.
- Page 8 – Identify Connected Equipment; PLEASE NOTE; that the outlets start at No. 8; LAN TEL; FRONT
- Page 9 – MESSAGE CONSTRUCTS; RS-232 and Telnet Command Set / Protocol Specifications; Command Set/Status Messaging
- Page 10 – CONTROLLER COMMANDS
- Page 11 – RESET FACTORY SETTINGS
- Page 13 – Responses and Warning Messages
- Page 14 – FCC Notice; Reorient or relocate the receiving antenna.; Contacting Customer Service; AC Power; A shielded-type power cord is required in order to meet FCC
Important:
You will need the BlueBOLT-CV1’s unique MAC address and challenge key (provided on the 2 labels
attached to the cover of the Quick Start Guide which is included in the M4315-PRO packaging). One label is
permanently adhered to the Quick Start Guide and the other is removable for your convenience.
1 2 3 4 5 6
7 8
UNSAFE VOLTAGE
BREAKER
WIRING FAULT
TEMPERATURE
15 A
BRIGHTNESS
OUTLET STATUS
REBOOT 1 REBOOT 2
M4315-PRO
B LT
Blue
™
ENABLED
VOLTS
Power Management with Control System Interactive Functionality.
• 15 Amp Capacity M4315-PRO
• 8 Individually Controllable Rear Panel Outlets
• Fully Programmable
• TCP/IP (BlueBOLT™) Installed
• RS-232 Card (Included, not installed)
• Linear Filtration with 3 Isolated LiFT Filter Banks, 76db (5 kHz - 250 kHz), 46 db (250 kHz - 1 MHz)
• One Isolated Filter Bank for High Current Devices, 60db (5 kHz - 450 kHz), 46 db (450 kHz - 1 MHz)
• Front Panel Circuit Breaker
• Integrated Front Rack Ears
• 12 Volt Input Triggering
• Detachable 10 ft. Power Cord
• AVM & Protect-or-Disconnect Circuitry
M4315-PRO Instructions
INS00859 REV. D 5/10
B LT
Blue
™
ENABLED
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Thank you for purchasing a Panamax M4315-PRO Power Management with control system interactive functionality, and congratulations on your choice. The M4315-PRO features Panamax’s revolutionary AVM (Automatic Voltage Monitoring) circuit, and our exclusive Linear Filtering Technology (LiFT). To-gether,...
Features Descriptions 1 BlueBOLT ™: Remote Power Management technology provides secure, hosted IP (Internet Protocol) system control. With BlueBOLT™, custom electronics installers, integrators and end-users can remotely monitor and control power to home theater equipment by accessing power managemen...
2 PLEASE NOTE: The lights’ status is obvious, when the outlet is just plain “ ON ” or just plain “ OFF ”. However, there are transition states that cause the lights to blink. The lights will blink when performing a triggered cycle, but when a server initiated cycle command occurs, it just goes “ OFF...
