Outback Power Systems 250VAC - Manual

Outback Power Systems 250VAC

Outback Power Systems 250VAC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
Page: / 4

Table of Contents:

  • Page 2 – WIRING INSTRUCTIONS; DIN Rail
  • Page 3 – If a load exceeds 8 amps, use both screw terminals for any; OIL
  • Page 4 – European Sales Office
Loading the manual

FLEXware16 Amp Maximum 30VDC/250VAC
Rated Relay and DIN Mount Base with LED

The FLEXware Relay Assembly will activate a two-wire start generator

when wired to the AUX output of either an OutBack FX Inverter/Charger

or an OutBack Charge Controller. The assembly consists of an LED

module and a relay inserted (in one orientation) into a base. The base is

mounted onto the DIN rail of any OutBack AC industrial control panel.

Relay Features:

Rated current - 16 amps AC/DC 8 amps per terminal

Rated voltage - 30VDC/250VAC

Coil power draw - 400 mW

Gold contacts for use in low power situations

A green LED lights to show the relay energizing when proper

voltage is applied to the relay coil connectors.

Base accommodates connections for wiring the coil, common relay

contacts, normally open relay contacts, and normally closed relay
contacts.

LED

RELAY

BASE

FRONT VIEW

SIDE VIEW

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - WIRING INSTRUCTIONS; DIN Rail

WIRING INSTRUCTIONS Wire the relay coil from the AUX positive and negative connections of your OutBack product according to the diagram. The coil connections (A1 and A2) are not polarity sensitive and the LED will light in either polarity as long as proper voltage is present. (Required voltage is no...

Page 3 - If a load exceeds 8 amps, use both screw terminals for any; OIL

There are two screw terminals for each relay contact. Each can handle up to 8 amps. They are tied together internally. COM 11 and COM 21 are the common relay connections. Either can be used for loads under 8 amps. If the load exceeds 8 amps, use both COM 11 and COM 21. r NO 14 and NO 24 are normally...

Page 4 - European Sales Office

European Sales Office C/ Castelló, 17 08830 - Sant Boi de Llobregat BARCELONA, España Phone: +34.93.654.9568 Corporate Office19009 62nd Avenue NEArlington, WA USA(+1) 360-435-6030 900-0018-01-00 REV A www.outbackpower.com

Other Outback Power Systems Models

All Outback Power Systems Other