Onkyo DS-A27 - Manual - manualsarea.com

Page 2 - Important Safety Instructions

2 Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s ins...

Page 3 - Precautions; Recording Copyright; For Canadian Models; Disconnect

3 Precautions 1. Recording Copyright —Unless it’s for personal use only, recording copyrighted material is ille-gal without the permission of the copyright holder. 2. Care —Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak so...

Page 4 - Getting Started; About the RI Dock; Interactive Dock

4 Getting Started With the Onkyo RI Dock, you can easily play the music stored on your Apple * iPod * through your Onkyo audio system and enjoy great sound, and watch iPod slideshows and videos on your T V. In addition, the onscreen display (OSD) allows you to view, navigate, and select your iPod’s ...

Page 5 - —Continued; Adjusting the iPod Adapter; Getting to Know the RI Dock

5 Getting Started —Continued ■ Adjusting the iPod Adapter The iPod adapter needs to be adjusted to match your particular iPod. Insert your iPod into the RI Dock. If there’s a gap between the back of your iPod and the adapter, turn the adapter counterclock-wise to close the gap. Turning the adapter c...

Page 6 - Sets the OSD mode to On or Off.; Remote Controller

6 Getting Started —Continued A SETUP button Used to set the T V system (PAL/NTSC) and the remote controller’s ID. B MODE button Sets the OSD mode to On or Off. C MENU button Used to select the previous menu on the onscreen display and iPod. D Play/Pause [ / ] button Starts or pauses playback of the ...

Page 7 - Replacing the Battery; Slide the cover shut.; Aiming the Remote Controller; Replacing the battery incorrectly; Remote control sensor

7 Getting Started —Continued Replacing the Battery Use only a battery of the same type (CR 2025). 1. To open the battery compartment, press the small hollow and slide open the cover. 2. While pressing the tab as shown, slide out the old battery. Slide the new battery into the battery com-partment wi...

Page 8 - Hooking Up the RI Dock; AC adapter; TV; Supplied AV cable

8 Getting Started —Continued Depending on the Onkyo amp that you’re using, choose connection method A or B . A : Connect the RI Dock’s AUDIO OUT L/R jacks and VIDEO OUT jack to an RI Dock-compati-ble input on your Onkyo amp. ( You might need to change the input display to “HDD” or “DOCK.”) B : Conne...

Page 9 - Using the RI Dock; Plug in the AC adapter.; On; : Nothing is displayed on your T V and; Playing Songs; Use the Up and Down arrow [; Setting the OSD Mode; Remove your; Controlling Your iPod without the OSD; Top Menu

9 Using the RI Dock Set the OSD (onscreen display) mode before you start using the RI Dock. 1. Plug in the AC adapter. 2. Turn on your T V and amp, and select the appropriate inputs on your T V and amp. 3. Insert your iPod into the RI Dock. 4. Use the remote controller’s [MODE] button to set the OSD...

Page 10 - Using the Page Modes; Repeat modes

10 Using the RI Dock —Continued ■ Using the Page Modes With the page modes, you can quickly locate your favorite songs even when your song lists, artist lists, and so on are very long. There are four page modes: L , M , S , and P . These stand for Large, Medium, Small, and Page. In P mode, you can p...

Page 11 - TV Display Settings

11 Using the RI Dock —Continued When the OSD mode is set to On, you can change the background color and set the screen saver. 1. Press the [MENU] button repeatedly to select the top menu. 2. Use the Up and Down arrow [ ]/[ ] but- tons to select “Settings,” and then press the [SELECT ] button. 3. Use...

Page 12 - Using Your iPod’s Alarm Clock; cable and an audio; Setting the Remote Controller’s ID

12 Using the RI Dock —Continued ■ Using Your iPod’s Alarm Clock You can use your iPod’s Alarm Clock function to automatically turn on your iPod and amp at a speciﬁed time. Your amp’s input source will automatically be set to the input to which your iPod is connected. ■ Charging Your iPod’s Battery T...

Page 13 - The following functions can be used with some Onkyo amps.; * Depending on your amp, some buttons may not work as expected.; Using Your Amp’s Remote Controller

13 Using the RI Dock —Continued The following table shows which buttons on your amp’s remote controller you can use to control your iPod while it’s in the RI Dock. Be sure to select the appropriate remote mode ﬁrst, and point your remote controller at your amp. Note that some buttons may be labelled...

Page 14 - Troubleshooting; There’s no sound; If you use this product under

14 Troubleshooting ■ There’s no sound • Make sure your iPod is actually playing.• Make sure your iPod is inserted properly in the RI Dock. • Make sure the RI Dock is connected to the correct input jacks on your amp. Do not connect it to any output jacks. • Make sure your amp is turned on, the correc...

Page 15 - Specifications; • The operating instructions in this manual apply

15 Specifications Power supply: AC adapter (5 V DC) Power consumption(iPod not inserted): 0.5 W Weight: 0.51 lbs. (230 g) Dimensions ( W x H x D): 4-7/16 x 2-3/8 x 4-7/16 inches 112 x 60 x 112 mm Connectors: VIDEO OUT, AUDIO OUT L/R, jack Speciﬁcations and features are subject to change without noti...

Page 16 - Printed in Japan

16 SN 29344526 Printed in Japan I0705-1 (C) Copyright 2007 ONKYO CORPORATION Japan. All rights reserved. http://www.onkyo.com/ HOMEPAGE Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPANTel: 072-831-8023 Fax: 072-831-8124 ONKYO U.S.A. CORPORATION 18 Park Way, U...

Onkyo DS-A27 - Manual

Table of Contents:

Summary

Other Onkyo Models