Oliveri ST-BL1520 - User Manual

CUTTING THE BENCHTOP

GENERAL INFORMATION

GRANITE SINK INSTALLATION INSTRUCTIONS

Please retain for consumer as care instructions are included

SEALANT
Oliveri recommends using the sealant strip (supplied with the sink), to seal between the sink and the bench
top. However, if silicone is used, it MUST be a “Neutral Cure” product – the use of “Acetic Cure” silicone
can damage or discolour the sink and will void warranty.

WASTE DISPOSAL UNITS
Waste disposal units can be fitted to Oliveri’s Granite Sinks. However, faulty or damaged waste disposal
units can cause vibration, which may lead to sink damage and will void warranty.

BASKET WASTE INSTALLATION
1 Fit the basket waste into the hole in the sink and then place the drain under the hole.
DO NOT USE SILICONE ADHESIVE.
2. Fasten the basket waste to the drain using a screw. Do not overtighten.

DRILLING THE TAP HOLE
Oliveri granite sinks with drainboards are provided with a pre-punched hole (picture A) placed on the front
and back of the sink in order to choose which side the bowls / drainer will sit. NOTE!
In order to avoid any possible damage to the sink, we strictly recommend to drill these pre-punched holes
using 35-37mm drill following the procedure shown in pictures B and C. We recommend using a diamond
coated drill to drill this hole.

Fig. A - Pre-punched tap holes

Fig. B - Place the tool on the
pre-punched hole.

Fig. C - Drill the hole.

CHECK SPACE

Ensure there is adequate space for tapware (including a splashback if
specified). Check space for installation (underneath) and operation (above).
Particular care must be taken when a thick splash back is used (it may
interfere with tapware location and operation). Ensure the cabinet will not
foul the sink mounting flange or basins.

TEMPLATE

Cut out templates for your Oliveri sink are available online at oliveri.com.au.
Use the product model number to find the template. Some sink templates
apply to both left-hand and right-hand model sinks. Ensure template is
correct way around for your model.

MARK CUT OUT

Carefully mark out the template (or follow drawing instructions) making
allowance for any additional polishing back that is required after cutting.

Note: The template is the exact finished cut-out size required.

CUT & FINISH HOLE

Drill pilot holes to accept an appropriate cutting tool for the benchtop
material (wear suitable personal protection equipment). Cut inside the mark,
allowing sufficient room for any polishing back.

Note: Accuracy is essential to ensure the bowl / basin and accessories
fit correctly.

TRIAL FIT THE SINK

Carefully position the sink against benchtop to make sure it fits the cut out
correctly. If the fit is not correct, remove the sink and proceed with remedial
work. Perform another trial fit after corrections have been made.

IT IS HIGHLY RECOMMENDED THE ACTUAL SINK BE PRESENT AT TIME OF CUTTING

Any advice, recommendation, information, assistance or service provided by Tasman Sinkware in relation to goods

manufactured by it or their use and installation, is given in good faith and is believed by Tasman Sinkware to be

appropriate and reliable. However, any advice, recommendation, information, assistance or service is provided by

Tasman Sinkware without responsibility or liability.

Download cut out files (PDF, DWG or DXF) from oliveri.com.au

CHECK MODEL

The model number on the sink
packaging must match the model
of sink the customer ordered.
Do not install if incorrect.

AVOID CUTS

The perimeter and punch-outs on
the sink may contain sharp edges.
Handle the sink carefully to avoid
personal injury.

CHECK THE CONDITION

Inspect the sink for any visible
defects. Do not install the sink if
defects are found. Contact your
sink retailer / point of purchase.

AVOID BREAKAGES

Granite sinks can be broken if
proper care is not taken during
installation.

© Tasman Sinkware -

TF158c

Granite Sink Installation Instructions