Oliveri ST-BL1510 - User Manual

DO NOT USE SILICONE

OLIVERI DOES NOT RECOMMEND THE USE OF A WASTE

DISPOSAL UNIT WITH GRANITE SINKS.

CUTTING THE COUNTER / BENCHTOP

GRANITE SINK INSTALLATION INSTRUCTIONS

Please retain for consumer as care instructions are included

DO NOT USE SILICONE

BASKET WASTE INSTALLATION
1 Fit the basket waste into the hole in the sink and then place the drain under the
hole. DO NOT USE SILICONE ADHESIVE.

2. Fasten the basket waste to the drain using a screw. Do not overtighten.

DRILLING THE TAP HOLE
3. Oliveri granite sinks with drainboards are provided with a pre-punched hole (picture
A) placed on the front and back of the sink in order to choose which side the bowls
/ drainer will sit. NOTE!
In order to avoid any possible damage to the sink, we strictly recommend to drill these
pre-punched holes using 35-37mm drill following the procedure shown in pictures B
and C. We recommend using a diamond coated drill to drill this hole.

Fig. A - Pre-punched tap holes

Fig. B - Place the tool on the
pre-punched hole.

Fig. C - Drill the hole.

CHECK SPACE

Ensure there is adequate space for tapware (including a splashback

if specified). Check space for installation (underneath) and operation

(above). Particular care must be taken when a thick splash back is used

(it may interfere with tapware location and operation). Ensure the cabinet

will not foul the sink mounting flange or basins.

TEMPLATE *

Cut out templates for your Oliveri sink are available online at oliverisinks.

com. Use the product model number to find the template. Some sink

templates apply to both left-hand and right-hand model sinks. Ensure

template is correct way around for your model.

MARK CUT OUT *

Carefully mark out the template (or follow drawing instructions) making

allowance for any additional polishing back that is required after cutting.

NOTE: THE TEMPLATE IS THE EXACT FINISHED CUT-OUT SIZE

REQUIRED.

CUT & FINISH HOLE *

Drill pilot holes to accept an appropriate cutting tool for the counter/

benchtop material (wear suitable personal protection equipment). Cut

inside the mark, allowing sufficient room for any polishing back.

Note: Accuracy is essential to ensure the bowl / basin and

accessories fit correctly.

TRIAL FIT THE SINK

Carefully position the sink against counter/benchtop to make sure it fits

the cut-out correctly. If the fit is not correct, remove the sink and proceed

with remedial work. Perform another trial fit after corrections have been

made.

IT IS HIGHLY RECOMMENDED THE ACTUAL SINK BE PRESENT AT TIME OF CUTTING

Any advice, recommendation, information, assistance or service provided

by Tasman Sinkware in relation to goods manufactured by it or their use

and installation, is given in good faith and is believed by Tasman Sinkware

to be appropriate and reliable. However, any advice, recommendation, in-

formation, assistance or service is provided by Tasman Sinkware without

responsibility or liability.

CHECK MODEL

The model number on the sink

packaging must match the model

of sink the customer ordered.

Do not install if incorrect.

AVOID CUTS

The perimeter and punch-outs on

the sink may contain sharp edges.

Handle the sink carefully to avoid

personal injury.

CHECK THE CONDITION

Inspect the sink for any visible

defects.

Do not install the sink if

defects are found.

Contact your

sink retailer / point of purchase.

AVOID BREAKAGES

Granite sinks can be broken if

proper care is not taken during

installation.

Download cutout

template files

(PDF, DWG & DXF)

from our website.

© Tasman Sinkware -

V(b)

Granite Sink Installation Instructions