Oki 8810n - Manual

Oki 8810n

Oki 8810n – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
Page: / 44

Table of Contents:

  • Page 2 – Printer Components; Front View; Set Up the Printer; Open the cover using the grips on either side.
  • Page 3 – Note; Install the Power Cord; The printhead lifts, moves to the left, then moves
  • Page 5 – Always turn the ribbon knob; turning it; counter; cause the ribbon to jam.; clockwise
  • Page 6 – Push the display panel back to its original; If the cover does not close easily,; do not; . The right end of the ribbon; Install the Stacker; With the flat edge toward the printer and the frosted; Remove the Protective Film; Peel the protective plastic film off the viewing area on
  • Page 7 – Run a Self Test; RELEASE SW; Load Paper; Paper Specifications,; Minimum Print Margins; Individual Multi-Part Forms; • Size
  • Page 8 – Load Individual Sheets/Forms; The sheet loads in to the print position,; Set the Printer for Continuous Forms; FRONT; MANUAL; Continuous Forms Specifications; • Width; Optional; Rear Feed
  • Page 9 – Load Continuous Forms; are engaged on each tractor. If not, the paper
  • Page 10 – Tearing Off Printed Continuous Forms; The continuous forms move forward onto the; Removing Continuous Forms; The forms move back to the tractors.; Connect to the Computer; Do not connect both the USB and parallel; USB Port
  • Page 11 – Parallel Port; To Connect the Ethernet Port
  • Page 12 – Guide d’installation; MICROLINE; Sommaire de l'installation
  • Page 13 – Composants de l'imprimante; Vue frontale; Installez l'imprimante; Ouvrez le capot en saisissant les poignées de
  • Page 14 – Remarque; Installation du cordon d’alimentation; La tête d’impression se soulève, se déplace vers; avant
  • Page 17 – Installation du Empileuse
  • Page 18 – Effectuer un autodiagnostic; Chargement du papier; Spécifications des supports; utiliser avec le mode Auto Align; Marges d’impression minimum; Format
  • Page 19 – La feuille s’alimente en position d’impression et; Configurez l'imprimante pour du papier en; Spécifications; Largeur
  • Page 20 – Chargement du papier en continu; engagés sur chaque tracteur. Sinon, le papier
  • Page 21 – Dépose des formulaires en continu; Les formulaires font marche arrière sur les; Connexion à l'ordinateur; Ne branchez pas les ports USB et parallèles; Port USB
  • Page 22 – Port parallèle; Pour brancher le port Ethernet
  • Page 23 – OKI; Resumen de instalación
  • Page 24 – Componentes de la impresora; Vista de frente; Configurar la impresora; Abra la tapa utilizando los asideros en ambos
  • Page 25 – Nota; Instale el cable de alimentación de; El cabezal de impresión se levanta, se mueve
  • Page 27 – Siempre gire la perilla de la cinta en sentido
  • Page 28 – Instale el Apilador
  • Page 29 – Hacer prueba de autoverificación; La impresora alimenta la hoja. Se imprime la; Cargue papel; Especificaciones del papel, para; Márgenes mínimos de impresión; Formularios multipartes individuales; • Tamaño
  • Page 30 – Cargar hojas individuales/Formularios; La hoja se carga en posición para imprimir, y es; Formularios continuos (“FRONT; Configurar la impresora para imprimir; Especificaciones
  • Page 31 – Cargue papel continuo; están utilizados en ambas orugas. De lo con-
  • Page 32 – Cómo desprender las hojas continuas; Las formas continuas avanzan hacia el apilador.; Cómo retirar las hojas continuas; Conexión a la computadora; No conecte el puerto USB y el puerto; Puerto USB
  • Page 33 – Puerto paralelo; Ouerto de red (Solamente el Modelo; Para conectar el puerto Ethernet
  • Page 34 – Se faltar algum dos itens, contacte imediatamente o; Requisitos de espaço; Coloque a impressora em uma superfície firme e; Requisitos Ambientais; Guia de Configuração; • Livreto de Informações Normativas e de Segurança; Resumo da instalação
  • Page 35 – Componentes da impressora; Vista frontal; Configurar a impressora; Abra a tampa usando os pegadores situados nos
  • Page 36 – Conecte o cabo de alimentação; A cabeça de impressão se elevará, se deslocará
  • Page 39 – Instale o empilhador
  • Page 40 – Execute um autodiagnóstico; A folha será alimentada pela impressora. O; Colocação do papelr; Margens mínimas de impressão; Formulários multivias individuais; • Tamanho
  • Page 41 – Colocação de folhas avulsas/Formulários; A folha avançará para a posição de impressão,; Configure a impressora para formulários; A impressora mudará o percurso e voltará a ficar; Especificações
  • Page 42 – Colocação de formulários contínuos; cios do papel esteja encaixado em cada tracio-
  • Page 43 – Os formulários contínuos avançarão na direção do; Remoção de formulários contínuos; Os formulários retrocederão para os; Conexão ao computador; Não conecte as portas USB e paralela ao; Porta USB
  • Page 44 – Porta paralela; Para conectar a porta Ethernet
Loading the manual

English

English . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
French [Français] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Spanish [Español]. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Brazilian Portuguese [Português] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34

Step 1:

Unpack

Check the Contents

If any items are missing, contact your dealer

immediately.

1

Printer

2

Stacker

3

Power Cable

4

Ribbon Cartridge

Not illustrated: Documentation

Space Requirements

Place the printer on a stable, level surface.
Check that sufficient space is available for the

installation:
• Width: 35.4" (90 cm)
• Depth

– Behind printer: 23.6" (60 cm)
– In front of printer: 12.6" (32 cm)
– Overall: 60.2" (153 cm)

• Height: 18" (46 cm) minimum

Environmental Requirements

• Operating Temperature: 41 to 104°F (5 to 40°C)
• Humidity: 30 to 85% RH

Documentation

Your printer includes the following documentation:
• This

Setup Guide

How to get the printer up and running.

•

Safety and Regulatory Information

booklet

Important safety information, along with general

regulatory information (FCC, Energy Star, IC, etc.)
and the Material Safety Data Sheet for the ribbon.

OKI

®

MICROLINE

®

8810/8810n

Setup Guide

Installation Summary

Unpack . . . . . . . . . . . . . . . . . . . . . . . . . 1
Set Up the Printer . . . . . . . . . . . . . . . . 2
Run a Self Test . . . . . . . . . . . . . . . . . . . 7
Load Paper . . . . . . . . . . . . . . . . . . . . . . 7
Connect to the Computer . . . . . . . . . . 10

Components Feb 17

06.jpg

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Printer Components; Front View; Set Up the Printer; Open the cover using the grips on either side.

2 Printer Components Front View 1 Ribbon Cartridge 7 Platen Knob 2 Sheet Guide 8 Power Switch 3 Sheet Platform 9 Display Panel 4 Sheet Supports 10 Stacker 5 Printhead 11 Cover 6 Control Panel Rear View 1 Stacker 3 Parallel Port 2 Power Socket 4 USB Port Step 2: Set Up the Printer Remove the Printhea...

Page 3 - Note; Install the Power Cord; The printhead lifts, moves to the left, then moves

3 4. Remove the shipping restraint ( 1 ). Note Save the shipping restraint and packing materials in case you ever need to ship the printer. 5. Push the display panel back to its original position. 6. Close the cover. Install the Power Cord 7. Make sure the printer power switch is in the OFF position...

Page 5 - Always turn the ribbon knob; turning it; counter; cause the ribbon to jam.; clockwise

5 8. Observe the black pin ( 1 ) over which the ribbon knob fits, and the guides ( 2 )—one at either end— into which the ribbon arms fit. 9. Feed the ribbon arms ( 1 ) in beside the guides ( 2 ), position the take-up knob ( 3 ) over the pin, then press the cartridge in firmly at either end. 10. Pull...

Other Oki Models

All Oki Other